참고문헌
- W. Y. Yang, S. Y. Lee, Y. T. Keum, J. Y. Hwang, C. S. Yoon, C. S. Shin, W. S. Cho, 2002, Proc. Kor. Soc. Automot. Eng. Symposium, Kor. Soc. Automot. Eng., Seoul, Korea, pp. 1011-1016.
- M. K. Choi, H. Huh, 2012, Investigation of Springback Behavior of DP780 Steel Sheets after the U-bending Process, Trans. Mater. Process., Vol. 21, No. 6, pp. 384-388. https://doi.org/10.5228/KSTP.2012.21.6.384
- H. J. Choi, Y. J. Jun, S. H. Kim, K. P. Kim, D. H. Kim, Y. H. Lim, 2011, Proc. Kor. Soc. Tech. Plast. Spring Conf., Kor. Soc. Tech. Plast., Seoul, Korea, pp. 315-318.
- S. H. Chang, K. H. Shin, Y. J. Jeon, Y. M. Heo, 2012, Proc. Kor. Soc. Tech. Plast. Spring Conf., Kor. Soc. Tech. Plast., Seoul, Korea, pp. 534-537.
- H. Huh, S. B. Kim, J. H. Song, J. H. Lim, 2008, Dynamic Tensile Characteristics of TRIP-type and DP-type Steel Sheets for an Auto-Body, Int. J. Mech. Sci., Vol. 50, No. 5, pp. 918-931. https://doi.org/10.1016/j.ijmecsci.2007.09.004
- H. Huh, J. H. Lim, S. H. Park, 2009, High Speed Tensile Test of Steel Sheets for the Stress-strain Curve at the Intermediate Strain Rate, Int. J. Automot. Technol., Vol. 10, No. 2, pp. 195-204. https://doi.org/10.1007/s12239-009-0023-3
- H. B. Shim, J. K. Park, 2003, Development of Stamping Process Optimization System through the Integration of Blank Design and Nesting, Trans. Mater. Process., Vol. 12, No. 7, pp. 615-622. https://doi.org/10.5228/KSPP.2003.12.7.615
- K. P. Kim, S. H. Kim, D. G. Lee, K. C. Jang, 2008, Analysis-based Die Face Design for the Improvement of Surface Quality for a Heat Pretect Panel of an Automobile, Trans. Mater. Process., Vol. 17, No. 4, pp. 278-283. https://doi.org/10.5228/KSPP.2008.17.4.278
- B. G. Kim, I. S. Lee, Y. T. Keum, 2009, Study on the Springback Reduction of Automotive Advanced High Strength Steel Panel, Trans. Mater. Process., Vol. 18, No. 6, pp. 488-493. https://doi.org/10.5228/KSPP.2009.18.6.488
피인용 문헌
- Process Design of Automobile Seat Rail Lower Parts using Ultra-High Strength, DP980 Steel vol.17, pp.2, 2018, https://doi.org/10.14775/ksmpe.2018.17.2.160