Computers and Concrete

  • 제21권6호
  • /
  • Pages.607-622
  • /
  • 2018
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

3-D finite element modelling of prestressed hollow-core slabs strengthened with near surface mounted CFRP strips

  • Mahmoud, Karam (Department of Civil Engineering, University of Manitoba) ;
  • Anand, Puneet (Department of Civil Engineering, University of Manitoba) ;
  • El-Salakawy, Ehab (Department of Civil Engineering, University of Manitoba)
  • 투고 : 2017.10.21
  • 심사 : 2018.02.07
  • 발행 : 2018.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

A non-linear finite element model (FEM) was constructed using a three-dimensional software (ATENA-3D) to investigate the effect of strengthening on the behavior of prestressed hollow-core (PHC) slabs with or without openings. The slabs were strengthened using near surface mounted (NSM)-carbon fiber reinforced polymer (CFRP) strips. The constructed model was validated against experimental results that were previously reported by the authors. The validated FEM was then used to conduct an extensive parametric study to examine the influence of prestressing reinforcement ratio, compressive strength of concrete and strengthening reinforcement ratio on the behavior of such slabs. The FEM results showed good agreement with the experimental results where it captured the cracking, yielding, and ultimate loads as well as the mid-span deflection with a reasonable accuracy. Also, an overall enhancement in the structural performance of these slabs was achieved with an increase in prestressing reinforcement ratio, compressive strength of concrete, external reinforcement ratio. The presence of openings with different dimensions along the flexural or shear spans reduced significantly the capacity of the PHC slabs. However, strengthening these slabs with 2 and 4 (64 and $128mm^2$ that represent reinforcement ratios of 0.046 and 0.092%) CFRP strips was successful in restoring the original strength of the slab and enhancing post-cracking stiffness and load carrying capacity.

키워드

과제정보

연구 과제 주관 기관 : Natural Science and Engineering Research Council of Canada (NSERC)

참고문헌

  1. Al-Saadi, N.T.K and Al-Mahaidi, R. (2016), "Modelling of NSM CFRP strips embedded in concrete using lap shear tests with epoxy adhesive", J. Compos. Struct., 153, 662-672. https://doi.org/10.1016/j.compstruct.2016.06.017
  2. Al-Saadi, N.T.K. and Al-Mahaidi, R. (2016), "Modelling of near-surface mounted carbon fibre reinforced polymer strips embedded in concrete with cement-based adhesive", Constr. Build. Mater., 127, 383-393. https://doi.org/10.1016/j.conbuildmat.2016.09.109
  3. Barros, J.A.O., Dias, S.J.E. and Lima, J.L.T. (2007), "Efficacy of CFRP-based techniques for the flexural and shear strengthening of concrete beams", Cement Concrete Compos., 29(3), 203-217. https://doi.org/10.1016/j.cemconcomp.2006.09.001
  4. Bigaj, A. (1999), "Structural dependence of rotation capacity of plastic hinges", PhD Thesis, Department of civil engineering, Delft University of Technology, Delft, Netherlands.
  5. Cervenka, V., Jendele, L. and Cervenka, J. (2016), ATENA Program Documentation Part 1: Theory, Cervenka Consulting Ltd., Prague, Czech Republic.
  6. CSA (2012), Design and Construction of Building Structures with Fibre-Reinforced Polymers, CSA/S806-12, Canadian Standards Association, Toronto, Ontario, Canada.
  7. CSA (2014a), Code for the Design of Concrete Structures for Buildings, CSA/ A23.3-14, Canadian Standards Association, Toronto, Ontario, Canada.
  8. CSA (2014b), Canadian Highway Bridge Design Code, CSA/S6-14, Canadian Standards Association, Toronto, Ontario, Canada.
  9. De Lorenzis, L., Nanni, A. and La Tegola, A. (2000), "Strengthening of reinforced concrete structures with near surface mounted FRP rods", International Meeting on Composite Materials, PLAST 2000, Proceedings, Advancing with Composites, Milan, Italy, May.
  10. Elgabbas, F., El-Ghandour, A.A., Abdelrahman, A.A. and El-Dieb, A.S. (2010), "Different CFRP strengthening techniques for prestressed hollow core concrete slabs: experimental study and analytical investigation", Compos. Struct., 92(2), 401-411. https://doi.org/10.1016/j.compstruct.2009.08.015
  11. Enochsson, O., Lundqvist, J., Taljsten, B., Rusinowski, P. and Olofsson, T. (2007), "CFRP strengthened openings in two-way concrete slabs-An experimental and numerical study", Constr. Build. Mater., 21(4), 810-826. https://doi.org/10.1016/j.conbuildmat.2006.06.009
  12. fib Bulletin 14 (2001), "Externally bonded FRP reinforcement for RC structures, Federation Internationale du Beton", Switzerland.
  13. Foubert, S. (2015), "Flexural strengthening of prestressed hollow core slabs using NSM-FRP technique", MSc Thesis, University of Manitoba, Winnipeg, MB, Canada.
  14. Foubert, S., Mahmoud, K. and El-Salakawy, E. (2016), "Behavior of prestressed hollow-core slabs strengthened in flexure with near-surface mounted carbon fiber-reinforced polymer reinforcement", J. Compos. Constr., 20(6),.
  15. Hassan, T.K. and Rizkalla, S.H. (2003), "Investigation of bond in concrete structures strengthened with near surface mounted carbon fiber reinforced polymer strips", J. Compos. Constr., 7(3), 248-257. https://doi.org/10.1061/(ASCE)1090-0268(2003)7:3(248)
  16. ISIS Canada (2007), "Reinforcing concrete structures with fibre reinforced polymers", Intelligent Sensing for Innovative Structures, Winnipeg, Manitoba, Canada.
  17. Khajehdehi, R. and Panahshahi, N. (2016), "Effect of openings on in-plane structural behavior of reinforced concrete floor slabs", J. Build. Eng., 7, 1-11. https://doi.org/10.1016/j.jobe.2016.04.011
  18. Kim, S., Riyad, S. and Aboutaha, R.S. (2004), "Finite element analysis of carbon fiber-reinforced polymer (CFRP) strengthened reinforced concrete beams", Comput. Concrete, 1(4), 401-416. https://doi.org/10.12989/cac.2004.1.4.401
  19. Mahmoud, K., Foubert, S. and El-Salakawy, E. (2017), "Strengthening of prestressed concrete hollow-core slab openings using near-surface-mounted carbon fiber-reinforced polymer reinforcement", PCI J., 62(4), 61-73.
  20. Mousavi, S.S. and Dehestani, M. (2015), "Implementation of bond-slip effects on behaviour of slabs in structures", Comput. Concrete, 16(2), 311-327. https://doi.org/10.12989/cac.2015.16.2.311
  21. Taljsten, B., Carolin, A. and Nordin, H. (2003), "Concrete structures strengthened with near surface mounted reinforcement of CFRP", Adv. Struct. Eng., 6(3), 201-213. https://doi.org/10.1260/136943303322419223
  22. Teng, J.G., De Lorenzis, L., Wang, B., Li, R., Wong, T.N. and Lam, L. (2006), "Debonding failures of RC beams strengthened with near surface mounted CFRP strips", J. Compos. Constr., 2(92), 92-105.
  23. Zhang, S.S., Teng, J.G. and Yu, T. (2013), "Bond-slip model for CFRP strips near-surface mounted to concrete", Eng. Struct., 56, 945-953. https://doi.org/10.1016/j.engstruct.2013.05.032

피인용 문헌

  1. Analytical model for the basement wall horizontally supported by flexible floor diaphragms vol.79, pp.5, 2018, https://doi.org/10.12989/sem.2021.79.5.601
  2. Torsional behavior of reinforced concrete plates under pure torsion vol.28, pp.3, 2021, https://doi.org/10.12989/cac.2021.28.3.311