DOI QR코드

DOI QR Code

Accuracy Analysis of GNSS-derived Orthometric Height in Mountainous Areas

  • Lee, Jisun (Dept. of Geoinformatics, University of Seoul) ;
  • Kwon, Jay Hyoun (Dept. of Geoinformatics, University of Seoul) ;
  • Lee, Hungkyu (Dept. of Civil Engineering, Changwon National University) ;
  • Park, Jong Soo (Dept. of Geoinformatics, University of Seoul)
  • Received : 2018.10.08
  • Accepted : 2018.10.25
  • Published : 2018.10.31

Abstract

Recently, GNSS (Global Navigation Satellite System)-derived orthometric height determination has been studied to improve the time and cost-effectiveness of traditional leveling surveying. However, the accuracy of this new survey method was evaluated when unknown points are located lower than control points. In this study, the accuracy of GNSS-derived orthometric height was examined using TPs (Triangulation Points) to verify the stability of surveying in mountainous areas. The GNSS survey data were obtained from Mungyeong, Unbong/Hadong, Uljin, and Jangseong. Three unknown points were surrounded by more than three UCPs (Unified Control Points) or BMs (Benchmarks) following the guideline for applying GNSS-derived orthometric height determination. A newly developed national geoid model, KNGeoid17 (Korean National Geoid 2017), has been applied for determining the orthometric height. In comparison with the official orthometric heights of the TPs, the heights of the unknown points in Mungyeong and Unbong/Hadong differ by more than 20 cm. On the other hand, TPs in Uljin and Jangseong show 15-16 cm of local bias with respect to the official products. Since the precision of official orthometric heights of TPs is known to be about 10 cm, these errors exceed the limit of the precision. Therefore, the official products should be checked to offer more reliable results to surveyors. As an alternative method of verifying accuracy, three different GNSS post-processing software were applied, and the results from each software were compared. The results showed that the differences in the whole test areas did not exceed 5 cm. Therefore, it was concluded that the precision of the GNSS-derived orthometric height was less than 5 cm, even though the unknown points were higher than the control points.

Keywords

References

  1. GSI (2017), GNSS leveling surveying guideline, GSI , https://psgsv2.gsi.go.jp/koukyou/public/ssp/gazou/GNSS_hyoukou_manual.pdf (last accessed: 27 September 2018)
  2. ICSM (2014), Guideline for control surveys by GNSS (version 2.1), ICSM , https://www.icsm.gov.au/sites/default/file/2018-02/Guideline-for-Control-Surveys-by-GNSS_v2.1.pdf (last accessed: 27 September 2018).
  3. Jung, S.C., Lee, J., and Kwon, J.H. (2017a), Accuracy analysis of GNSS-derived orthometric heght in the mountainous area, 2018 Conference of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography, 19-20 April, Yongin, Korea, pp. 81-84.
  4. Jung, S.C., Lee, J., and Kwon, J.H. (2017b), Accuracy analysis of GNSS-derived orthometric heights on the leveling loop disconnected area, Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography, Vol. 36, No. 1, pp. 1-8. https://doi.org/10.7848/KSGPC.2018.36.1.1
  5. Lee, H.K. (2018), Impact of tropospheric modeling schemes into accuracy of estimated ellipsoidal heights by GPS baseline processing : experimental analysis and results, Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography, Vol. 36, No. 4, pp. 245-254. (in Korean with English abstract) https://doi.org/10.7848/KSGPC.2018.36.4.245
  6. Lee, S.B., Lee, K.S., and Lee, M.K. (2017), Analysis of the feasibility of GNSS/geoid technology in determining orthometric height in mountain, Journal of the Korean Society for Geospatial Information Science , Vol. 25, No. 2, pp. 57-65. (in Korean with English abstract)
  7. Lee, Y., Han, J.H., and Kwon, J.H. (2015), Accuracy improvement of real-time GNSS based heighting using published orthometric height of unified control point, 2015 Conference of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography, 23-24 April, Changwon, Korea, pp. 345-346
  8. NGII (2014a), Development of Korean National Geoid Model (Part 1), 11-1613436-000039-01, NGII, Suwon, pp. 9-43.
  9. NGII (2014b), Development of Korean National Geoid Model (Part 2) : Appendix 3. Guideline for GNSS-derived Orthometric Height Determination (ver. 1.0), 11-1613436-000039-01, NGII, Suwon, pp. 145-167.
  10. NGII (2017a), Strategy to Establish Leveling Network based on Unified Control Points (Part 2), 11-1613436-000136-01, NGII, Suwon, pp. 73-99.
  11. NGII (2017b), Strategy to Establish Leveling Network based on Unified Control Points (Part 2) : Appendix 2. Guideline for GNSS-derived Orthometric Height Determination (ver. 1.1), 11-1613436-000136-01, NGII, Suwon, pp. 35-60.
  12. NGII (2018), Upgrade of Korean National Geoid and Korean Vertical Datum Transformation Model, 11-1613436-000166-01, NGII, Suwon, pp. 11-68
  13. NGS (1997), Guideline for establishing GPS-derived ellipsoid heights (NGS-58, version 4.3), NGS, https://www.ngs.noaa.gov/PUBS_LIB/NGS-58.html (last accessed: 27 September 2018).
  14. Park, J.K. and Jung, J.Y. (2014), Accuracy evaluation of orthometric heights from GNSS measured heights using KNGeod13 model, 2014 Conference of The Korean Society for GeoSpatial Information System, 15-16 May, Jeju, Korea, pp. 87-88.
  15. Shin, G.S., Han, J.H., and Kwon, J.H. (2014), Accuracy analysis of orthometric heights based on GNSS static surveying, Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography, Vol. 32, No. 5, pp. 527-537. (in Korean with English abstract) https://doi.org/10.7848/ksgpc.2014.32.5.527

Cited by

  1. Analyzing Precision and Efficiency of Global Navigation Satellite System-Derived Height Determination for Coastal and Island Areas vol.11, pp.11, 2021, https://doi.org/10.3390/app11115310