DOI QR코드

DOI QR Code

Behavior Analysis of a Self Excited Induction Generator with Various Loads for a Hybrid Electric Propulsion System

하이브리드 전기추진시스템 구축을 위한 SEIG의 출력 특성 분석

  • Yang, Joo-Ho (Department of Mechanical System Engineering, PKNU) ;
  • Choi, Gyo-Ho (Department of Maritime Police & Technology, Gangwon State University) ;
  • Lee, Jae-Min (Department of Mechatronics, Graduate School, PKNU) ;
  • Jeong, Seok-Kwon (Department of Refrigeration and Air-conditioning Engineering, PKNU)
  • 양주호 (부경대학교 기계시스템공학과) ;
  • 최교호 (강원도립대학교 해양경찰과) ;
  • 이재민 (부경대학교 대학원 메카트로닉스 협동과정) ;
  • 정석권 (부경대학교 냉동공조공학과)
  • Received : 2017.10.17
  • Accepted : 2018.02.19
  • Published : 2018.02.28

Abstract

This paper analyzes the output characteristics of a self excited induction generator with isolated mode according to change of its speeds and loads for building a hybrid electric propulsion system in special purpose ships by using power take off. The induction generators are being considered as an alternative choice to the well-developed generators because of their lower unit cost, inherent ruggedness, operational and maintenance simplicity. However, the generator working by stand alone has a few problems that the reactive power is required to establish the air gap magnetic flux, and the induced voltage and magnetizing current fluctuate when the load is varied. In spite of its advantages, basic design data of the capacitor bank and behaviors of the output characteristics of the generator are not sufficient for the system. Based on the operating condition(speed range of main engine) of the target boat, a reduced experimental equipment system was constructed to analyze the output characteristics of the SEIG. And a suitable capacitor bank of a stand-alone generator and its output characteristics under various loads was investigated in detail through these experiments. According to the experimental result, it was confirmed that the capacitor bank should be $70{\mu}F{\sim}100{\mu}F$, and the proper SEIG induced voltage should be DC 80 V ~ 250 V in order to storage electrical energy into a battery.

Keywords

References

  1. M. J. Kim and G. H. Chea, 2011, "Study on Catamaran Type Solar Boat Using the Pod Propulsion System", The Korean Society of Marine Environment & Safety, Vol. 17, No. 2, pp. 161-166. https://doi.org/10.7837/kosomes.2011.17.2.161
  2. J. S. Kim and S. H. Kim, 2011, "Harmonic Analysis of Power Conversion System for Torque and Speed Changing of Electric Propulsion Ship", The Korean Society of Marine Environment & Safety, Vol. 17, No. 1, pp. 83-88. https://doi.org/10.7837/kosomes.2011.17.1.083
  3. S. G. Lee, Y. S. Jeong, S. Y. Jung and C. G. Lee, 1992, "Characteristic Analysis of Integrated Power System and Propulsion Motor Comparison for Electric Vessels according to the Driving Condition", The Korean Society of Marine Environment & Safety, Vol. 15, No. 1, pp. 96-103.
  4. J. M. Lee, J. B. Kim, G. H. Choi, J. H. Yang and S. K. Jeong, 2017, "Behavior Analysis of a Self Excited Induction Generator with Various Loads for a Hybrid Electric Propulsion System", Proceed. of KSPSE (Spring), pp. 455-461.
  5. J. M. Lee, J. B. Kim, J. H. Yang, T. Y. Jeong and S. K. Jeong, 2016, "Hybrid Propulsion System Using PTO for a Small Special Ship", Proceed. of KSPSE (Fall), pp. 150-151.
  6. G. K. Singh, 2004, "Self-excited induction generator research-a survey", Electric Power Systems Research, Vol. 69, No. 2, pp. 107-114. https://doi.org/10.1016/j.epsr.2003.08.004
  7. S. S. Murthy, et al, 1998, "Studies on the use of conventional induction motors as self-excited induction generators", IEEE Transactions on Energy Conversion, Vol. 3, No. 4, pp. 842-848.
  8. Levi, Emil, 1995, "A unified approach to main flux saturation modelling in DQ axis models of induction machines", IEEE Transactions on Energy Conversion, Vol. 10, No. 3, pp. 455-461. https://doi.org/10.1109/60.464868
  9. S. Devabhaktuni and S. V. Jayaram-kumar, 1995, "Design of Excitation Capacitance for Self-Excited Induction Generator", Int. Journal of Computer Science and Communication Networks, Vol. 1, No. 3, pp. 264-269.
  10. S, Moulahoum and N. Kabache, 2011, "Behaviour Analysis of Self Excited Induction Generator Feeding Linear and No Linear Loads", Journal of Electric Engineering Technology, Vol. 8, No. 6, pp. 1371-1379. https://doi.org/10.5370/JEET.2013.8.6.1371
  11. T. Wildi, 2002, "Electrical Machines, Drives, and Power Systems(fifth edition)", Prentice-Hall, p. 313.

Cited by

  1. Charging and Discharging Characteristics Analysis of a Battery for a Hybrid Electric Propulsion System vol.22, pp.4, 2018, https://doi.org/10.9726/kspse.2018.22.4.039
  2. Evaluation of Heat Generation Characteristics during Discharging of Prismatic Lithium-Ion Battery Module for Energy Storage System vol.23, pp.1, 2018, https://doi.org/10.9726/kspse.2019.23.1.020