DOI QR코드

DOI QR Code

Effect of curing treatments on the material properties of hardened self-compacting concrete

  • Salhi, M. (Department of Civil Engineering, University of Relizane) ;
  • Ghrici, M. (Department of Civil Engineering, University of Relizane) ;
  • Li, A. (Laboratory of Civil Engineering, University of Reims Champagne Ardennes) ;
  • Bilir, T. (Department of Civil Engineering, Bulent Ecevit University)
  • Received : 2017.04.08
  • Accepted : 2017.07.08
  • Published : 2017.08.25

Abstract

This paper presents a study of the properties and behavior of self-compacting concretes (SCC) in the hot climate. The effect of curing environment and the initial water curing period on the properties and behavior of SCC such as compressive strength, ultrasonic pulse velocity (UPV) and sorptivity of the SCC specimens were investigated. Three Water/Binder (W/B) ratios (0.32, 0.38 and 0.44) have been used to obtain three ranges of compressive strength. Five curing methods have been applied on the SCC by varying the duration and the conservation condition of SCC. The results obtained on the compressive strength show that the period of initial water curing of seven days followed by maturation in the hot climate is better in comparison with the four other curing methods. The coefficient of sorptivity is influenced by W/B ratio and the curing methods. It is also shown that the sorptivity coefficient of SCC specimens is very sensitive to the curing condition. The SCC specimens cured in water present a low coefficient of sorptivity regardless of the ratio W/B. Furthermore, the results show that there is a good correlation between ultrasonic pulse velocity and the compressive strength.

Keywords

References

  1. ACI 305R-10 (2010), Guide to Hot Weather Concreting, American Concrete Institute, Michigan, U.S.A.
  2. Al-Sugair, F. (1995), "Destructive and nondestructive tests for evaluating the strength properties of concrete containing silica fume", Concrete Under Severe Conditions: Environment and Loading, CRC Press, New York, U.S.A.
  3. Almusallam, A. (2001), "Effect of environmental conditions on the properties of fresh and hardened concrete", Cement Concrete Compos., 23(4), 353-361. https://doi.org/10.1016/S0958-9465(01)00007-5
  4. ASTM C1621/C1621M (2014), Standard Test Method for Passing Ability of Self-Consolidating Concrete by J-Ring, U.S.A.
  5. ASTM C597 (2016), Standard Test Method for Pulse Velocity Through Concrete, U.S.A.
  6. Berhane, Z. (1992), "The behavior of concrete in hot climates", Mater. Struct., 25(3), 157-162. https://doi.org/10.1007/BF02472429
  7. Bingol, A.F. and Tohumcu, I. (2013), "Effects of different curing regimes on the compressive strength properties of self compacting concrete incorporating fly ash and silica fume", Mater. Des., 51, 12-18. https://doi.org/10.1016/j.matdes.2013.03.106
  8. Bonavetti, V., Donza, H., Rahhal, V. and Irassar, E. (2000), "Influence of initial curing on the properties of concrete containing limestone blended cement", Cement Concrete Res., 30(5), 703-708. https://doi.org/10.1016/S0008-8846(00)00217-9
  9. Bosiljkov, V.B. (2003), "SCC mixes with poorly graded aggregate and high volume of limestone filler", Cement Concrete Res., 33(9), 1279-1286. https://doi.org/10.1016/S0008-8846(03)00013-9
  10. Bouzoubaa, N. and Lachemi, M. (2001), "Self-compacting concrete incorporating high volumes of class F fly ash: Preliminary results", Cement Concrete Res., 31(3), 413-420. https://doi.org/10.1016/S0008-8846(00)00504-4
  11. Brandt, A.M. (2009), Cement-Based Composites: Materials, Mechanical Properties and Performance, 3rd Edition, CRC Press, New York, U.S.A.
  12. Breysse, D. (2012), "Nondestructive evaluation of concrete strength: An historical review and a new perspective by combining NDT methods", Constr. Build. Mater., 33, 139-163. https://doi.org/10.1016/j.conbuildmat.2011.12.103
  13. Bushlaibi, A.H. and Alshamsi, A.M. (2002), "Efficiency of curing on partially exposed high-strength concrete in hot climate", Cement Concrete Res., 32(6), 949-953. https://doi.org/10.1016/S0008-8846(02)00735-4
  14. Chan, S.Y.N. and Ji, X. (1998), "Water sorptivity and chloride diffusivity of oil shale ash concrete", Constr. Build. Mater., 12(4), 177-183. https://doi.org/10.1016/S0950-0618(98)00006-3
  15. Dehwah, H. (2012), "Mechanical properties of self-compacting concrete incorporating quarry dust powder, silica fume or fly ash", Constr. Build. Mater., 26(1), 547-551. https://doi.org/10.1016/j.conbuildmat.2011.06.056
  16. Domone, P.L. (2007), "A review of the hardened mechanical properties of self-compacting concrete", Cement Concrete Compos., 29(1), 1-12. https://doi.org/10.1016/j.cemconcomp.2006.07.010
  17. EFNARC (2005), The European Guidelines for Self-Compacting Concrete: Specification, Production and Use, The Self-Compacting Concrete European Project Group.
  18. EN 206-1 (2000), Concrete-Part 1: Specification, Performance, Production and Conformity.
  19. Kou, S.C. and Poon, C.S. (2009), "Properties of self-compacting concrete prepared with coarse and fine recycled concrete aggregates", Cement Concrete Compos., 31(9), 622-627. https://doi.org/10.1016/j.cemconcomp.2009.06.005
  20. Le, V.A. (2014), "Comportement des betons autoplacants par temps chaud", Ph.D. Dissertation, Universite Toulouse III-Paul Sabatier, France.
  21. Leemann, A., Loser, R. and Munch, B. (2010), "Influence of cement type on ITZ porosity and chloride resistance of self-compacting concrete", Cement Concrete Compos., 32(2), 116-120. https://doi.org/10.1016/j.cemconcomp.2009.11.007
  22. Leung, H.Y., Kim, J., Nadeem, A., Jaganathan, J. and Anwar, M.P. (2016), "Sorptivity of self-compacting concrete containing fly ash and silica fume", Constr. Build. Mater., 113, 369-375. https://doi.org/10.1016/j.conbuildmat.2016.03.071
  23. Ling, I.H. and Teo, D.C.L. (2011), " Properties of EPS RHA lightweight concrete bricks under different curing conditions", Constr. Build. Mater., 25(8), 3648-3655. https://doi.org/10.1016/j.conbuildmat.2011.03.061
  24. Liu, M. (2010), "Self-compacting concrete with different levels of pulverized fuel ash", Constr. Build. Mater., 24(7), 1245-1252. https://doi.org/10.1016/j.conbuildmat.2009.12.012
  25. Mindess, S. (1983), Mechanical Performance of Cementitious Systems, Structure and Performance of Cements, Applied Science Publishers, Essex.
  26. Mirza, S.A. and Lacroix, E.A. (2002), "Comparative study of strength-computation methods for rectangular reinforced concrete columns", ACI Struct. J., 99, 399-410.
  27. Nagaratnam, B.H., Faheem, A., Rahman, M.E., Mannan, M.A. and Leblouba, M. (2015), "Mechanical and durability properties of medium strength self-compacting concrete with high-volume fly ash and blended aggregates", Per. Polytech., 59(2), 155.
  28. Nasir, M., Al-Amoudi, O.S.B., Al-Gahtani, H.J. and Maslehuddin, M. (2016), "Effect of casting temperature on strength and density of plain and blended cement concretes prepared and cured under hot weather conditions", Constr. Build. Mater., 112, 529-537. https://doi.org/10.1016/j.conbuildmat.2016.02.211
  29. Okamura, H. and Ouchi, M. (2003), "Self-compacting concrete", J. Adv. Concrete Technol., 1(1), 5-15. https://doi.org/10.3151/jact.1.5
  30. Qasrawi, H.Y. (2000), "Concrete strength by combined nondestructive methods simply and reliably predicted", Cement Concrete Res., 30(5), 739-746. https://doi.org/10.1016/S0008-8846(00)00226-X
  31. Reinhardt, H.W. and Stegmaier, M. (2006), "Influence of heat curing on the pore structure and compressive strength of self-compacting concrete (SCC)", Cement Concrete Res., 36(5), 879-885. https://doi.org/10.1016/j.cemconres.2005.12.004
  32. Rojas-Henao, L., Fernandez-Gomez, J. and Lopez-Agui, J.C. (2012), "Rebound hammer, pulse velocity, and core tests in self-consolidating concrete", ACI Mater. J., 109(2), 235-243.
  33. Sahmaran, M., Christianto, H.A. and Yaman, I.O. (2006), "The effect of chemical admixtures and mineral additives on the properties of self-compacting mortars", Cement Concrete Compos., 28(5), 432-440. https://doi.org/10.1016/j.cemconcomp.2005.12.003
  34. Sedran, T. (1999), "Rheologie et rheometrie des betons. Application aux betons autonivelants", Ph.D. Dissertation, Ecole Nationale des Ponts et Chaussee, Paris, France.
  35. Shen, J., Yurtdas, I., Diagana, C. and Li, A. (2009), "Mix-design method of self-compacting concretes for pre-cast industry", Can. J. Civil Eng., 36(9), 1459-1469. https://doi.org/10.1139/L09-083
  36. Shirley, D.E. (1980), Concreting in Hot Weather, 4th Edition, British Cement Association.
  37. Siad, H., Mesbah, H.A., Mouli, M., Escadeillas, G. and Khelafi, H. (2014), "Influence of mineral admixtures on the permeation properties of self-compacting concrete at different ages", Arab. J. Sci. Eng., 39(5), 3641-3649. https://doi.org/10.1007/s13369-014-1055-1
  38. Skarendahl, A. and Petersson, O . (2000), State-of-the-Art Report of RILEM Technical Committee 174-SCC, Self-Compacting Concrete, RILEM Publication, Paris, France.
  39. Sonebi, M. and Bartos, P.J.M. (1999), "Hardened SCC and its bond with reinforcement", Proceedings of the 1st International RILEM Symposium, Stockholm, Sweden, September.
  40. Ulucan, Z.C., Turk, K. and Karatas, M. (2008), "Effect of mineral admixtures on the correlation between ultrasonic velocity and compressive strength for self-compacting concrete", Russ. J. Nondestruct. Test., 44(5), 367-374. https://doi.org/10.1134/S1061830908050100
  41. Uysal, M. and Yilmaz, K. (2011). "Effect of mineral admixtures on properties of self-compacting concrete", Cement Concrete Compos., 33(7), 771-776. https://doi.org/10.1016/j.cemconcomp.2011.04.005
  42. Zhao, H., Sun, W., Wu, X. and Gao, B. (2012), "Effect of initial water-curing period and curing condition on the properties of self-compacting concrete", Mater. Des., 35, 194-200. https://doi.org/10.1016/j.matdes.2011.09.053

Cited by

  1. Experimental Evaluation of Untreated and Pretreated Crumb Rubber Used in Concrete vol.11, pp.5, 2021, https://doi.org/10.3390/cryst11050558
  2. Combining internal and external curing to improve quality of self-compacting concrete with consideration of climate effects vol.12, pp.2, 2021, https://doi.org/10.12989/acc.2021.12.2.085