DOI QR코드

DOI QR Code

The effect of compression load and rock bridge geometry on the shear mechanism of weak plane

  • Sarfarazi, Vahab (Department of Mining Engineering, Hamedan University of Technology) ;
  • Haeri, Hadi (Young Researchers and Elite Club, Bafgh Branch, Islamic Azad University) ;
  • Shemirani, Alireza Bagher (Department of Civil Engineering, Sadra Institute of Higher Education)
  • 투고 : 2016.06.18
  • 심사 : 2017.06.01
  • 발행 : 2017.09.25

초록

Rock bridges in rock masses would increase the bearing capacity of Non-persistent discontinuities. In this paper the effect of ratio of rock bridge surface to joint surface, rock bridge shape and normal load on failure behaviour of intermittent rock joint were investigated. A total of 42 various models with dimensions of $15cm{\times}15cm{\times}15cm$ of plaster specimens were fabricated simulating the open joints possessing rock bridge. The introduced rock bridges have various continuities in shear surface. The area of the rock bridge was $45cm^2$ and $90cm^2$ out of the total fixed area of $225cm^2$ respectively. The fabricated specimens were subjected to shear tests under normal loads of 0.5 MPa, 2 MPa and 4 MPa in order to investigate the shear mechanism of rock bridge. The results indicated that the failure pattern and the failure mechanism were affected by two parameters; i.e., the ratio of joint surface to rock bridge surface and normal load. So that increasing in joint area in front of the rock bridge changes the shear failure mode to tensile failure mode. Also the tensile failure change to shear failure by increasing the normal load.

키워드

참고문헌

  1. ASTM (1986), Test method for unconfined compressive resistance of intact rock core specimens; ASTM designation D2938-86.
  2. ASTM (1971), Standard method of test for splitting tensile resistance of cylindrical concrete specimens; ASTM designation C496-71.
  3. Bobet, A. and Einstein, H.H. (1998), "Fracture coalescence in rock-type materials under uniaxial and biaxial compression", Int. J. Rock Mech., Min. Sci. Geomech. Abstract, 35(7), 863-889. https://doi.org/10.1016/S0148-9062(98)00005-9
  4. Bahaaddini, M. (2013), "Numerical investigation of the effect of joint geometrical parameters on the mechanical properties of a non-persistent jointed rock mass under uniaxial compression", Comput. Geotech., 49, 206-225. https://doi.org/10.1016/j.compgeo.2012.10.012
  5. Fujii, Y. and Ishijima, Y. (2004), "Consideration of fracture growth from an inclined slit and inclined initial fracture at the surface of roc k and mortar in compression", Int. J. Rock Mech. Min. Sci., 41(6), 1035-1041. https://doi.org/10.1016/j.ijrmms.2004.04.001
  6. Germanovich, L.N., Salganik, R.L., Dyskin, A.V. and Lee, K.K. (1994), "Mechanisms of brittle fracture of rocks with multiple pre-existing cracks in compression", Pure Appl. Geophys., 143(1/2/3), 117-149. https://doi.org/10.1007/BF00874326
  7. Ghazvinian, A., Nikudel, M.R. and Sarfarazi, V. (2007), "Effect of rock bridge continuity and area on shear behavior of joints", Proceedings of the 11th Congress of the International Society for Rock Mechanics, Lisbon, Portugal, July, pp. 518-522.
  8. Ghazvinian, A., Nikudel, M.R. and Sarfarazi, V. (2008), "Determination of sliding path in rock slopes containing coplanar non-persistent open discontinuity", World Appl. Sci. J., 3(4), 577-589.
  9. Haeri, H. (2015a), "Experimental crack analysis of rock-like CSCBD specimens using a higher order DDM", Comput. Concrete, 16(6), 881-896. https://doi.org/10.12989/cac.2015.16.6.881
  10. Haeri, H. (2015b), "Influence of the inclined edge notches on the shear-fracture behavior in edge-notched beam specimens", Comput. Concrete, 16(4), 605-623. https://doi.org/10.12989/cac.2015.16.4.605
  11. Haeri, H. (2015c), "Propagation mechanism of neighboring cracks in rock-like cylindrical specimens under uniaxial compression", J. Min. Sci., 51(3), 487-496. https://doi.org/10.1134/S1062739115030096
  12. Haeri, H. and Sarfarazi, V. (2016), "The effect of micro pore on the characteristics of crack tip plastic zone in concrete", Comput. Concrete, Int. J., 17(1), 107-112. https://doi.org/10.12989/cac.2016.17.1.107
  13. Haeri, H., Shahriar, K., Marji, M.F. and Moarefvand, P. (2014), "Investigating the fracturing process of rock-like Brazilian discs containing three parallel cracks under compressive line loading", Strength of Mater., 46(3), 133-148.
  14. Haeri, H., Khaloo, K. and Marji, M.F. (2015a), "Experimental and numerical analysis of Brazilian discs with multiple parallel cracks", Arab. J. Geosci., 8(8), 5897-5908. https://doi.org/10.1007/s12517-014-1598-1
  15. Haeri, H., Marji, M.F. and Shahriar, K. (2015b), "Simulating the effect of disc erosion in TBM disc cutters by a semi-infinite DDM", Arab. J. Geosci., 8(6), 3915-3927. https://doi.org/10.1007/s12517-014-1489-5
  16. Haeri, H., Shahriar, K., Marji, M.F. and Moarefvand, P. (2015c), "On the HDD analysis of micro crack initiation, propagation, and coalescence in brittle materials", Arab. J. Geosci., 8(5), 2841-2852. https://doi.org/10.1007/s12517-014-1290-5
  17. Haeri, H., Sarfarazi, V. and Lazemi, H. (2016), "Experimental study of shear behavior of planar nonpersistent joint", Comput. Concrete, Int. J., 17(5), 639-653. https://doi.org/10.12989/cac.2016.17.5.639
  18. Lajtai, E.Z. (1969), "Strength of discontinuous rocks in direct shear", Geotechnique, 19(2), 218-233. https://doi.org/10.1680/geot.1969.19.2.218
  19. Li, C., Stephansson, O. and Savilahti, T. (1990), "Behaviour of rock joints and rock bridges in shear testing", Proceedings of International Symposium on Rock Joints, (N. Barton and O. Stephansson Ed.), Loen, Norway, June, pp. 259-266.
  20. Sarfarazi, V. and Haeri, H. (2016), "Effect of number and configuration of bridges on shear properties of sliding surface", J. Min. Sci., 52(2), 245-257. https://doi.org/10.1134/S1062739116020370
  21. Sarfarazi, V., Ghazvinian, A., Schubert, W., Blumel, M. and Nejati, H.R. (2014), "Numerical simulation of the process of fracture of echelon rock joints", Rock Mech. Rock Eng., 47(4), 1355-1371. https://doi.org/10.1007/s00603-013-0450-3
  22. Sarfarazi, V., Haeri, H. and Khaloo, A. (2016), "The effect of non-persistent joints on sliding direction of rock slopes", Comput. Concrete, Int. J., 17(6), 723-737. https://doi.org/10.12989/cac.2016.17.6.723
  23. Savilahti, T., Nordlund, E. and Stephansson, O. (1990), "Shear box testing and modeling of joint bridge", Proceedings of International Symposium on Shear Box Testing and Modeling of Joint Bridge Rock Joints, Loen, Norway, June, pp. 295-300.
  24. Shen, B. (1993), "The mechanics of fracture coalescence in compression experimental study and numerical simulation", Eng. Fract. Mech., 51(1), 73-85. https://doi.org/10.1016/0013-7944(94)00201-R
  25. Shen, B., Stephansson, O., Einstein, H.H. and Ghahreman, B. (1995), "Coalescence of fractures under shear stress experiments", J. Geophy. Res., 100(6), 5975-5990. https://doi.org/10.1029/95JB00040
  26. Takeuchi, K. (1991), "Mixed-mode fracture initiation in granular brittle materials", M.S. Thesis; Massachusetts Institute of Technology, Cambridge, MA, USA.
  27. Vasarhelyi, B. and Bobet, A. (2000), "Modeling of crack initiation, propagation and coalescence in uniaxial compression", Rock Mech. Rock Eng., 33(2), 119-139. https://doi.org/10.1007/s006030050038
  28. Wasantha, P.L.P., Ranjith, P.G. and Shao, S.S. (2014b), "Energy monitoring and analysis during deformation of bedded sandstone: Use of acoustic emission", Ultrasonic, 54(1), 217-226. https://doi.org/10.1016/j.ultras.2013.06.015
  29. Wong, R.H.C. and Chau, K.T. (1998), "Crack coalescence in a rock-like material containing two cracks", Int. J. Rock Mech. Min. Sci., 35(2), 147-164. https://doi.org/10.1016/S0148-9062(97)00303-3
  30. Wong, R.H.C., Leung, W.L. and Wang, S.W. (2001), "Shear strength study on rocklike models containing arrayed open joints", In: Rock Mechanics in the National Interest, (D. Elsworth, J.P. Tinucci, K.A. Heasley Ed.), Swets & Zeitlinger Lisse, pp. 843-849. ISBN: 90-2651-827-7.
  31. Yang, S.Q., Jiang, Y.Z., Xu, W.Y. and Chen, X.Q. (2008), "Experimental investigation on strength and failure behavior of pre-cracked marble under conventional triaxial compression", Int. J. Solids Struct., 45(17), 4796-4819. https://doi.org/10.1016/j.ijsolstr.2008.04.023
  32. Yang, S.Q., Dai, Y.H., Han, L.J. and Jin, Z.Q. (2009), "Experimental study on mechanical behavior of brittle marble samples containing different flaws under uniaxial compression", Eng. Fract. Mech., 76(12), 1833-1845. https://doi.org/10.1016/j.engfracmech.2009.04.005
  33. Zhang, X.P. and Wong, L.N.Y. (2012), "Cracking process in rock-like material containing a single flaw under uniaxial compression: A numerical study based on parallel bonded-particle model approach", Rock Mech. Rock Eng., 45(5), 711-737. https://doi.org/10.1007/s00603-011-0176-z
  34. Zhang, X.P. and Wong, R.H.C. (2013), "Crack initiation, propagation and coalescence in rock-like material containing two flaws: A numerical study based on bonded- particle model approach", Rock Mech. Rock Eng., 46(5), 1001-1021. https://doi.org/10.1007/s00603-012-0323-1