Wind and Structures

  • 제26권2호
  • /
  • Pages.99-114
  • /
  • 2018
  • /
  • 1226-6116(pISSN)
  • /
  • 1598-6225(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Investigation of mean wind pressures on 'E' plan shaped tall building

  • Bhattacharyya, Biswarup (Department of Civil Engineering, Indian Institute of Engineering Science and Technology) ;
  • Dalui, Sujit Kumar (Department of Civil Engineering, Indian Institute of Engineering Science and Technology)
  • 투고 : 2017.09.14
  • 심사 : 2018.01.27
  • 발행 : 2018.02.25
⟨ 이전 논문 다음 논문 ⟩

초록

Due to shortage of land and architectural aesthetics, sometimes the buildings are constructed as unconventional in plan. The wind force acts differently according to the plan shape of the building. So, it is of utter importance to study wind force or, more specifically wind pressure on an unconventional plan shaped tall building. To address this issue, this paper demonstrates a comprehensive study on mean pressure coefficient of 'E' plan shaped tall building. This study has been carried out experimentally and numerically by wind tunnel test and computational fluid dynamics (CFD) simulation respectively. Mean wind pressures on all the faces of the building are predicted using wind tunnel test and CFD simulation varying wind incidence angles from $0^{\circ}$ to $180^{\circ}$ at an interval of $30^{\circ}$. The accuracy of the numerically predicted results are measured by comparing results predicted by CFD with experimental results and it seems to have a good agreement with wind tunnel results. Besides wind pressures, wind flow patterns are also obtained by CFD for all the wind incidence angles. These flow patterns predict the behavior of pressure variation on the different faces of the building. For better comparison of the results, pressure contours on all the faces are also predicted by both the methods. Finally, polynomial expressions as the sine and cosine function of wind angle are proposed for obtaining mean wind pressure coefficient on all the faces using Fourier series expansion. The accuracy of the fitted expansions are measured by sum square error, $R^2$ value and root mean square error.

키워드

참고문헌

  1. Amin, J.A. and Ahuja, A. (2012), "Wind-induced mean interference effects between two closed spaced buildings", J. Civil Eng. - KSCE, 16(1), 119-131.
  2. AS/NZS 1170-2 (2011), Australian/New-Zealand Standard, Structural design actions, Part 2: Wind actions. Sydney, Wellington.
  3. ASCE 7-10 (2010), Minimum Design Loads for Buildings and Other Structures, American Society of Civil Engineering, ASCE Standard, Reston, Virginia.
  4. Bandi, E.K., Tamura, Y., Yoshida, A., Chul Kim, Y. and Yang, Q. (2013), "Experimental investigation on aerodynamic characteristics of various triangular-section high-rise buildings", J. Wind Eng. Ind. Aerod., 122, 60-68. https://doi.org/10.1016/j.jweia.2013.07.002
  5. Bashor, R., Bobby, S., Kijewski-Correa, T. and Kareem, A. (2012), "Full-scale performance evaluation of tall buildings under wind", J. Wind Eng. Ind. Aerod., 104-106, 88-97. https://doi.org/10.1016/j.jweia.2012.04.007
  6. BS 6399-2 (1997), Loading for buildings- Part 2: Code of practice for wind loads, British Standard, London, UK.
  7. Chakraborty, S., Dalui, S.K. and Ahuja, A.K. (2014), "Wind load on irregular plan shaped tall building-a case study", Wind Struct., 19(1), 59-73. https://doi.org/10.12989/was.2014.19.1.059
  8. Cheng, Y., Lien, F.S., Yee, E. and Sinclair, R. (2003), "A comparison of large eddy simulations with a standard k-${\varepsilon}$ Reynolds-averaged Navier-Stokes model for the prediction of a fully developed turbulent flow over a matrix of cubes", J. Wind Eng. Ind. Aerod., 91(11), 1301-1328. https://doi.org/10.1016/j.jweia.2003.08.001
  9. Cheung, J.O.P. and Liu, C.H. (2011), "CFD simulations of natural ventilation behaviour in high-rise buildings in regular and staggered arrangements at various spacings", Energ. Buildings, 43(5), 1149-1158. https://doi.org/10.1016/j.enbuild.2010.11.024
  10. Dalui, S.K. (2008), "Wind effects on tall buildings with peculiar shapes." Indian Institute of Technology Roorkee, India.
  11. Endo, M., Bienkiewicz, B. and Ham, H.J. (2006), "Wind-tunnel investigation of point pressure on TTU test building", J. Wind Eng. Ind. Aerod., 94(7), 553-578. https://doi.org/10.1016/j.jweia.2006.01.019
  12. Franke, J., Hirsch, C., Jensen, A.G., Krűs, H.W., Schatzmann, M., Westbury, P.S., Miles, S.D., Wisse, J.A. and Wright, N.G. (2004), "Recommendations on the use of CFD in wind engineering", International Conference on Urban Wind Engineering and Building Aerodynamics: COST C14: Impact of Wind and Storm on City life and Built Environment.
  13. Gomes, M.G., Moret Rodrigues, A. and Mendes, P. (2005), "Experimental and numerical study of wind pressures on irregular-plan shapes", J. Wind Eng. Ind. Aerod., 93(10), 741-756. https://doi.org/10.1016/j.jweia.2005.08.008
  14. Gomes, M.G., Rodrigues, A.M. and Mendes, P. (2003), "Wind effects on and around L- and U-shaped buildings", Proceedings of the 5th International Conference on Urban Climate (ICUC5), Lodz, Poland.
  15. Gu, M. and Quan, Y. (2004), "Across-wind loads of typical tall buildings", J. Wind Eng. Ind. Aerod., 92(13), 1147-1165. https://doi.org/10.1016/j.jweia.2004.06.004
  16. Hargreaves, D.M. and Wright, N.G. (2007), "On the use of the k-${\varepsilon}$ model in commercial CFD software to model the neutral atmospheric boundary layer", J. Wind Eng. Ind. Aerod., 95(5), 355-369. https://doi.org/10.1016/j.jweia.2006.08.002
  17. Huang, M.F., Lau, I.W.H., Chan, C.M., Kwok, K.C.S. and Li, G. (2011), "A hybrid RANS and kinematic simulation of wind load effects on full-scale tall buildings", J. Wind Eng. Ind. Aerod., 99(11), 1126-1138. https://doi.org/10.1016/j.jweia.2011.09.003
  18. Huang, S., Li, Q.S. and Xu, S. (2007), "Numerical evaluation of wind effects on a tall steel building by CFD", J. Constr. Steel Res., 63(5), 612-627. https://doi.org/10.1016/j.jcsr.2006.06.033
  19. IS 875 (Part 3) (2015), Indian standard code of practice for design wind load on building and structures, New Delhi, India.
  20. Kim, Y.C. and Kanda, J. (2013), "Wind pressures on tapered and set-back tall buildings", J. Fluid. Struct., 39, 306-321. https://doi.org/10.1016/j.jfluidstructs.2013.02.008
  21. Kim, Y.M. and You, K.P. (2002), "Dynamic responses of a tapered tall building to wind loads", J. Wind Eng. Ind. Aerod., 90(12-15), 1771-1782. https://doi.org/10.1016/S0167-6105(02)00286-6
  22. Kim, Y.M., You, K.P. and Ko, N.H. (2008), "Across-wind responses of an aeroelastic tapered tall building", J. Wind Eng. Ind. Aerod., 96(8-9), 1307-1319. https://doi.org/10.1016/j.jweia.2008.02.038
  23. Li, B., Liu, J. and Li, M. (2013), "Wind tunnel study on the morphological parameterization of building non-uniformity", J. Wind Eng. Ind. Aerod., 121, 60-69. https://doi.org/10.1016/j.jweia.2013.07.017
  24. Li, Q.S., Fang, J.Q., Jeary, A.P. and Wong, C.K. (1998), "Full scale measurements of wind effects on tall buildings", J. Wind Eng. Ind. Aerod., 74-76, 741-750. https://doi.org/10.1016/S0167-6105(98)00067-1
  25. Li, Q.S., Fu, J.Y., Xiao, Y.Q., Li, Z.N., Ni, Z.H., Xie, Z.N. and Gu, M. (2006). "Wind tunnel and full-scale study of wind effects on China‟s tallest building", Eng. Struct., 28(12), 1745-1758. https://doi.org/10.1016/j.engstruct.2006.02.017
  26. Li, Q.S., Xiao, Y.Q., Fu, J.Y. and Li, Z.N. (2007), "Full-scale measurements of wind effects on the Jin Mao building", J. Wind Eng. Ind. Aerod., 95(6), 445-466. https://doi.org/10.1016/j.jweia.2006.09.002
  27. Li, Y. and Li, Q. (2016), "Across-wind dynamic loads on L-shaped tall buildings", Wind Struct., 23(5), 385-403. https://doi.org/10.12989/was.2016.23.5.385
  28. Mukherjee, S., Chakraborty, S., Dalui, S.K. and Ahuja, A.K. (2014), "Wind induced pressure on 'Y' plan shape tall building", Wind Struct., 19(5), 523-540. https://doi.org/10.12989/was.2014.19.5.523
  29. Swaddiwudhipong, S. and Khan, M.S. (2002), "Dynamic Response of Wind-Excited Building Using CFD", J. Sound Vib., 253(4), 735-754. https://doi.org/10.1006/jsvi.2000.3508
  30. Tanaka, H., Tamura, Y., Ohtake, K., Nakai, M. and Kim, Y.C. (2012), "Experimental investigation of aerodynamic forces and wind pressures acting on tall buildings with various unconventional configurations", J. Wind Eng. Ind. Aerod., 107-108, 179-191. https://doi.org/10.1016/j.jweia.2012.04.014
  31. Wang, F., Tamura, Y. and Yoshida, A. (2013), "Wind loads on clad scaffolding with different geometries and building opening ratios", J. Wind Eng. Ind. Aerod., 120, 37-50. https://doi.org/10.1016/j.jweia.2013.06.015
  32. Yi, J. and Li, Q.S. (2015), "Wind tunnel and full-scale study of wind effects on a super-tall building", J. Fluid. Struct., 58, 236-253. https://doi.org/10.1016/j.jfluidstructs.2015.08.005
  33. Zhang, A., Gao, C. and Zhang, L. (2005), "Numerical simulation of the wind field around different building arrangements", J. Wind Eng. Ind. Aerod., 93(12), 891-904. https://doi.org/10.1016/j.jweia.2005.09.001

피인용 문헌

  1. Modelling of Wind Pressure Coefficients on C-Shaped Building Models vol.2018, pp.None, 2018, https://doi.org/10.1155/2018/6524945
  2. Experimental Investigation on the Wind-Induced Pressures on C-Shaped Buildings vol.23, pp.8, 2018, https://doi.org/10.1007/s12205-019-1929-6
  3. Effect of corner modifications on 'Y' plan shaped tall building under wind load vol.30, pp.3, 2020, https://doi.org/10.12989/was.2020.30.3.245
  4. Comparison of aerodynamic coefficients of various types of Y-plan-shaped tall buildings vol.21, pp.7, 2020, https://doi.org/10.1007/s42107-020-00265-9
  5. Research on Wind Load Calculation Based on Identical Guarantee Rate Method vol.2021, pp.None, 2018, https://doi.org/10.1155/2021/1831330
  6. Numerical Statistic Approach for Peak Factor of Non-Gaussian Wind Pressure on Building Claddings vol.2021, pp.None, 2018, https://doi.org/10.1155/2021/2918656