Journal of the Korean Society of Mechanical Technology (한국기계기술학회지)

Korean Society of Mechanical Technology (한국기계기술학회)
권호 표지
DOI QR코드

DOI QR Code

The Effect of Torque Variation on the Stress Distribution Characteristics in A-IMS Module with both Side Tubular Shaft Yoke

양형 튜블러 샤프트 요크 적용 가변 슬라이딩 중간축 모듈의 토크 변경에 따른 응력 분포 특성

  • Yeom, Jin Seop (Division of Mechanical & Automotive Engineering, Kongju National University) ;
  • Suh, Hyun Kyu (Division of Mechanical & Automotive Engineering, Kongju National University)
  • Received : 2018.09.18
  • Accepted : 2018.10.22
  • Published : 2018.12.28
⟨ Previous Next ⟩

Abstract

The objective of this study is to investigate the effect of torque variation on stress distributions in A-IMS module with both side tubular shaft yoke by numerically. In order to achieve this, the torque value was increased from 10Nm to 40Nm, and the results of this work were confirmed in terms of Von-mises Stress and the displacement characteristics. As the torque in module assembly was increased, the stress in tubular shaft york and splined shaft york was increased linearly. The indentation due to the steel ball was occurred in over $40N{\cdot}m$ torque which is over the yield strength condition. The largest displacement occurred in the tubular shaft yoke 1, however, it does not exceed the yield strength and is supposed to be restored due to the elasticity. Therefore, it was concluded that there is no problem for the manufacturing of A-IMS with both side tubular shaft yoke.

Keywords

Acknowledgement

Supported by : 충남지역사업평가단

References

  1. K. H. Choi et al., "Finite Element Analysis and Shape Design for Coated Intermediate Shaft of Steering System," Conference of KSAE, pp. 1284-1288, 2009
  2. H. G. Lee and Y. B. Park, "Process Reduction Design of Cold Forging for Cost-Saving of Asymmetric Pinch Yoke at Automobile Steering System," Journal of KSMT, Vol. 16, No. 2, pp. 1365-1370, 2014
  3. S. H. Min and H. K. Suh, "Optimal Design of the A-IMS Core Components for Commercial Vehicle by the Effect of Upper Die Type," Journal of KSMT, Vol. 18, No. 2, pp. 294-300, 2016
  4. J. S. Yeom and H. K. Suh, "The Effect of Shaft Hole Length on the A-IMS Tubular Shaft Machining," Journal of KSMT, Vol. 20, No. 1, pp. 96-101, 2018
  5. S. H. Kim, "Press Die design Engineering," Dae Kwang Seo rim, p. 15, 2010
  6. S. M. Lee, "Press Die design," Gi Jeon Yeon Gu Sa, p. 15, 2012
  7. S. C. Choi and B. M. Kim, "Expert system for cold forging process design," Journal of KSTP, Vol. 2, No. 2, pp. 1-7, 1993