한국지반신소재학회논문집 (Journal of the Korean Geosynthetics Society)

  • 제17권1호
  • /
  • Pages.139-152
  • /
  • 2018
  • /
  • 2508-2876(pISSN)
  • /
  • 2287-9528(eISSN)
한국지반신소재학회 (Korean Geosynthetics Society)
권호 표지
DOI QR코드

DOI QR Code

역해석을 통한 퇴적암 절취비탈면 불연속면(층리)의 전단강도 추정

Estimation of Shear Strength of Discontinuous (bedding) Cut Sedimentary Rock Slope by Using Back Analysis

  • 투고 : 2018.02.27
  • 심사 : 2018.03.26
  • 발행 : 2018.03.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

본 연구에서는 경상분지 퇴적암지대 특히 양산단층대(일광동래단층대) 구간 퇴적암 비탈면에서 도로 시공 시 불연속면(층리)에서 발생된 파괴사례를 분석하였다. 이 지역의 경우 다른 지역에 비해 시공 중 비탈면파괴 사례가 유독 많이 발생된 지역이다. 노출된 파괴 비탈면에 대한 Face Mapping 작성 후 한계평형법에 의한 역해석을 통해 불연속면(층리)의 전단강도 파라미터를 산정하였다. 분석 결과 이 지역 불연속면(층리면) 비탈면 경우 기존 설계 전단강도 파라미터 값 및 문헌제시 값과 비교했을 때 상당히 작게 산정되는 것으로 나타났다. 이것은 층리면에 존재하는 잔존물과 지하수의 유출 등에 의한 영향으로 볼 수 있는데, 특히 점토와 같은 풍화잔존물이 불연속면의 전단강도에 감소에 영향을 미친 것으로 판단된다. 그리고 마찰각은 층리면각과 서로 비례하는 경향을 보여 두 변수사이에 관계식을 제시하였다. 이 식을 이용하여 노출된 층리면각을 알면 쉽게 전단강도 마찰각을 손쉽게 산정할 수 있다.

This study is an analysis of slope failure examples of cut sedimentary hills during construction road in Kyoungsang Basin, especially Yangsan Fault system (Ilkwang-Dongrae fault). This area involved a lot of hillslope failures compared to other areas during road construction. The exposed failure slopes were first face-mapped, and then back analyzed based on the limit equilibrium method to assess the shear strength parameters of discontinuity (bedding). The results of this analysis indicate that the shear strength parameters of discontinuity (bedding) are significantly smaller than those used in the design stage and presented in the existing works. The filling in the bedding and emerging groundwater may be decreasing strength parameters. Especially, the clay in the bedding plays a key role in the effect of the shear strength. The study also suggests that the bedding angle and the internal friction angle are proportional to each other. Using this relationship and knowing the bedding angle, the friction can easily be estimated.

키워드

참고문헌

  1. Aydan, O., Shimizu, Y. and Ichikawa, Y. (1989), "The Effective Filure Modes and Stability of Slopes in Rock Mass with Two Discontinuity Sets", Rock Mechanics and Rock Engineering, Vol.22, No.3, pp.163-188. https://doi.org/10.1007/BF01470985
  2. Baek, Y., Koo, H. B. and Ryu, G.-J. (2002), "A Study on the Stability Analysis and Countermeasure of Tunnel Portal Failure Slope - in Suanbo Hot Springs 1 and 2 Tunnel Failure Site", The Journal of Engineering Geology, Vol.27, No.4, pp.367-378. https://doi.org/10.9720/KSEG.2017.4.367
  3. Barton, N. R. (1973), "Review of a New Shear Strength Criterion for Rock Joints", Eng. Geol., Vol.7, pp.287-332. https://doi.org/10.1016/0013-7952(73)90013-6
  4. Barton, N. R. (1974), A Review of the Shear Strength of Filled Discontinuities in Rock, Norwegian Geotech. Inst. Publ. No. 105.
  5. Barton, N. R. and Choubey, V. (1977), "The Shear Strength of Rock Joints in Theory and Practice", Rock Mech. Vol. 10. No.1-2, pp.1-54. https://doi.org/10.1007/BF01261801
  6. Coates, D. F., Gyenge, M. and Stubbins, J. B. (1965), "Slope Stability Studies at Knob Lake", Proceedings 3rd Canadian Symp. on Rock Mech., Univ. of Toronto, Mines Branch, Queens Printer, pp.35-46.
  7. Halakatevakis, N. and Sofianos, A. I. (2010), "Correlation of the Hoek-Brown Failure Criterion for a Sparsely Jointed Rock Mass with an Extended Plane of Weakness Theory," International Journal of Rock Mechanics and Mining Sciences, Vol.47, No.7, pp.1166-1179. https://doi.org/10.1016/j.ijrmms.2010.06.017
  8. Hoek, E. (1990), "Estimating Mohr-Coulomb Friction and Cohesion Values from the Hoek-Brown Failure Criterion," International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts, Vol.27, No.3, pp.227-229. https://doi.org/10.1016/0148-9062(90)94333-O
  9. Hoek, E. and Bray, J. D. (1981), Rock Slope Engineering: Third Edition, CRC Press, pp.368.
  10. Hoek, E. and Brown, E. T. (1997), "Practical Estimates of Rock Mass Strength," International Journal of Rock Mechanics and Mining Sciences, Vol.34, No.8, pp.1165-1186. https://doi.org/10.1016/S1365-1609(97)80069-X
  11. Hoek, E., Carranza-Torres, C. and Corkum, B. (2002), "Hoek-Brown Failure Criterion-2002 Edition," Proceedings of the 5th North American Rock Mechanics Symposium (NARMS-TAC '02), pp.267-273.
  12. Kim, J. H. (2004), A Case Study on Stability of Colluvial Soil Slope, Master thesis, Chonnam National University, pp.63.
  13. Kim, K. S., You, B. O. and Lee, S. D. (2002), "Failure Characteristics of Cut Slopes of Shale in Kyoungsang Basin", Proceedings of the seminar and field workshop for mudstone and shale, organized by the Korean Geotechnical Socity for Rock Mechanics Commission, pp.103-114.
  14. Kim, S.-W., Choi, E.-K., Kim, J.-W., Kim, T.-H. and Lee, K.-H. (2017), "Chemical Weathering Index of Clastic Sedimentary Rocks in Korea", The Journal of Engineering Geology, Vol.27, No.1, pp.67-79. https://doi.org/10.9720/KSEG.2017.1.67
  15. Korea Expressway Corporation (2001), Design documents the Busan-Ulsan expressway.
  16. Korea Expressway Corporation (2008), Reports of slope stability analysis on the Busan-Ulsan expressway construction site.
  17. Lee, S. H. and Kim, S. J. (2004), "Weathering Characteristics of Sedimentary Rocks Affected by Periodical Submerging", Journal of Mineralogical Society of Korea, Vol.17, No.1, pp.23-35.
  18. Lin, H., Zhong, W., Xiong, W. and Tang, W. (2014), "Slope Stability Analysis Using Limit Equilibrium Method in Nonlinear Criterion", The Scientific World Journal, Vol. 2014, Article ID 206062, pp.7, http://dx.doi.org/10.1155/2014/206062
  19. Lv, Q., Liu, Y. and Yang, Q. (2017), "Stability Analysis of Earthquake-induced Rock Slope based on Back Analysis of Shear Strength Parameters of Rock Mass", Engineering Geology, Vol.228, No.13, pp.39-49. https://doi.org/10.1016/j.enggeo.2017.07.007
  20. Park. H. D. (2002), "Engineering Geological Properties of Mudstone and Shale", Proceedings of the seminar and field workshop for mudstone and shale, organized by the Korean Geotechnical Socity for Rock Mechanics Commission, pp. 18-30.
  21. Son, M., Kim, I.-S., Lee, D. H., Lee J.-D., Kim, J. S. and Paik, I. S. (2000), "Geological Characteristics in the Eastern Part of the Ulsan Fault Area, Korea : Structural Geology and Anisotropy of Magnetic Susceptibility(AMS) in the Tertiary Miocene Waup Basin", Journal of the Geological Society of Korea, Vol.36, No.3, pp.195-216.
  22. Whitman, R. V. and Bailey, W. A. (1967), "Use of Computers for Slope Stability Analysis", J. Soil Mech. Found. Div., ASCE Vol. 93, SM4, pp.475-498.
  23. You, B. O. (2002), "Assumption of Shear Strength on Failed Discontinuities Due to Back Analysis", Proceedings of fall conference of the Korean Geotechnical Society, pp.213-227.