DOI QR코드

DOI QR Code

Shear lag effects on wide U-section pre-stressed concrete light rail bridges

  • Boules, Philopateer F. (Department of Structural Engineering, Faculty of Engineering, Cairo University) ;
  • Mehanny, Sameh S.F. (Department of Structural Engineering, Faculty of Engineering, Cairo University) ;
  • Bakhoum, Mourad M. (Department of Structural Engineering, Faculty of Engineering, Cairo University)
  • 투고 : 2018.01.14
  • 심사 : 2018.07.16
  • 발행 : 2018.10.10

초록

Recently, U-section decks have been more and more used in metro and light rail bridges as an innovative concept in bridge deck design and a successful alternative to conventional box girders because of their potential advantages. U-section may be viewed as a single vent box girder eliminating the top slab connecting the webs, with the moving vehicles travelling on the lower deck. U-section bridges thus solve many problems like limited vertical clearance underneath the bridge lowest point, besides providing built-in noise barriers. Beam theory in mechanics assumes that plane section remains plane after bending, but it was found that shearing forces produce shear deformations and the plane section does not remain plane. This phenomenon leads to distortion of the cross section. For a box or a U section, this distortion makes the central part of the slab lagging behind those parts closer to the webs and this is known as shear lag effect. A sample real-world double-track U-section metro bridge is modelled in this paper using a commercial finite element analysis program and is analysed under various loading conditions and for different geometric variations. The three-dimensional finite element analysis is used to demonstrate variations in the transverse bending moments in the deck as well as variations in the longitudinal normal stresses induced in the cross section along the U-girder's span thus capturing warping and shear lag effects which are then compared to the stresses calculated using conventional beam theory. This comparison is performed not only to locate the distortion, warping and shear lag effects typically induced in U-section bridges but also to assess the main parameters influencing them the most.

키워드

참고문헌

  1. Ayoub, E, Mehanny, S., Malek, C. and Helmy, G. (2017), "Dynamic response assessment in compliance with the Eurocodes for the elevated viaducts of the Doha Metro Green Line", Struct. Concrete, 18(3), 397-408. https://doi.org/10.1002/suco.201600072
  2. Bakhoum, M. (2010), Structural Mechanics, Arab Republic of Egypt, 2nd edition, 257-295, 303-330, 342-377.
  3. Bakhoum, M.M. and Shehata, E. (1995), "Box girder bridges: Modeling with FBM, influence lines, live load stresses considering bending, shear, torsion, distortion, and warping", Proceedings of the Hong Kong Institution of Engineers.
  4. Bazant, Z.P., Yu, Q. and Li, G.H. (2012a), "Excessive long-time deflections of prestressed box girders. I: Record-span bridge in palau and other paradigms", ASCE J. Struct. Eng., 138(6), 676-686. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000487
  5. Bazant, Z.P., Yu, Q. and Li, G.H. (2012b), "Excessive long-time deflections of prestressed box girders. II: Numerical analysis and lessons learned", ASCE J. Struct. Eng., 138(6), 687-696.
  6. Boules, P.F. (2017), "Investigating shear lag effects on wide U-section pre-stressed concrete light rail bridges", M.Sc. Dissertation, Cairo University, Egypt.
  7. Chang, S.T. (2004), "Shear lag effect in simply supported prestressed concrete box girder", ASCE J. Brid. Eng., 9(2), 178-184. https://doi.org/10.1061/(ASCE)1084-0702(2004)9:2(178)
  8. Dezi, L., Gara, F. and Leoni, G. (2003), "Shear-lag effect in twin-girder composite decks", Steel Compos. Struct., 3(2), 111-122. https://doi.org/10.12989/scs.2003.3.2.111
  9. Gibbens, B., Selby Smith, P. and Joynson, G. (2004), "Design-Construction of Sorell causeway channel bridge, Hobart, Tasmania", PCI J., 49, 56-66.
  10. Hu, H. and Wang, Y.H. (2015), "Theoretical analysis of simply supported channel girder bridges", Struct. Eng. Mech., 56(2), 241-256. https://doi.org/10.12989/sem.2015.56.2.241
  11. Mazinani, I., Jumaat, M.Z., Ismail Z. and Chao, O.Z. (2014), "Comparison of shear lag in structural steel building with framed tube and braced tube", Struct. Eng. Mech., 49(3), 297-309. https://doi.org/10.12989/sem.2014.49.3.297
  12. Murray, N.W. (1986). Introduction to the Theory of Thin-Walled Structures, Clarendon Press, Oxford.
  13. Raju, V. and Menon, D. (2011), "Analysis of behavior of U-girder bridge decks", ACEE Int. J. Tran. Urban Devel., 1(1), 34-38.
  14. Raju, V. and Menon, D. (2013), "Longitudinal analysis of concrete U-girder bridge decks", Proceedings of the ICE-Bridge Engineering, 167(2), 99-110.
  15. SAP2000 NL CSI Reference Manual (2000), Computers and Structures. Inc. University Avenue. Suite 540. Berkeley, California, U.S.A.
  16. Shehata, E. (1994) "Box girder bridges: An investigation into the analysis considering bending, torsion, distortion, shear lag", M.Sc. Dissertation, Cairo University, Egypt.
  17. Shepherd, B. and Gibbens, B. (2004), "The evolution of the concrete 'channel' bridge system and its application to road and rail bridges", Proceedings of the Fib Concrete Structures, Avignon, France, April.
  18. Staquet, S., Rigot, G., Detandt, H. and Espion, B. (2004), "Innovative composite precast pre-stressed pre-cambered U-shaped concrete deck for Belgium's high speed railway trains", PCI J., 49(6), 94-113. https://doi.org/10.15554/pcij.11012004.94.113
  19. Timoshenko, S. and Gere, J.M. (2009), Theory of Elastic Stability, Mineola, N.Y., Dover Publications.
  20. Timoshenko, S. and Goodier, J.N. (1969), Theory of Elasticity, McGraw-Hill, New York, U.S.A.
  21. Vlasov, V.Z. (1961), Thin-Walled Elastic Beams, 2nd Edition, Israel Program for Scientific Translations, Jerusalem, Israel.
  22. Yamaguchi, E., Chaisomphob, T., Sa-nguanmanasak, J. and Lertsima, C. (2008), "Stress concentration and deflection of simply supported box girder including shear lag effect", Struct. Eng. Mech., 28(2), 207-220. https://doi.org/10.12989/sem.2008.28.2.207
  23. Zhang, Y.H. (2012), "Improved finite-segment method for analyzing shear lag effect in thin-walled box girders", ASCE J. Struct. Eng., 138(10).
  24. Zhou, S.J. (2011), "Shear lag analysis in prestressed concrete box girders", ASCE J. Brid. Eng., 16(4).
  25. Zhou, Y. (2014) "Analysis of the shear lag effect of cantilever box girder", Eng. Rev., 34(3), 197-207.