DOI QR코드

DOI QR Code

Influence of fin partitioning of a Rayeigh-Bénard cavity at low Rayleigh numbers

  • Zilic, Adis (Department of Mechanical Engineering, University of Vermont) ;
  • Hitt, Darren L. (Department of Mechanical Engineering, University of Vermont)
  • Received : 2017.07.22
  • Accepted : 2018.01.15
  • Published : 2018.07.25

Abstract

This computational study examines the augmentation of classic 2-D Rayleigh-$B{\acute{e}}nard$ convection by the addition of periodically-spaced transverse fins. The fins are attached to the heated base of the cavity and serve to partition the cavity into 'units' with different aspect ratios. The respective impacts upon heat transfer of the fin configuration parameters - including spacing, height, thickness and thermal conductivity - are systematically examined through numerical simulations for a range of laminar Rayleigh numbers (0 < Ra < $2{\times}10^5$) and reported in terms of an average Nusselt number. The selection of the low Rayleigh number regime is linked to likely scenarios within aerospace applications (e.g. avionics cooling) where the cavity length scale and/or gravitational acceleration is small. The net heat transfer augmentation is found to result from a combination of competing fin effects, most of which are hydrodynamic in nature. Heat transfer enhancement of up to $1.2{\times}$ that for a Rayleigh-$B{\acute{e}}nard$ cavity without fins was found to occur under favorable fin configurations. Such configurations are generally characterized by short, thin fins with half-spacings somewhat less than the convection cell diameter from classic Rayleigh-$B{\acute{e}}nard$ theory. In contrast, for unfavorable configurations, it is found that the introduction of fins can result in a significant reduction in the heat transfer performance.

Keywords

Acknowledgement

Supported by : National Aeronautics and Space Administration under NASA

References

  1. Ahmadi, M., Mostafavi, G. and Bahrami, M. (2014), "Natural convection from rectangular interrupted fins", J. Therm. Sci., 82, 62-71. https://doi.org/10.1016/j.ijthermalsci.2014.03.016
  2. Amraqui, S., Mezrhab, A. and Abid, C. (2011), "Combined natural convection and surface radiation in solar collector equipped with partitions", Appl. Solar Energy, 47(1), 36-47. https://doi.org/10.3103/S0003701X11010051
  3. Arquis, E. and Rady, M. (2005), "Study of natural convection heat transfer in a finned horizontal fluid layer", J. Therm. Sci., 44(1), 43-52. https://doi.org/10.1016/j.ijthermalsci.2004.04.011
  4. Beldar, K. and Patil, A. (2017), "Fabrication and CFD analysis of cylindrical heat sink having longitudinal fins with rectangular notches", Res. J. Eng. Technol., 4(6), 678-684.
  5. Bergles, A.E. (1999), "Techniques to enhance heat transfer", Handbook of Heat Transfer, McGraw-Hill, New York, U.S.A.
  6. Catton, I. (1978), "Natural convection in enclosures", Proceedings of the 6th International Heat Transfer Conference, Toronto, Canada, August.
  7. Hanin, L. and Campo, A. (2003), "A new minimum volume straight cooling fin taking into account the length of arc", J. Heat Mass Transfer, 46(26), 5145-5152. https://doi.org/10.1016/S0017-9310(03)00355-7
  8. Hollands, K.G.T., Unny, T.E., Raithby, G.D. and Konicek, L. (1976), "Free convective heat transfer across inclined air layers", J. Heat Transfer, 98(2), 189-193. https://doi.org/10.1115/1.3450517
  9. Hoogendoorn, C.J. (1986), "Natural convection in enclosures", Proceedings of the 8th International Heat Transfer Conference, San Francisco, U.S.A., August.
  10. Inada, S., Taguchi, T. and Yang, W.J. (1999), "Effects of vertical fins on local heat transfer performance in a horizontal fluid layer", J. Heat Mass Transfer, 42(15), 2897-2903. https://doi.org/10.1016/S0017-9310(98)00357-3
  11. Jaluria, Y. (2003), "Natural convection", Heat Transfer Handbook, John Wiley and Sons, New Jersey, U.S.A.
  12. Kanashima, Y., Nishino, K. and Yoda, S. (2005), "Effect of g-jitter on the thermocapillary convection experiment in the ISS", Microgravity Sci. Technol., 16(1), 285-289. https://doi.org/10.1007/BF02945992
  13. Lin, N.N. and Bejan, A. (1983), "Natural convection in a partially divided enclosure", J. Heat Mass Transfer, 26(12), 1867-1878. https://doi.org/10.1016/S0017-9310(83)80157-4
  14. Manglik, R.M. (2003), "Heat transfer enhancement", Heat Transfer Handbook, John Wiley and Sons, New Jersey, U.S.A.
  15. Manneville, P. (2006), "Rayleigh-Benard convection: Thirty years of experimental, theoretical and modeling work", Dynamics of Spatio-Temporal Cellular Structures, Springer, New York, U.S.A.
  16. Naumann, R.J. (2000), "An analytical model for transport from quasi-steady and periodic accelerations on spacecraft", J. Heat Mass Transfer, 43(16), 2917-2930. https://doi.org/10.1016/S0017-9310(99)00340-3
  17. Nelson, E.S. (1994), "An examination of anticipated g-jitter on space station and its effects on materials processes", NASA-TM-103775, E-6042, NAS 1.15:103775; NASA Lewis Research Center, Cleveland, U.S.A.
  18. Ostrach, S. (1972), "Natural convection in enclosures", Adv. Heat Transfer, 8(1), 161-227.
  19. Papari, M.M., Hitt, D.L. and Campo, A. (2005), "Dual influence of temperature and gas composition of selected helium-based binary gas mixtures on the thermal convection enhancement in Rayleigh-Benard enclosures", J. Heat Mass Transfer, 48(23), 5081-5088. https://doi.org/10.1016/j.ijheatmasstransfer.2005.06.010
  20. Qarnia, H.E., Draoui, A. and Lakhal, E.K. (2013), "Computation of melting with natural convection inside a rectangular enclosure heated by discrete protruding heat sources", Appl. Math. Model., 37(6), 3968-3981. https://doi.org/10.1016/j.apm.2012.08.021
  21. Rayman, M.D., Fraschetti, T.C., Raymond, C.A. and Russell, C.T. (2006), "Dawn: A mission in development for exploration of main belt asteroids Vesta and Ceres", Acta Astronautica, 58(11), 605-616. https://doi.org/10.1016/j.actaastro.2006.01.014
  22. Schmidt, E. (1926), Die Warmeubertragung durch Rippen, Germany.
  23. Singh, K.K. and Sinha, M.K. (2016), "Parametric effects on a heat sink with branched fins under natural convection", J. Sci. Eng. Res., 7(6), 229-236.
  24. Sivaprakasam, V. Basha, J.K., Udhayarasu, R. and Siva, D. (2015), "Experimental investigation on the performance of longitudinal fins with different notches using mixed convection heat transfer", J. Res. Aeronaut. Mech. Eng., 3(6), 12-20.

Cited by

  1. Fatigue damage identification for composite pipeline systems using electrical capacitance sensors vol.27, pp.8, 2018, https://doi.org/10.1088/1361-665X/aacc99