Computers and Concrete

  • 제21권5호
  • /
  • Pages.539-546
  • /
  • 2018
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

An investigation into the shear strength of SFRC beams with opening in web using NFEM

  • 투고 : 2017.06.11
  • 심사 : 2018.01.26
  • 발행 : 2018.05.25
⟨ 이전 논문 다음 논문 ⟩

초록

Making a transverse opening in concrete beams in order to accommodate utility services through the member instead of below or above of that, sometimes may be necessary. It is obvious that inclusions of an opening in a beam decreases its flexural and shear strengths. Fabricated steel bars are usually used to increase the capacity of the opening section, but details of reinforcements around the opening are dense and complex resulting in laborious pouring and setup process. The goal of this study was to investigate the possibility of using steel fibers in concrete mixture instead of complex reinforcement detailing order to strengthen opening section. Nonlinear finite element method was employed to investigate the behavior of steel fiber reinforced concrete beams. The numerical models were validated by comparison with experimental measurements tested by other investigators and then used to study the influence of fiber length, fiber aspect ratio and fiber content on the shear performance of SFRC slender beams with opening. Finally, it was concluded that the predicted shear strength enhancement is considerably influenced by use of steel fibers in concrete mixture but the effect of fiber length and fiber aspect ratio wasn't significant.

키워드

참고문헌

  1. Abbas, A.A., Mohsin, S.M.S. and Cotsovos, D.M. (2014), "Seismic response of steel fiber reinforced concrete beamcolumn joints", Eng. Struct., 59, 261-283. https://doi.org/10.1016/j.engstruct.2013.10.046
  2. Abbas, Y.M. and Iqbal Khan, M. (2016), "Influence of fiber properties on shear failure of steel fiber reinforced beams without web reinforcement: ANN modeling", Lat. Am. J. Solid Struct., 13, 1483-1498. https://doi.org/10.1590/1679-78252851
  3. ACI Committee 318 and American Concrete Institute and International Organization for Standardization (1995), Building Code Requirements for Structural Concrete (ACI 318-08) and Commentary, Beams in Shear, American Concrete Institute, USA.
  4. Colajanni, P., Recupero, A. and Spinella, N. (2012), "Generalization of shear truss model to the case of SFRC beams with stirrups", Comput. Concrete, 9(3), 227-244. https://doi.org/10.12989/cac.2012.9.3.227
  5. Comite Euro-International Du Beton (1993), CEB-FIP MODEL CODE 1990, Thomas Telford Publishing, UK.
  6. Du Beton, F. (2000), Bond of Reinforcement in Concrete: State-of-the-Art Report, International Federation for Structural Concrete.
  7. Du Beton, fib-Federation Internationale (2013), fib Model Code for Concrete Structures 2010, Wiley.
  8. Ezeldin, A.S. and Balaguru, P.N. (1992), "Normal-and high-strength fiber reinforced concrete under compression", J. Mater. Civil Eng., 4(4), 415-429. https://doi.org/10.1061/(ASCE)0899-1561(1992)4:4(415)
  9. Gan, Y. (2000), "Bond stress and slip modeling in nonlinear finite element analysis of reinforced concrete structures", Ph.D. Thesis, University of Toronto, Canada.
  10. Godde, L., Mark, P., Bicanic, N., de Borst, R., Mang, H. and Meschke, G. (2010), "Numerical modelling of failure mechanisms and redistribution effects in steel fiber reinforced concrete slabs", Computational Modelling of Concrete Structures (EURO-C 2010), CRC Press, Boca Raton, FL.
  11. Greenough, T. and Nehdi, M. (2008), "Shear behavior of fiberreinforced selfconsolidating concrete slender beams", ACI Mater. J., 105(5), 468.
  12. Harajli, M., Hout, M. and Jalkh, W. (1995), "Local bond stress-slip behavior of reinforcing bars embedded in plain and fiber concrete", ACI Mater. J., 92(4), 343-353.
  13. Karlsson, H. and Sorensen Inc. (2011), ABAQUS 6.11 Analysis User's Manual.
  14. Lee, S.C., Cho, J.Y. and Vecchio, F.J. (2013), "Simplified diverse embedment model for steel fiber reinforced concrete elements in tension", ACI Mater. J., 110(4), 403-412.
  15. Luccioni, B., Ruano, G., Isla, F., Zerbino, R. and Giaccio, G. (2012), "A simple approach to model SFRC", Constr. Build. Mater., 37, 111-124. https://doi.org/10.1016/j.conbuildmat.2012.07.027
  16. MacGregor, J.G. (2011), Reinforced Concrete: Mechanics and Design, Pearson Prentice Hall.
  17. Mansur, M. (1998), "Effect of openings on the behavior and strength of r/c beams in shear", Cement Concrete Compos., 20(6), 477-486. https://doi.org/10.1016/S0958-9465(98)00030-4
  18. Mansur, M. and Tan, K. (1999), Concrete Beams with Openings: Analysis and Design, New Directions in Civil Engineering, CRC Press, USA.
  19. Nasser, K. W. Acavalos, A. and Daniel, H. (1967), "Behavior and design of large openings in reinforced concrete beams", Journal Proceedings, vol. 64, pp. 25-33.
  20. Pimanmas, A. (2010), "Strengthening r/c beams with opening by externally installed frp rods: Behavior and analysis", Compos. Struct., 92(8), 1957-1976. https://doi.org/10.1016/j.compstruct.2009.11.031
  21. Prentzas, E.G. (1968), "Behavior and reinforcement of concrete beams with large rectangular apertures", Ph.D. Thesis, University of Sheffeld, UK.
  22. Sahoo, D.R., Flores, C.A. and Chao, S.H. (2012), "Behavior of steel fiber reinforced concrete deep beams with large opening", ACI Struct. J., 109(2), 193-203.
  23. Somes, N. and Corley, W. (1974), "Circular openings in webs of continuous beams", ACI Spec. Publ., 42, 359-398.
  24. Spinella, N. (2013), "Shear strength of full-scale steel fibre-reinforced concrete beams without stirrups", Comput. Concrete, 11(5), 365-382. https://doi.org/10.12989/cac.2013.11.5.365
  25. Spinella, N., Colajanni, P. and La Mendola, L. (2012), "Nonlinear analysis of beams reinforced in shear with stirrups and steel fibers", ACI Struct. J., 109(1), 53-63.
  26. Tahenni, T., Chemrouk, M. and Lecompte, T. (2016), "Effect of steel fibers on the shear behavior of high strength concrete beams", Constr. Build. Mater., 105, 14-28. https://doi.org/10.1016/j.conbuildmat.2015.12.010
  27. Tejchman, J. and Kozicki, J. (2010), Experimental and Theoretical Investigations of steel fibrous Concrete, Springer.
  28. Voo, J.Y. and Foster, D.S.J. (2003), "Variable engagement model for fiber reinforced concrete intension", University of Sheffeld, UK.