Structural Engineering and Mechanics

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Strength and durability studies on high strength concrete using ceramic waste powder

  • Karthikeyan, B. (School of Civil Engineering, SASTRA University) ;
  • Dhinakaran, G. (School of Civil Engineering, SASTRA University)
  • Received : 2016.04.21
  • Accepted : 2016.08.02
  • Published : 2017.01.25
⟨ Previous Next ⟩

Abstract

This paper summarizes the study on effect of ceramic waste powder as partial substitute to cement in binary blend and along with silica fume in ternary blend high strength concrete in normal and aggressive environments. Strength parameters such as compression & tension and durability indices such as corrosion measurement, deterioration, water absorption and porosity were studied. Ceramic waste powder was used in three different percentages namely 5, 10 and 15 with constant percentage of silica fume (1%) as substitutes to cement in ternary blend high strength concrete was investigated. After a detailed investigation, it was understood that concrete with 15% ceramic waste powder registered maximum performance. Increase of ceramic waste powder offered better resistance to deterioration of concrete.

Keywords

References

  1. American Society for Testing and Materials (ASTM), Standard Test method for Density, Absorption and voids in Hardened Concrete, ASTM C 642-13, Annual book of ASTM standards, West Conshohockers, United States.
  2. American Society for Testing and Materials (ASTM), Standard Test method for Half-Cell Potentials of Uncoated Reinforcing Steel in Concrete, ASTM C 876-91,Annual book of ASTM standards, West Conshohockers, United States.
  3. American Society for Testing and Materials (ASTM), Standard Test method for Measurement of Rate of Absorption of water by Hydraulic Cement Concrete, ASTM C 1585-13, Annual book of ASTM standards, West Conshohockers, United States.
  4. Appa Rao, G. (2001),"Development of strength with age of mortars containing silica fume", Cem. Conc. Res, 31(8): 1141-1146. https://doi.org/10.1016/S0008-8846(01)00540-3
  5. Atis, C.D. and Bilim, C. (2007), "Wet and dry cured compressive strength of concrete containing ground granulated blast-furnace slag", Build. Environ., 42(8), 3060-3065. https://doi.org/10.1016/j.buildenv.2006.07.027
  6. Ay, N. and Unal, M. (2000), "The use of waste ceramic tile in cement production", Cement Concrete Res., 30, 497-499. https://doi.org/10.1016/S0008-8846(00)00202-7
  7. BS 1881-108 (1983), "Testing concrete - Method for making test cubes from fresh concrete", British Standards Institution, 2 Park Street London W1 A 2BS.
  8. Chalee, W., Ausapanit, P. and Jaturapitakkul, C. (2010), "Utilization of fly ash concrete in marine environment for long term design life analysis", Mater. Des., 31(3), 1242-1249. https://doi.org/10.1016/j.matdes.2009.09.024
  9. Cheriyan, S.G., Dhanya, B.S. and Santhanam, M. (2014), "Durability indices for concretes with different dosages of mineral admixtures", India Concrete J., 88(3), 60-68.
  10. Chidambaram, N., Srikanth, J., Karthikeyan, B. and Dhinakaran, G. (2015), "Mechanical properties and micro structure characteristics of ternary blended concrete with ceramic powder and $SiO_2$", Asian J. Appl. Sci., 8(3), 304-314.
  11. Ergun, A. (2011), "Effect of the usage of diatomite and waste marble powder as partial replacement of cement on the mechanical properties of concrete", Constr. Build. Mater., 25(2), 806-812. https://doi.org/10.1016/j.conbuildmat.2010.07.002
  12. Flower, D.J.M. and Sanjayan, J.G. (2007), "Green house gas emissions due to concrete manufacture", Int. J. Life Cycle Assess., 12(5), 282-288. https://doi.org/10.1065/lca2007.05.327
  13. Guneyisi, E., Gesoglu, M. and Mermerdas, K. (2010), "Strength deterioration of plain and metakaolin concretes in aggressive sulfate environments", J. Mater. Civil Eng., 22(4), 403-407. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000034
  14. Halicka, A., Ogrodnik, P. and Zegardlo, B. (2013),"Using ceramic sanitary ware as concrete aggregate", Constr. Build. Mater., 48, 295-305. https://doi.org/10.1016/j.conbuildmat.2013.06.063
  15. Heidari, A. and Tavakoli, D. (2013), "A study of the mechanical properties of ground ceramic powder concrete incorporating nano-$SiO_2$ particles", Constr. Build. Mater., 38, 255-264. https://doi.org/10.1016/j.conbuildmat.2012.07.110
  16. Jaturapitakkul, C., Kiattikomol, K., Sata, V. and Leekeeratikul, T. (2004), "Use of ground coarse flu ash as a replacement of condensed silica fume in producing high-strength concrete", Cement Concrete Res., 34(4), 549-555. https://doi.org/10.1016/S0008-8846(03)00150-9
  17. Jaturapitakkul, C., Kiattilomol, K., Sata, V. and Leekeeratikul, T. (2004), "Use of ground coarse flyash as a replacement of condensed silica fume in producing high-strength concrete", Cement Concrete Res., 34(4), 549-555. https://doi.org/10.1016/S0008-8846(03)00150-9
  18. Kartikeyan, B., Sumanth, K., Harshavardhan, G., Rajasekharareddy, A. and Dhinakaran, G. (2014), "Microstructure analysis and strength properties of concrete with nano $SiO_2$", Int. J. Chem Tech. Res., 6(5), 3004-3013.
  19. Khatib, J.M., Roger, M. and Clay, R.M. (2004), "Absorption characteristics of metakaolin concrete", Cement Concrete Res., 34(1), 19-29. https://doi.org/10.1016/S0008-8846(03)00188-1
  20. Pacheco-Torgal, F. and Jalali, S. (2010), "Reusing ceramic wastes in concrete", Constr. Build. Mater., 24(5), 832-838. https://doi.org/10.1016/j.conbuildmat.2009.10.023
  21. Pradhan, B. (2014), "Corrosion behavior of steel reinforcement in concrete exposed to composite chloride-sulfate environment", Constr. Build. Mater, 72(15), 398-410. https://doi.org/10.1016/j.conbuildmat.2014.09.026
  22. Rajamane, N.P., Peter, J.A., Dattatreya, J.K., Neelamegam, M., and Gopalakrishnan, S. (2003), "Improvement in properties of high performance concrete with partial replacement of concrete by ground granulated blast furnace slag", J. Inst. Eng. India. Civil Eng. Div., 84, 38-42.
  23. Razak, H.A., Chai, M.K. and Wong, H.S. (2004), "Near surface characteristics of concrete containing supplementary cementitious materials", Cement Concrete Compos., 26(7), 883-889. https://doi.org/10.1016/j.cemconcomp.2003.10.001
  24. Saraswathy, V., Muralidharan, S., Thangavel, K. and Srinivasan, S. (2003), "Influence of activated fly ash on corrosionresistance and strength of concrete", Cement Concrete Compos., 25(7), 673-680. https://doi.org/10.1016/S0958-9465(02)00068-9
  25. Sayieda, R.Z., Maha R.M., Doaa, A.A. and Aya, H.M. (2015), "Alkali activated Ceramic Waste with or without two different calcium sources", Adv. Mater. Res., 4(3), 133-144. https://doi.org/10.12989/amr.2015.4.3.133
  26. Senthamarai, R.M., Devadas Manoharan, P. and Gobinath, D. (2011), "Concrete made from ceramic industry waste: Durability properties", Constr. Build. Mater., 25(5), 2413-2419. https://doi.org/10.1016/j.conbuildmat.2010.11.049
  27. Shannag, M.J. (2000), "High strength concrete containing natural pozzolan and silica fume", Cement Concrete Compos., 22(6), 399-406. https://doi.org/10.1016/S0958-9465(00)00037-8
  28. Sharmila, P. and Dhinakaran, G. (2015), "Effect of nano sized slag on Micro structure, Compressive Strength and durability of Concrete", Strut. Eng. Mech., 55(3), 675-686. https://doi.org/10.12989/sem.2015.55.3.675
  29. Srikanth, J., Chidambaram, N., Karthikeyan, B. and Dhinakaran, G. (2015), "Resistance to deterioration and water absorption by ternary blended concrete with ceramic powder and $SiO_2$", Int. J. Chem. Tech. Res., 8(2), 696-703.
  30. Teng, S., Lim, T.Y.D. and Divsholi, B.S. (2013), "Durability and mechanical properties of high strength concrete incorporating ultra fine ground granulated blast-furnace slag", Constr. Build. Mater., 40, 875-881. https://doi.org/10.1016/j.conbuildmat.2012.11.052
  31. Vejmelkova, E., Keppert, M., Rovnanikova, P., Ondracek, M., Kersner, Z. and cerny, R. (2012), "Properties of high performance concrete containing fine-ground ceramics as supplementary cementitious material", Cement Concrete Compos, 34(1), 55-61. https://doi.org/10.1016/j.cemconcomp.2011.09.018

Cited by

  1. Strength and durability characteristics of ternary blend and lightweight HPC vol.134, 2017, https://doi.org/10.1016/j.conbuildmat.2016.12.201
  2. Influence of ultrafine TiO 2 and silica fume on performance of unreinforced and fiber reinforced concrete vol.161, 2018, https://doi.org/10.1016/j.conbuildmat.2017.11.133
  3. Experimental Evaluation of Untreated and Pretreated Crumb Rubber Used in Concrete vol.11, pp.5, 2021, https://doi.org/10.3390/cryst11050558