DOI QR코드

DOI QR Code

Seismic behavior of steel tube reinforced concrete bridge columns

  • Tian, Tian (School of Civil Engineering, Dalian University of Technology) ;
  • Qiu, Wen-liang (School of Civil Engineering, Dalian University of Technology) ;
  • Zhang, Zhe (School of Civil Engineering, Dalian University of Technology)
  • 투고 : 2017.08.31
  • 심사 : 2018.04.17
  • 발행 : 2018.07.10

초록

This paper reports an experimental study that was accomplished to assess the seismic behavior of steel tube reinforced concrete bridge columns (SBCs). The motivation of this study was to verify a supposition that the core steel tube may be terminated at a rational position in the column to minimize the material cost while maintaining the seismic behavior of this composite column. Four SBC specimens were tested under combined constant axial load and cyclic reversed lateral loads. The unique variable in the test matrix was the core steel tube embedment length, which ranged from 1/3 to 3/3 of the column effective height. It is observed that SBCs showed two distinctly different failure patterns, namely brittle shear failure and ductile flexural failure. Tests results indicate that the hysteretic responses of SBCs were susceptible to the core steel tube embedment length. With the increase of this structural parameter, the lateral strength of SBC was progressively improved; the deformability and ductility, however, exhibited a tendency of first increase and then decrease. It is also found that in addition to maintained the rate of stiffness degradation and cumulative energy dissipation basically unchanged, both the ductility and deformability of SBC were significantly improved when the core steel tube was terminated at the mid-height of the column, and these were the most unexpected benefits accompanied with material cost reduction.

키워드

과제정보

연구 과제 주관 기관 : National Natural Science Foundation of China

참고문헌

  1. An, Y.F., Han, L.H. and Roeder, C. (2014), "Flexural performance of concrete-encased concrete-filled steel tubes", Mag. Concrete Res., 66(5), 249-267. https://doi.org/10.1680/macr.13.00268
  2. China, C.P. (2008), JTG/T B02-01-2008: Guidelines for seismic design of highway bridges; China Communications Press, Beijing, China. [In Chinese]
  3. Choi, E., Chung, Y.S., Park, J. and Cho, B.S. (2010), "Behavior of reinforced concrete columns confined by new steel-jacketing method", ACI Struct. J., 107(6), 654-662.
  4. Choi, E., Chung, Y.S., Park, C. and Kim, D.J. (2013), "Seismic performance of circular RC columns retrofitted with prefabricated steel wrapping jackets", Mag. Concrete Res., 65(23), 1429-1440. https://doi.org/10.1680/macr.13.00177
  5. Guo, Q.Q., Zhao, Y.X., Li, Q. and Shang, K. (2013), "Experimental study on eccentric compressive property of steel tube-reinforced concrete columns", J. Build Struct., 34(12), 103-111. [In Chinese]
  6. Han, L.H. and An, Y.F. (2014), "Performance of concrete-encased CFST short columns under axial compression", J. Constr. Steel Res., 93(1), 62-76. https://doi.org/10.1016/j.jcsr.2013.10.019
  7. Hashimoto, S., Fujino, Y. and Abe, M. (2005), "Damage analysis of Hanshin expressway viaducts during 1995 Kobe Earthquake. II: damage mode of single reinforced concrete Piers", J. Bridge Eng., 10(1), 54-60. https://doi.org/10.1061/(ASCE)1084-0702(2005)10:1(54)
  8. Hsu, Y.T. and Fu, C.C. (2004), "Seismic effect on highway bridges in Chi Chi Earthquake", J. Perform. Constr. Fac., 18(1), 47-53. https://doi.org/10.1061/(ASCE)0887-3828(2004)18:1(47)
  9. Ibrahim, A.M.A., Wu, Z.S., Fahmy, M.F.M. and Kamal, D. (2016), "Experimental study on cyclic response of concrete bridge columns reinforced by steel and basalt FRP reinforcements", J. Compos. Constr., 20(3), 04015062. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000614
  10. Ji, X.D., Kang, H.Z., Chen, X.C. and Qian, J.R. (2014), "Seismic behavior and strength capacity of steel tube-reinforced concrete composite columns", Earthq. Eng. Struct. Dyn., 43(4), 487-505. https://doi.org/10.1002/eqe.2354
  11. Kwak, J.H., Kwak, H.G. and Kim, J.K. (2013), "Behavior of circular CFT columns subject to axial force and bending moment", Steel Compos. Struct., Int. J., 14(2), 173-190. https://doi.org/10.12989/scs.2013.14.2.173
  12. Lu, X.L., Xue, J.Y., Yin, X.W. and Jiang, H.J. (2014), "Experimental study on hysteretic properties of SRC columns with high steel ratio", Steel Compos. Struct., Int. J., 17(3), 287-303. https://doi.org/10.12989/scs.2014.17.3.287
  13. Nie, J.G., Bai, Y., Li, S.Y., Zhao, J. and Xiao, Y. (2005), "Analyses on composite column with inside concrete filled steel tube under axial compression", China Civil Eng. J., 38(9), 9-13.
  14. [In Chinese] Paultre, P., Eid, R., Robles, H.I. and Bouaanani, N. (2009), "Seismic performance of circular high-strength concrete columns", ACI Struct. J., 106(4), 395-404.
  15. Qiu, W.L., Jiang, M., Pan, S.S. and Zhang, Z. (2013), "Seismic responses of composite bridge piers with CFT columns embedded inside", Steel Compos. Struct., Int. J., 15(3), 343-355. https://doi.org/10.12989/scs.2013.15.3.343
  16. Qiu, W.L., Kao, C.S., Kou, C.H. and Tasi, J.L. (2015), "Experimental study of seismic performances of RC bridge columns with CFST column embedded inside", J. Mar. Sci. Tech., 23(2), 212-219.
  17. Saiidi, M.S. and Tazarv, M. (2016), "Low-damage precast columns for accelerated bridge construction in high seismic zones", J. Bridge Eng., 21(3), 04015056. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000806
  18. Shim, C.S., Chung, Y.S. and Yoon, J.Y. (2011), "Cyclic behavior of prefabricated circular composite columns with low steel ratio", Eng. Struct., 33(9), 2525-2534. https://doi.org/10.1016/j.engstruct.2011.04.024
  19. Wu, K., Xue, J.Y. and Zhao, H.T. (2013), "Failure mechanism and bearing capacity of transfer columns in SRC-RC hybrid structures", Eur. J. Environ. Civil Eng., 17(S1), 205-228. https://doi.org/10.1080/19648189.2013.834595
  20. Wu, K., Xue, J.Y., Nan, Y. and Zhao, H.T. (2016), "Experimental research on seismic behavior of SRC-RC transfer columns", Steel Compos. Struct., Int. J., 21(1), 157-175. https://doi.org/10.12989/scs.2016.21.1.157