DOI QR코드

DOI QR Code

A hybrid seismic response control to improve performance of a two-span bridge

  • Heo, Gwanghee (Department of Civil Engineering, Konyang University) ;
  • Kim, Chunggil (Department of Civil Engineering, Konyang University) ;
  • Jeon, Seunggon (Department of Civil Engineering, Chungnam National University) ;
  • Lee, Chinok (Department of Civil Engineering, Chungnam National University) ;
  • Jeon, Joonryong (Department of Civil Engineering, Konyang University)
  • 투고 : 2015.12.04
  • 심사 : 2017.01.25
  • 발행 : 2017.03.10

초록

In this paper, a hybrid seismic response control (HSRC) system was developed to control bridge behavior caused by the seismic load. It was aimed at optimum vibration control, composed of a rubber bearing of passive type and MR-damper of semi-active type. Its mathematical modeling was driven and applied to a bridge model so as to prove its validity. The bridge model was built for the experiment, a two-span bridge of 8.3 meters in length with the HSRC system put up on it. Then, inflicting the EI Centro seismic load on it, shaking table tests were carried out to confirm the system's validity. The experiments were conducted under the basic structure state (without an MR-damper applied) first, and then under the state with an MR-damper applied. It was also done under the basic structure state with a reinforced rubber bearing applied, then the passive on/off state of the HSRC system, and finally the semi-active state where the control algorithm was applied to the system. From the experiments, it was observed that pounding rather increased when the MR-damper alone was applied, and also that the application of the HSRC system effectively prevented it from occurring. That is, the experiments showed that the system successfully mitigated structural behavior by 70% against the basic structure state, and, further, when control algorithm is applied for the operation of the MR-damper, relative displacement was found to be effectively mitigated by 80%. As a result, the HSRC system was proven to be effective in mitigating responses of the two-span bridge under seismic load.

키워드

과제정보

연구 과제 주관 기관 : National Research Foundation of Korea

참고문헌

  1. Bouc, R. (1971), "Modele mathematique d'hysteresis", Acustica, 24(3), 16-25.
  2. DesRoches, R., Comerio, M., Eberhard, M., Mooney, W. and Rix, G.J. (2011), "Overview of the 2010 Haiti Earthquake", Earthq. Spectra, 27(S1), S1-S21. https://doi.org/10.1193/1.3630129
  3. Dyke, S.J., Spencer, Jr. B.F., Sain, M.K. and Carlson, J.D. (1996), "Experimental verification of semi-active structural control strategies using acceleration feedback", Proceeding of 3rd International Conference on Motion and Vibration Control, 3, 291-296.
  4. El-Bahey, S. and Bruneau, M. (2012), "Bridge piers with structural fuses and bi-steel columns. I: Exp Test", J. Bridge Eng., ASCE, 17(1), 25-35. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000234
  5. El-Bahey, S. and Bruneau, M. (2012), "Bridge piers with structural fuses and bi-Steel columns. II: analytical investigation", J. Bridge Eng., ASCE, 17(1), 36-46. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000236
  6. Guo, A., Li, Z., Li, H. and Ou, J. (2009), "Experimental and analytical study on pounding reduction of base-isolated highway bridges using MR dampers", Earthq. Eng. Struct. Dyn., 38, 1307-1333. https://doi.org/10.1002/eqe.903
  7. Han, Q., Du, X., Liu, J., Li, Z., Li, L. and Zhao, J. (2009), "Seismic damage of highway bridges during the 2008 Wenchuan earthquake", Earthq. Eng. Eng. Vib., 8, 263-273. https://doi.org/10.1007/s11803-009-8162-0
  8. Heo, G., Kim, C. and Lee, C. (2013), "Experimental test of asymmetrical cable-stayed bridges using MR-damper for vibration control", Soil Dyn. Earthq. Eng., 57, 78-85
  9. Heo, G.H. and Jeon, S.G. (2013), "Characteristics and dynamic modeling of MR damper for semi-active vibration control", J. Korea Inst. Struct. Mainten. Inspect., 17(6), 61-69. https://doi.org/10.11112/jksmi.2013.17.6.061
  10. Ikhouane, F. and Dyke, S.J. (2007), "Modeling and identification of a shear mode magnetorheological damper", Smart Mater. Struct., 16(3), 605-616. https://doi.org/10.1088/0964-1726/16/3/007
  11. Ikhouane, F., Manosa, V. and Rodellar, J. (2007), "Dynamic properties of the hysteretic Bouc-Wen model", Syst. Control Lett., 56(3), 197-205. https://doi.org/10.1016/j.sysconle.2006.09.001
  12. Jankowski, R., Wilde, K. and Fujino, Y. (1998), "Pounding of superstructure segments in isolated elevated bridge during earthquakes", Earthq. Eng. Struct. Dyn., 27(5), 487-502. https://doi.org/10.1002/(SICI)1096-9845(199805)27:5<487::AID-EQE738>3.0.CO;2-M
  13. Kajita, Y., Sugiura, K., Tsumura, Y., Maruyama, T. and Watanabe, E. (1998), "Numerical Analysis on the Scenario of Girder Fall-off of Simple Span Elevated Bridge during Strong Ground Motions", Fifth Pacific Structural Steel Conference, 8(1), 583-588.
  14. Kwok, N.M., Ha, Q.P., Nguyen, M.T., Li, J. and Samali, B. (2007), "Bouc-Wen model parameter identification for a MR fluid damper using computationally efficient GA", ISA Tran., 46(2), 167-179. https://doi.org/10.1016/j.isatra.2006.08.005
  15. Lei, Y. and He, M. (2013), "Identification of the nonlinear properties of rubber-bearings in base-isolated buildings with limited seismic response data", Sci. China Technol. Sci., 56(5), 1224-1231. https://doi.org/10.1007/s11431-013-5196-3
  16. Li, Z.X. and Yue, F.Q. (2006), "Analysis and control for seismic pounding responses of urban elevated bridges", 4th International Conference on Earthquake Engineering Taipei, Paper No. 083.
  17. Li, Z.X., Chen, Y. and Shi, Y.D. (2016), "Seismic damage control of nonlinear continuous reinforced concrete bridges under extreme earthquakes using MR dampers", Soil Dyn. Earthq. Eng., 88, 386-398. https://doi.org/10.1016/j.soildyn.2016.07.015
  18. Qin, H. and Guo, W.D. (2012), "Group effects of piles due to lateral soil movement", Int. J. GEOMATE, 4(1), 450-455.
  19. Raheem, S.E.A. (2009), "Pounding mitigation and unseating prevention at expansion joints of isolated multi-span bridges", Eng. Struct., 31, 2345-2356. https://doi.org/10.1016/j.engstruct.2009.05.010
  20. Ruangrassamee, A. and Kawashima, K. (2003), "Control of nonlinear bridge response with pounding effect by variable dampers", Eng. Struct., 25, 593-606. https://doi.org/10.1016/S0141-0296(02)00169-4
  21. Sheikh, M.N., Xiong, J. and Li, W.H. (2012), "Reduction of seismic pounding effects of base-isolated RC highway bridges using MR damper", Struct. Eng. Mech., 41(6), 791-803. https://doi.org/10.12989/sem.2012.41.6.791
  22. Tanabe, T., Machida, A., Higai, T. and Matsumoto, N. (1998), "General view of the reasons for seismic damages for bridge piers and columns of elevated bridges at Hyogoken-Nanbu earthquake", Structural Engineering World Congress, T153-4.
  23. Wen, Y.K. (1976), "Method for random vibration of hysteretic systems", J. Eng. Mech., 102(2), 249-263.
  24. Yang, M.G., Chen, Z.Q. and Hua, X.G. (2011), "An experimental study on using MR damper to mitigate longitudinal seismic response of a suspension bridge", Soil Dyn. Earthq. Eng., 31(8), 1171-1181. https://doi.org/10.1016/j.soildyn.2011.04.006
  25. Zanardo, G., Hao, H. and Modena, C. (2002), "Seismic response of multi-span simply supported bridges to a spatially varying earthquake ground motion", Earthq. Eng. Struct. Dyn., 31, 1325-1345. https://doi.org/10.1002/eqe.166
  26. Zhang, J., Huo, Y., Brandenberg, S.J. and Kashighandi, P. (2008), "Effects of structural characterizations on fragility functions of bridges subject to seismic shaking and lateral spreading", Earthq. Eng. Eng. Vib., 7(4), 369-382. https://doi.org/10.1007/s11803-008-1009-2

피인용 문헌

  1. Seismic performance and design of bridge piers with rocking isolation vol.73, pp.4, 2020, https://doi.org/10.12989/sem.2020.73.4.447
  2. Development of a hybrid control algorithm for effective reduction of drift in multispan isolated bridges vol.143, pp.None, 2021, https://doi.org/10.1016/j.soildyn.2021.106659