Smart Structures and Systems

  • 제21권2호
  • /
  • Pages.195-205
  • /
  • 2018
  • /
  • 1738-1584(pISSN)
  • /
  • 1738-1991(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Effective time-frequency characterization of Lamb wave dispersion in plate-like structures with non-reflecting boundaries

  • Wang, Zijian (Department of Dam Safety Management, Nanjing Hydraulic Research Institute) ;
  • Qiao, Pizhong (Department of Civil and Environmental Engineering, Washington State University) ;
  • Shi, Binkai (School of Mechanics and Materials, Hohai University)
  • 투고 : 2017.05.09
  • 심사 : 2018.01.11
  • 발행 : 2018.02.25
⟨ 이전 논문 다음 논문 ⟩

초록

Research on Lamb wave-based damage identification in plate-like structures depends on precise knowledge of dispersive wave velocity. However, boundary reflections with the same frequency of interest and greater amplitude contaminate direct waves and thus compromise measurement of Lamb wave dispersion in different materials. In this study, non-reflecting boundaries were proposed in both numerical and experimental cases to facilitate time-frequency characterization of Lamb wave dispersion. First, the Lamb wave equations in isotropic and laminated materials were analytically solved. Second, the non-reflecting boundaries were used as a series of frames with gradually increased damping coefficients in finite element models to absorb waves at boundaries while avoiding wave reflections due to abrupt property changes of each frame. Third, damping clay was sealed at plate edges to reduce the boundary reflection in experimental test. Finally, the direct waves were subjected to the slant-stack and short-time Fourier transformations to calculate the dispersion curves of phase and group velocities, respectively. Both the numerical and experimental results suggest that the boundary reflections are effectively alleviated, and the dispersion curves generated by the time-frequency analysis are consistent with the analytical solutions, demonstrating that the combination of non-reflecting boundary and time-frequency analysis is a feasible and reliable scheme for characterizing Lamb wave dispersion in plate-like structures.

키워드

과제정보

연구 과제 주관 기관 : National Natural Science Foundation of China

참고문헌

  1. Ambrozinski, L., Piwakowski, B., Stepinski, T. and Uhl, T. (2014), "Evaluation of dispersion characteristics of multimodal guided waves using slant stack transform", NDT & E Int., 68, 88-97. https://doi.org/10.1016/j.ndteint.2014.08.006
  2. Drozdz, M., Moreau, L., Castaings, M., Lowe, M.J.S. and Cawley, P. (2006), "Efficient numerical modelling of absorbing regions for boundaries of guided waves problems", AIP Conference Proceedings, 820(1), 126-133.
  3. Giurgiutiu, V. (2011), "Piezoelectric wafer active sensors for structural health monitoring of composite structures using tuned guided waves", J. Eng. Mater. Technol., 133(4), 041012-041012. https://doi.org/10.1115/1.4004698
  4. He, C., Liu, H., Liu, Z. and Wu, B. (2013), "The propagation of coupled Lamb waves in multilayered arbitrary anisotropic composite laminates", J. Sound Vib., 332(26), 7243-7256. https://doi.org/10.1016/j.jsv.2013.08.035
  5. Hong, M., Su, Z., Wang, Q., Cheng, L. and Qing, X. (2014), "Modeling nonlinearities of ultrasonic waves for fatigue damage characterization: theory, simulation, and experimental validation", Ultrasonics, 54(3), 770-778. https://doi.org/10.1016/j.ultras.2013.09.023
  6. Hosseini, S.M.H., Duczek, S. and Gabbert, U. (2013), "Non-reflecting boundary condition for Lamb wave propagation problems in honeycomb and CFRP plates using dashpot elements", Compos. Part B: Eng., 54, 1-10.
  7. Liu, G.R. and Quek Jerry, S.S. (2003), "A non-reflecting boundary for analyzing wave propagation using the finite element method", Finite Elem. Anal. Des., 39(5-6), 403-417. https://doi.org/10.1016/S0168-874X(02)00081-1
  8. Niethammer, M., Jacobs, L.J., Qu, J. and Jarzynski, J. (2000), "Time-frequency representation of Lamb waves using the reassigned spectrogram", J. Acoust. Soc. Am., 107(5), 19-24. https://doi.org/10.1121/1.428894
  9. Pant, S., Laliberte, J., Martinez, M. and Rocha, B. (2014), "Derivation and experimental validation of Lamb wave equations for an n-layered anisotropic composite laminate", Compos. Struct., 111, 566-579. https://doi.org/10.1016/j.compstruct.2014.01.034
  10. Poddar, B. and Giurgiutiu, V. (2016a), "Complex modes expansion with vector projection using power flow to simulate Lamb waves scattering from horizontal cracks and disbonds", J. Acoust. Soc. Am., 140(3), 2123-2133. https://doi.org/10.1121/1.4963087
  11. Poddar, B. and Giurgiutiu, V. (2016b), "Scattering of Lamb waves from a discontinuity: an improved analytical approach", Wave Motion, 65, 79-91. https://doi.org/10.1016/j.wavemoti.2016.03.009
  12. Qiu, L., Liu, M., Qing, X. and Yuan, S. (2013), "A quantitative multidamage monitoring method for large-scale complex composite", Struct. Health Monit., 12(3), 183-196. https://doi.org/10.1177/1475921713479643
  13. Rose, J.L. (2004), "Ultrasonic waves in solid media", Cambridge university press.
  14. Shen, Y. and Giurgiutiu, V. (2015), "Effective non-reflective boundary for Lamb waves: theory, finite element implementation, and applications", Wave Motion, 58, 22-41. https://doi.org/10.1016/j.wavemoti.2015.05.009
  15. Tao, C., Ji, H., Qiu, J., Zhang, C., Wang, Z. and Yao, W. (2017), "Characterization of fatigue damages in composite laminates using Lamb wave velocity and prediction of residual life", Compos. Struct., 166, 219-228. https://doi.org/10.1016/j.compstruct.2017.01.034
  16. Wang, L. and Yuan, F.G. (2007), "Group velocity and characteristic wave curves of Lamb waves in composites: modeling and experiments", Compos. Sci. Technol., 67(7-8), 1370-1384. https://doi.org/10.1016/j.compscitech.2006.09.023
  17. Wang, Q., Yuan, S.F., Hong, M. and Su, Z.Q. (2015), "On time reversal-based signal enhancement for active lamb wave-based damage identification", Smart Struct. Syst., 15(6), 1463-1479. https://doi.org/10.12989/sss.2015.15.6.1463
  18. Wang, Z. and Qiao, P. (2017), "Backward wave separation method in a single transmitter and multi-receiver sensor array for improved damage identification of two-dimensional structures", Int. J. Damage Mech., 26(2), 229-250. https://doi.org/10.1177/1056789517694477
  19. Wang, Z., Qiao, P. and Shi, B. (2016), "Application of soft-thresholding on the decomposed Lamb wave signals for damage detection of plate-like structures", Measurement, 88, 417-427. https://doi.org/10.1016/j.measurement.2015.10.001
  20. Wang, Z., Qiao, P. and Shi, B. (2017), "A comprehensive study on active Lamb wave-based damage identification for plate-type structures", Smart Struct. Syst., 20(6), 759-767 https://doi.org/10.12989/SSS.2017.20.6.759
  21. Yi, T.H., Li, H.N. and Gu, M. (2011), "Characterization and extraction of global positioning system multipath signals using an improved particle-filtering algorithm", Measurement Sci. Technol., 22 (7).
  22. Yi, T.H., Li, H.N. and Sun, H.M. (2013), "Multi-stage structural damage diagnosis method based on "energy-damage" theory", Smart Struct. Syst., 12(3-4), 345-361. https://doi.org/10.12989/sss.2013.12.3_4.345