DOI QR코드

DOI QR Code

Analysis of reinforced concrete corbel beams using Strut and Tie models

  • Parol, Jafarali (Sustainability and Reliability of Infrastructures Program, Energy and Building Research Center, Kuwait Institute for Scientific Research) ;
  • Al-Qazweeni, Jamal (Sustainability and Reliability of Infrastructures Program, Energy and Building Research Center, Kuwait Institute for Scientific Research) ;
  • Salam, Safaa Abdul (Sustainability and Reliability of Infrastructures Program, Energy and Building Research Center, Kuwait Institute for Scientific Research)
  • 투고 : 2016.05.23
  • 심사 : 2017.11.17
  • 발행 : 2018.01.25

초록

Reinforced concrete corbel beams (span to depth ratio of a corbel is less than one) are designed with primary reinforcement bars to account for bending moment and with the secondary reinforcement placed parallel to the primary reinforcement (shear stirrups) to resist shear force. It is interesting to note that most of the available analytical procedures employ empirical formulas for the analysis of reinforced concrete corbels. In the present work, a generalized and a simple strut and tie models were employed for the analysis of reinforced corbel beams. The models were benchmarked against experimental results available in the literature. It was shown here that increase of shear stirrups increases the load carrying capacity of reinforced concrete corbel beams. The effect of horizontal load on the load carrying capacity of the corbel beams has also been examined in the present paper. It is observed from the strut and tie models that the resistance of the corbel beam subjected to combined horizontal and vertical load did not change with increase in shear stirrups if the failure of the corbel is limited by concrete crushing. In other words, the load carrying capacity was independent of the horizontal load when failure of the beam occurred due to concrete crushing.

키워드

과제정보

연구 과제 주관 기관 : Kuwait Institute for Scientific Research (KISR)

참고문헌

  1. Abdul-Razzak, A.A. and Mohammad Ali, A.A. (2011a), "Influence of cracked concrete models on the nonlinear analysis of high strength steel fibre reinforced concrete corbels", Compos. Struct., 93, 2277-2287. https://doi.org/10.1016/j.compstruct.2011.03.016
  2. Abdul-Razzak, A.A. and Mohammad Ali, A.A. (2011b), "Modeling and numerical simulation of high strength fiber reinforced concrete corbels", Appl. Math. Model., 35, 2901-2915. https://doi.org/10.1016/j.apm.2010.11.073
  3. ACI 318M-11 (2011), Building Code Requirements for Structural Concrete (ACI 318M-11) and Commentary, ACI Committee 318M-11, American Concrete Institute, Farmington Hills, MI, USA.
  4. Campione, G. (2009a), "Flexural response of FRP corbels", Cement Concrete Compos., 31(3), 204-210. https://doi.org/10.1016/j.cemconcomp.2009.01.006
  5. Campione, G. (2009b), "Performance of steel fibrous reinforced concrete corbels subjected to vertical and horizontal loads", J. Struct. Eng., 135(5), 519-529. https://doi.org/10.1061/(ASCE)0733-9445(2009)135:5(519)
  6. Campione, G., La Maendola, L. and Papia, M. (2005), "Flexural behavior of concrete corbels containing steel fibres or wrapped with FRP sheets", Mater. Struct., 38(6), 617-625. https://doi.org/10.1007/BF02481593
  7. EN 1992-1-1 (2008), Eurocode 2: Design of Concrete Structures- Part 1-1: General Rules and Rules for Building.
  8. European Concrete Platform (2008), Worked Examples for Eurocode 2, ASBL, May.
  9. Fatuhi, N.I. (1990), "Column-load effect on reinforced concrete corbels", J. Struct. Eng., 116(1), 188-197. https://doi.org/10.1061/(ASCE)0733-9445(1990)116:1(188)
  10. Fatuhi, N.I. (1994), "Strength of FRC corbels in flexure", J. Struct. Eng., 120(2), 360-377. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:2(360)
  11. Fatuhi, N.I. and Hughes, B.P. (1989a), "Reinforced steel fiber concrete corbels with various shear-span to depth ratios", Struct. J., 86(6), 590-596.
  12. Fatuhi, N.I. and Hughes, B.P. (1989b), "The ductility of RC corbels containing either steel fibers or stirrups", ACI Struct. J., 86(6), 644-651.
  13. Foster, S.J., Powell, R.E. and Selim, H.S. (1996), "Performance high strength concrete corbels", ACI Struct. J., 93(5), 555-563.
  14. Hagberg, T. (2015), "Do EN 1992-1-1 and the european concrete platform comply with tests? Commentary on the rules for strut-and-tie models using corbels as an example", Struct. Concrete, 16(3), 418-428. https://doi.org/10.1002/suco.201400066
  15. Hagberg, T.H. (1966), "On the design of brackets", Beton und Stahlbetonbau, 61(3), 68-72.
  16. Hagberg, T.H. (1983), "Design of concrete brackets: on the application of the truss analogy", ACI Struct. J., 80(1), 3-12.
  17. Hermansen, B.R. and Cowan, J. (1974), "Modified shear friction theory for bracket design", ACI Struct. J., 71(2), 55-60.
  18. Huwang, S., Lu, W. and Lee, H. (2000), "Shear strength prediction for reinforced concrete corbels", ACI Struct. J., 97(4), 543-552.
  19. Kriz, L.B. and Raths, C.H. (1965), "Connections in precast concrete structures-strength of corbels", J. Prestres. Concrete Inst., 10(1), 16-61.
  20. Kumar, S. and Barai, S.V. (2010), "Neural networks modeling of shear strength of SFRC corbels without stirrups", Appl. Soft Comput., 10(1), 135-148. https://doi.org/10.1016/j.asoc.2009.06.012
  21. Manzoli, O.L., Oliver, J., Diaz, G. and Huespe, A.E. (2008), "Three-dimensional analysis of reinforced concrete members via embedded discontinuity finite elements", Struct. Mater. J., 1(1), 58-83.
  22. Mast, R.F. (1968), "Auxiliary reinforcement in concrete connections", Proc. ASCE, 94(6), 1485-1504.
  23. Mattock, A.H., Chen, K.C. and Soongswang, K. (1976), "The behavior of reinforced concrete corbels", J. Prestres. Concrete Inst., 10(1), 52-77.
  24. Mehmet, A. and Freitag, W. (1967), "Test on the load capacity of concrete brackets", Der Bauingenieur, 42(10), 362-369.
  25. Niedenhoff, H. (1961), "Studies on the structural behavior of brackets and short beams", PhD Thesis, Technical Hochschule, Karls ruhe.
  26. PCI (2004), Design Handbook, Design of Connection, Part 6.8: concrete brackets and corbels, PCI committee on Building code, Chicago 47.
  27. Rejane Martins, F.C., Daniel Alexander, K. and Mounir Khalil, E.D. (2014), "Numerical analysis of reinforced high strength concrete corbels", Eng. Struct., 74, 130-144. https://doi.org/10.1016/j.engstruct.2014.05.014
  28. Renuka Prasad, H.N., Channakeshava, C., Raghu Prasad, B.K. and Sundara Raja Iyengar, K.T. (1993), "Nonlinear finite element analysis of reinforced concrete corbel", Comput. Struct., 46(2), 343-354. https://doi.org/10.1016/0045-7949(93)90199-N
  29. Rezaei, M., Osman, S.A. and Shanmugam, N.E. (2013), "Primary and secondary reinforcements in reinforced concrete corbels", J. Civil Eng. Manage., 19(6), 836-845. https://doi.org/10.3846/13923730.2013.801896
  30. Russo, G., Venir, R., Pauletta, M. and Somma, G. (2006), "Reinforced concrete corbels-shear strength model and design formula", ACI Struct. J., 103(1), 3-7.
  31. Somerville, G. (1974), "The behavior and design of reinforced concrete corbels", Shear in Reinforced Concrete, SP-42, ACI 477-502.
  32. Strauss, A., Mordini, A. and Bergmeister, K. (2006), "Nonlinear finite element analysis of reinforced concrete corbels at both deterministic and probabilistic levels", Comput. Concrete, 3(2-3), 123-144. https://doi.org/10.12989/cac.2006.3.2_3.123
  33. Syroka, E., Bobinski, J. and Tejchman, J. (2011), "FE analysis of reinforced concrete corbels with enhanced continuum models", Finite Elem. Anal. Des., 47, 1066-1078. https://doi.org/10.1016/j.finel.2011.03.022
  34. Will, G.T., Uzamerii, S.M. and Sihna, S.K. (1972), "Application of finite element method to the analysis of reinforced concrete beam-column joint", Proceedings of Conference on Finite Element Method in Civil Engineering, Canada.
  35. Yassin, L.A.G., Sayhood, E.K. and Majeed Hasan, Q.A. (2015), "Reinforced concrete corbels-State of the Art", J. Mater. Eng. Struct., 2(4), 180-205.
  36. Yong, Y.K. and Balaguru, P. (1994), "Behavior of reinforced high strength-concrete corbels", J. Struct. Eng., 120(4), 1182-1201. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:4(1182)
  37. Zielinski, Z.A. and Rigotti, M. (1995), "Test on the shear capacity of reinforced concrete", J. Struct. Eng., 121(11), 1660-1666. https://doi.org/10.1061/(ASCE)0733-9445(1995)121:11(1660)