DOI QR코드

DOI QR Code

Uplift capacity of horizontal anchor plate embedded near to the cohesionless slope by limit analysis

  • Bhattacharya, Paramita (Department of Civil Engineering, Indian Institute of Technology Kharagpur) ;
  • Sahoo, Sagarika (Department of Civil Engineering, Indian Institute of Technology Kharagpur)
  • 투고 : 2016.08.03
  • 심사 : 2017.05.08
  • 발행 : 2017.10.25

초록

The effect of nearby cohesionless sloping ground on the uplift capacity of horizontal strip plate anchor embedded in sand deposit with horizontal ground surface has been studied numerically. The numerical analysis has been carried out by using the lower bound theorem of limit analysis with finite elements and linear optimization. The results have been presented in the form of non-dimensional uplift capacity factor of anchor plate by changing its distance from the slope crest for different slope angles, embedment ratios and angles of soil internal friction. It has been found that the decrease in horizontal distance between the edge of the anchor plate and the slope crest causes a continuous decrease in uplift capacity of anchor plate. The optimum distance is that distance between slope crest and anchor plate below which uplift capacity of an anchor plate has been found to decrease with a decrease in normalized crest distance from the anchor plate in presence of nearby sloping ground. The normalized optimum distance between the slope crest and the anchor plate has been found to increase with an increase in slope angle, embedment ratio and soil internal friction angle.

키워드

참고문헌

  1. Andresen, L., Jostad, P.H. and Andersen, K.H. (2011), "Finite element analysis applied in design of foundations and anchors for offshore structures", J. Geomech., 11(6), 417-430. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000020
  2. Basudhar, P.K. and Singh, D.N. (1994), "A generalized procedure for predicting optimal lower bound breakout factors of strip anchors", Geotechnique, 44(2), 307-318. https://doi.org/10.1680/geot.1994.44.2.307
  3. Bhattacharya, P. and Kumar, J. (2014), "Pullout capacity of inclined plate anchors embedded in sand", Can. Geotech. J., 51(11), 1365-1370. https://doi.org/10.1139/cgj-2014-0114
  4. Bhattacharya, P. and Kumar, J. (2016), "Uplift capacity of anchors in layered sand using finite element limit analysis: Formulation and results", J. Geomech., 16(3), 04015078. DOI: 10.1061/(ASCE)GM.1943-5622.0000560, 04015078
  5. Bhattacharya, P. and Roy, A. (2016), "Improvement in horizontal capacity of anchor plate in clay by granular column", Geomech. Eng., 10(5), 617-633. https://doi.org/10.12989/gae.2016.10.5.617
  6. Bildik, S., Laman, M. and Suleinman, M.T. (2013), "Uplift behavior of anchor plates in slope", Geo-Congress 2013, San Diego, California, U.S.A., March.
  7. Bottero, A., Negre, R., Pastor, J. and Turgeman, S. (1980), "Finite element method and limit analysis theory for soil mechanics problems", Comput. Methods Appl. Mech. Eng., 22(1), 131-149. https://doi.org/10.1016/0045-7825(80)90055-9
  8. Bouazza, A. and Finlay, T.W. (1990), "Uplift capacity of plate anchors buried in a two-layered sand", Geotechnique, 40(2), 293-297. https://doi.org/10.1680/geot.1990.40.2.293
  9. Das, B.M. and Seeley, G.R. (1975), "Breakout resistance of shallow horizontal anchors", J. Geotech. Engrg. Div., 101(9), 999-1003.
  10. Davis, E.H. (1968), Theories of Plasticity and Failure of Soil Masses in Soil Mechanics: Selected topics, Elsevier, New York, U.S.A., pp. 341-354.
  11. Dickin, E.A. (1988), "Uplift behavior of horizontal anchor plates in sand", J. Geotech. Eng., 114(11), 1300-1317. https://doi.org/10.1061/(ASCE)0733-9410(1988)114:11(1300)
  12. Keskin, M.S. (2015), "Model studies of uplift capacity behaviour of square plate anchors in geogridreinforced sand", Geomech. Eng., 8(4), 595-613. https://doi.org/10.12989/gae.2015.8.4.595
  13. Khatri, V.N. and Kumar, J. (2011), "Effect of anchor width on pullout capacity of strip anchors in sand", Can. Geotech. J., 48(3), 511-517. https://doi.org/10.1139/T10-082
  14. Kumar, J. (1997), "Upper bound solution for pullout capacity of anchors on sandy slopes", J. Numur. Anal. Methods Geomech., 21(7), 477-484. https://doi.org/10.1002/(SICI)1096-9853(199707)21:7<477::AID-NAG880>3.0.CO;2-I
  15. Kumar, J. (2001), "Seismic vertical uplift capacity of strip anchors", Geotechnique, 51(3), 275-279. https://doi.org/10.1680/geot.2001.51.3.275
  16. Kumar, J. (2003), "Uplift resistance of strip and circular anchors in a two layered sand", Soils Fdns, 43(1), 101-107.
  17. Kumar, J. and Khatri, V.N. (2008), "Effect of footing width on bearing capacity factor $N_{\gamma}$ for smooth strip footings", J. Geotech. Geoenviron. Eng., 134(9), 1299-1310. https://doi.org/10.1061/(ASCE)1090-0241(2008)134:9(1299)
  18. Kumar, J. and Kouzer, K.M. (2008), "Vertical uplift capacity of horizontal anchors using upper bound limit analysis and finite elements", Can. Geotech. J., 45(5), 698-704. https://doi.org/10.1139/T08-005
  19. Lyamin, A.V. and Sloan, S.W. (2002), "Lower bound limit analysis using non-linear programming", J. Numur. Methods Eng., 55(5), 573-611. https://doi.org/10.1002/nme.511
  20. Merified, R.S. and Sloan, S.W. (2006), "The ultimate pullout capacity of anchors in frictional soils", Can. Geotech. J., 43(8), 852-868. https://doi.org/10.1139/t06-052
  21. Merifield, R.S., Lyamin, A.V. and Sloan, S.W. (2006), "Three dimensional lower-bound solutions for the stability of plate anchors in sand", Geotechnique, 56(2), 123-132. https://doi.org/10.1680/geot.2006.56.2.123
  22. Meyerhof, G.G. (1973), "Uplift resistance of inclined anchors and piles", Proceedings of the 8th International Conference on Soil Mechanics and Foundation Engineering, Moscow, Russia, August.
  23. Meyerhof, G.G. and Adams, J.I. (1968), "The ultimate uplift capacity of foundations", Can. Geotech. J., 5(4), 225-244. https://doi.org/10.1139/t68-024
  24. Murray, E.J. and Geddes, J.D. (1987), "Uplift of anchor plates in sand", J. Geotech. Eng., 113(3), 202-215. https://doi.org/10.1061/(ASCE)0733-9410(1987)113:3(202)
  25. Murray, E.J. and Geddes, J.D. (1989), "Resistance of passive inclined anchors in cohesionless medium", Geotechnique, 39(3), 417-431.
  26. Niroumand, H. and Kassim, K.A. (2014a), "Uplift response of circular plates as symmetrical anchor plates in loose sand", Geomech. Eng., 6(4), 321-340. https://doi.org/10.12989/gae.2014.6.4.321
  27. Niroumand, H. and Kassim, K.A. (2014b), "Experimental and numerical modeling of uplift behavior of rectangular plates in cohesionless soil", Geomech. Eng., 6(4), 341-358. https://doi.org/10.12989/gae.2014.6.4.341
  28. Niroumand, H. and Kassim, K.A. (2014c), "Square plates as symmetrical anchor plates under uplift test in loose sand", Geomech. Eng., 6(6), 593-612. https://doi.org/10.12989/gae.2014.6.6.593
  29. Ovesen, N.K. (1981), "Centrifuge tests on the uplift capacity of anchors", Proceedings of the 10th International Conference on Soil Mechanics and Foundation Engineering, Stockholm, Sweden, June.
  30. Rangari, S.M., Choudhury, D. and Dewaikar, D.M. (2013), "Seismic uplift capacity of shallow horizontal strip anchor under oblique load using pseudo-dynamic approach", Soils Found., 53(5), 692-707. https://doi.org/10.1016/j.sandf.2013.08.007
  31. Rao, K.S.S. and Kumar, J. (1994), "Vertical uplift capacity of horizontal anchors", J. Geotech. Eng., ASCE, 120(7), 1134-1147. https://doi.org/10.1061/(ASCE)0733-9410(1994)120:7(1134)
  32. Rowe, R.K. and Davis, E.H. (1982), "The behavior of anchor plates in sand", Geotechnique, 32(1), 25-41. https://doi.org/10.1680/geot.1982.32.1.25
  33. Sakai, T. and Tanaka, T. (2007), "Experimental and Numerical study of uplift behavior of shallow circular anchor in two-layered sand", J. Geotech. Geoenviron. Eng., 133(4), 469-477. https://doi.org/10.1061/(ASCE)1090-0241(2007)133:4(469)
  34. Sloan, S.W. (1988), "Lower bound limit analysis using finite elements and linear programming", J. Numur. Anal. Methods Geomech., 12(1), 61-77. https://doi.org/10.1002/nag.1610120105
  35. Sloan, S.W. (2013), "Geotechnical stability analysis", Geotechnique, 63(7), 531-572. https://doi.org/10.1680/geot.12.RL.001
  36. Yu, S.B., Merifield, R.S., Lyamin, A.V. and Fu, X.D. (2014), "Kinematic limit analysis of pullout capacity for plate anchors in sandy slopes", Struct. Eng. Mech., 51(4), 565-579. https://doi.org/10.12989/sem.2014.51.4.565