DOI QR코드

DOI QR Code

Mechanical behavior of FRP confined steel tubular columns under impact

  • Liu, Qiangqiang (College of Civil Engineering, Nanjing Tech University) ;
  • Zhou, Ding (College of Civil Engineering, Nanjing Tech University) ;
  • Wang, Jun (College of Civil Engineering, Nanjing Tech University) ;
  • Liu, Weiqing (College of Civil Engineering, Nanjing Tech University)
  • Received : 2016.12.09
  • Accepted : 2018.04.21
  • Published : 2018.06.25

Abstract

This paper presents experimental and analytical results of fiber reinforced polymer (FRP) confined steel tubular columns under transverse impact loads. Influences of applied impact energy, thickness of FRP jacket and impact position were discussed in detail, and then the impact responses of FRP confined steel tubes were compared with bare steel tubes. The test results revealed that the FRP jacket contributes to prevent outward buckling deformation of steel at the clamped end and inward buckling of steel at the impact position. For the given applied impact energy, specimens wrapped with one layer and three layers of FRP have the lower peak impact loads than those of the bare steel tubes, whereas specimens wrapped with five layers of FRP exhibit the higher peak impact loads. All the FRP confined steel tubular specimens displayed a longer duration time than the bare steel tubes under the same magnitude of impact energy, and the specimen wrapped with one layer of FRP had the longest duration time. In addition, increasing the applied impact energy leads to the increase of peak impact load and duration time, whereas increasing the distance of impact position from the clamped end results in the decrease of peak impact load and the increase of duration time. The dynamic analysis software Abaqus Explicit was used to simulate the mechanical behavior of FRP confined steel tubular columns, and the numerical results agreed well with the test data. Analytical solution for lateral displacement of an equivalent cantilever beam model subjected to impact load was derived out. Comparison of analytical and experimental results shows that the maximum displacement can be precisely predicted by the present theoretical model.

Keywords

Acknowledgement

Supported by : National Natural Science Foundation of China

References

  1. Alam, M.I. and Fawzia, S. (2015), "Numerical studies on CFRP strengthened steel columns under transverse impact", Compos. Struct., 120, 428-441. https://doi.org/10.1016/j.compstruct.2014.10.022
  2. Alper, E. and Daniel, J.I. (2011), Piezoelectric Energy Harvesting, Appendix C: Modal Analysis of a Uniform Cantilever With a Tip Mass, John Wiley & Sons, New York, NY, USA, pp. 353-356.
  3. ASTM D3039/D3039M (2014), Standard test method for tensile properties of polymer matrixcomposite materials, USA.
  4. Bhetwal, K.K. and Yamada, S. (2012), "Effects of CFRP-reinforcements on the buckling behavior of thin-walled steel cylinders under compression", Int. J. Struct. Stab. Dy., 12(1), 131-151. https://doi.org/10.1142/S0219455412004665
  5. Chen, C.H., Zhu, X., Hou, H., Zhang, L., Shen, X. and Tang, T. (2014), "An experimental study on the ballistic performance of FRP-steel plates completely penetrated by a hemisphericalnosed projectile", Steel Compos. Struct., Int. J., 16(3), 269-288. https://doi.org/10.12989/scs.2014.16.3.269
  6. Chen, C., Zhao, Y. and Li, J. (2015), "Experimental investigation on the impact performance of concrete-filled FRP steel tubes", J. Eng. Mech.-ASCE, 141(2), 197-201.
  7. Cheng, X., Al-Mansour, A.M. and Li, Z. (2009), "Residual strength of stitched laminates after low velocity impact", J. Reinf. Plast. Compos., 28(14), 1679-1688. https://doi.org/10.1177/0731684408090368
  8. Fang, H., Liu, W., Zhuang, Y. and Zhu, L. (2014), Analysis and Design of Floating Composite Anti-collision Bumper System for Large Bridge, Research and application of composite materials in Infrastructure, China Architecture & Building Press, pp. 40-47.
  9. Fawzia, S., Al-Mahaidi, R., Zhao, X.L. and Rizkalla, S. (2007), "Strengthening of circular hollow steel tubular sections using high modulus of CFRP sheets", Constr. Build. Mater., 21(4), 839-845. https://doi.org/10.1016/j.conbuildmat.2006.06.014
  10. Feng, P., Cheng, S., Bai, Y. and Ye, L. (2015), "Mechanical behavior of concrete-filled square steel tube with FRP-confined concrete core subjected to axial compression", Compos. Struct., 123, 312-324. https://doi.org/10.1016/j.compstruct.2014.12.053
  11. Haedir, J. and Zhao, X.L. (2011), "Design of short CFRP-reinforced steel tubular columns", J. Constr. Steel Res., 67(3), 497-509. https://doi.org/10.1016/j.jcsr.2010.09.005
  12. Haedir, J. and Zhao, X.L. (2012), "Design of CFRP-strengthened steel CHS tubular beams", J. Constr. Steel Res., 72(4), 203-218. https://doi.org/10.1016/j.jcsr.2011.12.004
  13. Haedir, J., Zhao, X.L., Grzebieta, R.H. and Bambach, M.R. (2011), "Non-linear analysis to predict the moment-curvature response of CFRP-strengthened steel CHS tubular beams", Thin-Wall. Struct., 49(8), 997-1006. https://doi.org/10.1016/j.tws.2011.03.004
  14. Han, H., Taheri, F. and Pegg, N. (2011), "Crushing behaviors and energy absorption efficiency of hybrid pultruded and ${\pm}45^{\circ}$ braided tubes", Mech. Adv. Mater. Struct., 18(4), 287-300. https://doi.org/10.1080/15376494.2010.506103
  15. Hashin, Z. (1980), "Failure criteria for undirectional fiber composites", J. Appl. Mech., 47(2), 329-334. https://doi.org/10.1115/1.3153664
  16. Huang, L., Sun, X., Yan, L. and Kasal, B. (2017), "Impact behavior of concrete columns confined by both GFRP tube and steel spiral reinforcement", Constr. Build. Mater., 131, 438-448. https://doi.org/10.1016/j.conbuildmat.2016.11.095
  17. Jiang, H. and Chorzepa, M.G. (2015), "Evaluation of a new FRP fender system for bridge pier protection against vessel collision", J. Bridge Eng., 20(2), 05014010. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000658
  18. JTG/T D81 (2006), Guidelines for design of highway safety facilities, China.
  19. Lesani, M., Bahaari, M. and Shokrieh, M. (2013), "Numerical investigation of FRP-strengthened tubular T-joints under axial compressive loads", Compos. Struct., 100, 71-78. https://doi.org/10.1016/j.compstruct.2012.12.020
  20. Liang, R., Skidmore, M. and Ganga Rao, H.V.S. (2014), "Rehabilitation of east lynn lake bridge steel pile bents with composites", TRB Innovative Technologies for a Resilient Marine Transportation System 3Rd Biennial Research and Development Conference, Washington, DC, USA, June.
  21. Ozbakkaloglu, T. and Fanggi, B.L. (2014), "Axial compressive behavior of FRP-concrete-steel double-skin tubular columns made of normal- and high-strength concrete", J. Compos. Constr., 18(1), 04013027. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000401
  22. Park, J.W. and Yoo, J.H. (2015), "Flexural and compression behavior for steel structures strengthened with Carbon Fiber Reinforced Polymers (CFRPs) sheet", Steel Compos. Struct., Int. J., 19(2), 441-465. https://doi.org/10.12989/scs.2015.19.2.441
  23. Parvin, A. and Brighton, D. (2014), "FRP composites strengthening of concrete columns under various loading conditions", Polymers, 6(4), 1040-1056. https://doi.org/10.3390/polym6041040
  24. Saeed, M.S., Majid, B., Hossein, G. and Masood, F. (2016), "Retrofitting of steel pile-abutment connections of integral bridges using CFRP", Struct. Eng. Mech., Int. J., 59(2), 209-226. https://doi.org/10.12989/sem.2016.59.2.209
  25. Samaaneh, M.A., Sharif, A.M., Baluch, M.H. and Azad, A.K. (2016), "Numerical investigation of continuous composite girders strengthened with CFRP", Steel Compos. Struct., Int. J., 21(6), 1307-1326. https://doi.org/10.12989/scs.2016.21.6.1307
  26. Shaat, A. and Fam, A. (2007), "Finite element analysis of slender HSS columns strengthened with high modulus composites", Steel Compos. Struct., Int. J., 7(1), 19-34. https://doi.org/10.12989/scs.2007.7.1.019
  27. Su, L., Li, X. and Wang, Y. (2016), "Experimental study and modeling of CFRP-confined damaged and undamaged square RC columns under cyclic loading", Steel Compos. Struct., Int. J., 21(2), 411-427. https://doi.org/10.12989/scs.2016.21.2.411
  28. Teng, J.G. and Hu, Y.M. (2007), "Behaviour of FRP-jacketed circular steel tubes and cylindrical shells under axial compression", Constr. Build. Mater., 21(4), 827-838. https://doi.org/10.1016/j.conbuildmat.2006.06.016
  29. Vijay, P.V., Clarkson, J.D., Ganga Rao, H.V.S., Soti, P.R. and Lampo, R. (2014), FRP Composites for Rehabilitation of Hydraulic Structures, Research and application of composite materials in Infrastructure, China Architecture & Building Press, pp. 164-171.
  30. Wang, J., Liu, W., Liang, R. and Ganga Rao, H. (2014a), Behavior of Concrete and Steel Columns Wrapped with FRP Composites, Research and application of composite materials in Infrastructure, China Architecture & Building Press, pp. 187-200.
  31. Wang, Y., Qian, X., Liew, J.Y.R. and Zhang, M.H. (2014b), "Experimental behavior of cement filled pipe-in-pipe composite structures under transverse impact", Int. J. Impact Eng., 72(4), 1-16. https://doi.org/10.1016/j.ijimpeng.2014.05.004
  32. Wang, J., Liu, W., Zhou, D., Zhu, L. and Fang, H. (2014c), "Mechanical behaviour of concrete filled double skin steel tubular stub columns confined by FRP under axial compression", Steel Compos. Struct., Int. J., 17(4), 431-452. https://doi.org/10.12989/scs.2014.17.4.431
  33. Wang, R., Han, L.H. and Tao, Z. (2015), "Behavior of FRPconcrete-steel double skin tubular members under lateral impact: experimental study", Thin-Wall. Struct., 95, 363-373. https://doi.org/10.1016/j.tws.2015.06.022
  34. Xiao, Y. and Shen, Y. (2012), "Impact behaviors of CFT and CFRP confined CFT stub columns", J. Compos. Constr., 16(6), 662-670. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000294
  35. Xie, Z., Yan, Q. and Li, X. (2014), "Investigation on low velocity impact on a foam core composite sandwich panel", Steel Compos. Struct., Int. J., 17(2), 159-172. https://doi.org/10.12989/scs.2014.17.2.159
  36. Yousefi, O., Narmashiri, K. and Ghaemdoust, M.R. (2017), "Structural behaviors of notched steel beams strengthened using CFRP strips", Steel Compos. Struct., Int. J., 25(1), 35-43.