Abstract
The porosity formation by the addition of additives was found to be the highest in the case of aluminum powder 3% and $Ca(OH)_2$ 2% under the condition that strength was maintained. The optimum mixing ratio of the binder was shown to be the most effective at (Ash+Food waste+clay):(water glass+colloidal silica) 7:3, and the temperature response is most economical and effective at $1,000^{\circ}C$. The optimal mixing ratio is the strength in 30% of ash, 30% of clay and 10% of food waste, which is the effective in non-point pollution water treatment. Filter media produced under optimal mixing conditions were analyzed as $SiO_2$ 65.8%, density $1.4g/cm^3$, porosity 25.6%, pH 9.8, and no hazardous substances were detected. As a result of the filtration of the water treatment, the mean concentration of the filtered SS was $14.06mg/{\ell}$, and the removal efficiency of SS was 90%, the recovery rate of the reversal is 97.1%. This enables the development of filter media considering economic efficiency and efficiency as well as the utilization of waste resources, enabling high value added of waste resources.
본 연구에서는 연소재와 식품폐기물의 산업부산물을 이용하여 비점오염 수처리 여과재로 활용 가능한 여과재를 개발하였다. 첨가제 주입에 따른 공극 형성은 강도가 유지되는 전제하에 알루미늄 파우더 3%, $Ca(OH)_2$ 2%일 경우 기포형성이 가장 많이 발생하는 것으로 나타났다. 결합재의 적정 혼합비로서 (연소재+식품 폐기물+점토):(물유리+콜로이드성 실리카)는 7:3 이상에서 가장 효과적인 것으로 나타났으며, 온도에 따른 강도반응은 $1,000^{\circ}C$일 경우가 효과적이다. 최적의 혼합비율은 연소재 30%, 점토 30%, 식품 폐기물 10%에서 가장 높은 강도를 보여 비점오염 수처리로 활용도가 가장 높을 것이라 판단된다. 최적 배합조건에서 제조된 여과재는 $SiO_2$ 65.8%, 밀도 $1.4g/cm^3$, 공극률 25.6%, pH 9.8로 분석되었으며, 유해물질은 검출되지 않았다. 수처리에 대한 여과능을 알아본 결과 여과된 SS의 평균농도는 $14.06mg/{\ell}$로서 SS의 제거효율은 90.63%로 나타났으며, 역세척 회복률도 97.1%로 나타났다. 이는 폐자원의 활용뿐만 아니라 경제성 및 효율성을 고려한 수처리 여과재 제조가 가능함에 따라 폐자원의 높은 부가가치화가 가능하다.