DOI QR코드

DOI QR Code

Enhanced Startup Diagnostics of LCL Filter for an Active Front-End Converter

  • Agrawal, Neeraj (Department of Electrical Engineering, Indian Institute of Science) ;
  • John, Vinod (Department of Electrical Engineering, Indian Institute of Science)
  • Received : 2018.03.14
  • Accepted : 2018.06.17
  • Published : 2018.09.20

Abstract

The reliability of grid-connected inverters can be improved by algorithms capable of diagnosing faults in LCL filters. A fault diagnostic method during inverter startup is proposed. The proposed method can accurately generate and monitor information on the peak value and the location of the peak frequency component of the step response of a damped LCL filter. To identify faults, the proposed method compares the evaluated response with the response of a healthy higher-order damped LCL filter. The frequency components in the filter voltage response are first analytically obtained in closed form, which yields the expected trends for the filter faults. In the converter controller, the frequency components in the filter voltage response are computed using an appropriately designed fast Fourier transform and compared with healthy LCL response parameters using a finite state machine, which is used to sequence the proposed startup diagnostics. The performance of the proposed method is validated by comparing analytical results with the simulation and experimental results for a three-phase grid-connected inverter with a damped LCL filter.

Keywords

References

  1. E. J. Bueno, F. Espinosa, F. J. Rodriguez, J. Urefia, and S. Cobreces, "Current control of voltage source converters connected to the grid through an LCL-filter," in 35th Ann. IEEE Power Electron. Conf., Vol. 1, pp. 68-73, 2004.
  2. IEEE application guide for ieee std 1547(tm), ieee standard for interconnecting distributed resources with electric power systems, IEEE Std 1547.2-2008, pp. 1-217, April 2009.
  3. K. Jalili and S. Bernet, “Design of LCL filters of active-front-end two-level voltage-source converters,” IEEE Trans. Ind. Electron., Vol. 56, No. 5, pp. 1674-1689, May 2009. https://doi.org/10.1109/TIE.2008.2011251
  4. A. Babel, A. Muetze, R. Seebacher, K. Krischan, and E. Strangas, "Condition monitoring and failure prognosis of igbt inverters based on on-line characterization," in IEEE Energy Conversion Congress and Exposition (ECCE), pp. 3059-3066, 2014.
  5. B. Ji, X. Song, W. Cao, V. Pickert, Y. Hu, J. Mackersie, and G. Pierce, “In situ diagnostics and prognostics of solder fatigue in igbt modules for electric vehicle drives,” IEEE Trans. Power Electron., Vol. 30, No. 3, pp. 1535-1543, Mar. 2015. https://doi.org/10.1109/TPEL.2014.2318991
  6. K. Debaprasad and B. Bose, "Investigation of fault modes of voltage-fed inverter system for induction motor drive," IEEE Trans. Ind. Appl., Vol. 30, No. 4 pp. 1028-1038, Jul./Aug. 1994. https://doi.org/10.1109/28.297920
  7. K. Rothenhagen and W. Fuchs, "Performance of diagnosis methods for igbt open circuit faults in three phase voltage source active rectifiers," in 35th Ann. IEEE Power Electron Conf., Vol. 6, pp. 4348-4354, 2004.
  8. S. Yang, A. Bryant, P. Mawby, D. Xiang, L. Ran, and P. Tavner, “An industry-based survey of reliability in power electronic converters,” IEEE Trans. Ind. Appl., Vol. 47, No. 3, pp. 1441-1451, May 2011. https://doi.org/10.1109/TIA.2011.2124436
  9. R. de Araujo Ribeiro, C. Jacobina, E. Cabral da Silva, and A. Lima, “Fault detection of open-switch damage in voltage-fed pwm motor drive systems,” IEEE Trans. Power Electron., Vol. 18, No. 2, pp. 587-593, Mar. 2003.
  10. B. Lu and K. S. Sharma, "A literature review of igbt fault diagnostic and protection methods for power inverters," IEEE Trans. Ind. Appl., Vol. 45, No. 5, pp. 1770-1777, Sep.-Oct. 2009. https://doi.org/10.1109/TIA.2009.2027535
  11. B. Gonzalez-Contreras, J. Rullan-Lara, L. Vela-Valdes, and A. Clau-dio S., "Modelling, simulation and fault diagnosis of the three-phase inverter using bond graph," in IEEE Ind. Electron Int. Symp., pp. 130-135, 2007.
  12. F. Huang and F. Flett, "IGBT fault protection based on di/dt feedback control," in IEEE Power Electron. Specialists Conf., pp. 1478-1484, 2007.
  13. P. Gilreath and B. Singh, "A new centroid based fault detection method for 3-phase inverter-fed induction motors," in 36th IEEE Power Electron. Specialists Conf., pp. 2664-2669, 2005.
  14. C. Kral and K. Kafka, "Power electronics monitoring for a controlled voltage source inverter drive with induction machines," in 31st Annu. IEEE Power Electron. Specialists Conf., Vol. 1, pp. 213-217, 2000.
  15. M. Awadallah and M. Morcos, "Diagnosis of switch open-circuit fault in pm brushless dc motor drives," in Large Engineering Systems Conf. on Power Engineering, pp. 69-73, 2003.
  16. M. Rodriguez, A. Claudio, D. Theilliol, and L. Vela, "A new fault detection technique for igbt based on gate voltage monitoring," in IEEE Power Electron. Specialists Conf., pp. 1001-1005, 2007.
  17. R. Pagano, Y. Chen, K. Smedley, S. Musumeci, and A. Raciti, "Short circuit analysis and protection of power module IGBTs," in 20th Annu. IEEE Appl. Power Electron. Conf. and Exposition, Vol. 2, pp. 777-783, 2005.
  18. R. Pagano and A. Raciti, "Evolution in IGBT's protection against short circuit behaviors by gate-side circuitry," in IEEE Ind. Electron. Int. Sym., Vol. 3, pp. 913-918, 2002.
  19. A. Bhall, S. Shekhawat, J. Gladish, and G. Dolny, "IGBT behavior during desat detection and short circuit fault protection," in Power Semicond. Devices & ICs, 1998. Kyoto. Proc. of the 1998 Int. Symp., pp. 245-248, 1998.
  20. M. Liserre, F. Blaabjerg, and S. Hansen, "Design and control of an lcl-filter-based three-phase active rectifier," IEEE Trans. Ind. Appl., Vol. 41, No. 5, pp. 1281-1291, Sep.-Oct., 2005. https://doi.org/10.1109/TIA.2005.853373
  21. T. Paulraj, S. Hari Kishan, and S. Dhana, "Modeling and location of faults in power transformer using transfer function and frequency response analysis," in Advanced Communication Control and Computing Technologies (ICACCCT), International Conf., pp. 83-87, 2014.
  22. M. Bigdeli, M. Vakilian, E. Rahimpour, and D. Azizian, "Transformer winding diagnosis using comparison of transfer function coefficients," in 8th Electrical Engineering/Electronics, Computer, Telecommunications and Information Technology (ECTI-CON), International Conf., pp. 681-683, 2011.
  23. J. Bak-Jensen, B. Bak-Jensen, and S. Mikkelsen, “Detection of fualts and aging phenomena in transformers by transfer functions,” IEEE Trans. Power Del., Vol. 10, No. 1, pp. 308-314, Jan. 1995. https://doi.org/10.1109/61.368384
  24. S. Chandar and S. K. Panda, “Degradation detection and diagnosis of inductors in lcl filter integrated with active front end rectifier,” IEEE Trans. Power Electron., Vol. 33, No. 2, pp. 1622-1632, Feb. 2018. https://doi.org/10.1109/TPEL.2017.2685421
  25. E. Rahimpour, J. Christian, and K. Feser, “Transfer function method to diagnose axial displacement and radial deformation of transformer windings,” IEEE Trans. Power Del., Vol. 18, No. 2, pp. 493 -505, Apr. 2003. https://doi.org/10.1109/TPWRD.2003.809692
  26. T. Leibfried and K. Feser, "Monitoring of power transformers using the transfer function method," IEEE Trans. Power Del., Vol. 14, No. 4 pp. 1333-1341, Oct. 1999. https://doi.org/10.1109/61.796226
  27. I. M.K. and V. M., “Transformer fault detection by frequency response analysis,” IOSR J. Electr. Electron. Eng., Vol. 1, No. 4, pp. 27-32, Jul.-Aug. 2012. https://doi.org/10.9790/1676-0142732
  28. K. Ragavan and L. Satish, “An efficient method to compute transfer function of a transformer from its equivalent circuit,” IEEE Trans. Power Del., Vol. 20, No. 2, pp. 780-788, Apr. 2005. https://doi.org/10.1109/TPWRD.2004.834345
  29. J. Christian and K. Feser, “Procedures for detecting winding displacements in power transformers by the transfer function method,” IEEE Trans. Power Del., Vol. 19, No. 1, pp. 214-220, Jan. 2004.
  30. N. Agrawal and V. John, "Lcl filter startup diagnostics for an active front end converter," in Power Electronics, Drives and Energy Systems IEEE International Conf., pp. 1-6, 2016.
  31. R. Beres, X. Wang, F. Blaabjerg, C. Bak, and M. Liserre, "Comparative evaluation of passive damping topologies for parallel grid-connected converters with lcl filters," in Power Electronics International Conf., pp. 3320-3327, 2014.
  32. C. Chen, Z. Wang, Y. Zhang, G. Li, and Y. Wu, "A novel passive damping lcl-filter for active power filter," in Transportation Electrification Asia-Pacific (ITEC Asia-Pacific), IEEE Conf. and Expo, pp. 1-5, 2014.
  33. T. C. Wang, Z. Ye, G. Sinha, and X. Yuan, "Output filter design for a grid-interconnected three phase inverter," in 34th Ann. Power Electron. Specialists, IEEE conf., Vol. 2, pp. 779-784, 2003.
  34. E. O. Brigham, The Fast Fourier Transform and Its Applications. Prentice-Hall, 1988.