Computers and Concrete

  • 제19권1호
  • /
  • Pages.79-85
  • /
  • 2017
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Structural behaviour of HFRC beams retrofitted for shear using GFRP laminates

  • Vinodkumar, M. (Department of Civil Engineering, PSNA College of Engg. and Tech.) ;
  • Muthukannan, M. (Department of Civil Engineering, Kalasalingam University)
  • 투고 : 2016.08.31
  • 심사 : 2016.10.23
  • 발행 : 2017.01.25
⟨ 이전 논문 다음 논문 ⟩

초록

This paper summarizes the experimental study of the shear behaviour of Hybrid Fibre Reinforced Concrete (HFRC) beams retrofitted by using externally bonded Glass Fibre Reinforced Polymer (GFRP) laminates. To attain the set-out objectives of the present investigation, steel fibre of 1% and polypropylene fibre of 0.30% was used for hybrid steel-polypropylene fibre reinforced concrete: whereas for hybrid glass-polypropylene fibre reinforced concrete, glass fibre by 0.03% and polypropylene fibre of 0.03% by volume of concrete was used. In this study, 9 numbers of beams were cast and tested into three groups (Group I, II & III). Each group containing 3 numbers of beams, out of which one serve as a control beam or a hybrid steel-polypropylene fibre reinforced concrete beam or a hybrid glass - polypropylene fibre reinforced concrete beam and the remaining two beams were preloaded until shear cracks appeared up to 75% of ultimate load and then preloaded beams (damaged beams) were retrofitted with GFRP laminates at shear zone in the form of strips, as one beam in vertical position and another beam in inclined position to restrict the shear cracks. Finally, the retrofitted beams were loaded until failure and test results were compared. The experimental tests have been conducted to investigate various parameters of structural performance, such as load carrying capacity, crack pattern and failure modes, load-deflection responses and ductility relations. The test results revealed that beams retrofitted using GFRP laminates considerably increased the load carrying capacity. In addition, it was found that beams retrofitted with inclined strip offers superior performance than vertical one. Comparing the test results, it was observed that hybrid steel-polypropylene fibre reinforced concrete beam retrofitted with GFRP laminates showed enhanced behaviour as compared to other tested beams.

키워드

참고문헌

  1. Jaber, M.S.A., Abdel-Jaber, M.S. and Shatanawi, A.S. (2007), "Jordan journal of civil engineering", 1(4), 327-335.
  2. ACI Committee 440 (2008), "Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures", ACI 440.2R-08, American Concrete Institute, Michigan, U.S.A.
  3. ACI Committee 544 (2002), "State-of-the-art report on fiber reinforced concrete", ACI 5441, R-96, 1-66.
  4. ASTM C494 Type F "Standard specification for chemical admixtures for concrete".
  5. Attari, N., Amziane, S. and Chemrouk, M. (2012), "Flexural strengthening of concrete beams using CFRP, GFRP and hybrid FRP sheets", Cement Build. Mater., 37, 746-757. https://doi.org/10.1016/j.conbuildmat.2012.07.052
  6. Belarbi, A., Bae, S. and Brancaccio, A. (2012), "Behavior of fullscale RC T-beams strengthened in shear with externally bonded FRP sheets", Constr. Build. Mater., 32, 27-40. https://doi.org/10.1016/j.conbuildmat.2010.11.102
  7. Bentur, A. and Mindess, S. (1990), Fiber Reinforced Cementitious Composites, Elsevier, London, U.K.
  8. Ganesan, N., Indira, P.V. and Sabeena, M.V. (2014), "Behaviour of hybrid fibre reinforced concrete beam-column joints under reverse cyclic loads", Mater. Design, 54, 686-693. https://doi.org/10.1016/j.matdes.2013.08.076
  9. Hosny, A., Shaheen, H., Abdelrahman, A. and Elafandy, T. (2006), "Performance of reinforced concrete beams strengthened by hybrid FRP laminates", Cement Concrete Compos., 28(10), 906-913. https://doi.org/10.1016/j.cemconcomp.2006.07.016
  10. IS: 12269 (1987), "Indian standards-specification for 53 grade ordinary Portland cement".
  11. IS: 9103 (1999), "Indian standards-specification for concrete admixtures".
  12. IS: 10262 (2009), "Indian standards-concrete mix proportioning guide".
  13. IS: 383 (1970), "Indian standards-specification for coarse and fine aggregates from natural sources for concrete".
  14. Kakemi, M. and Hannant, D.J. (1995), "Mathematical model for the tensile behavior of hybrid continuous fiber cement composites", Compos., 26(9), 637-643. https://doi.org/10.1016/0010-4361(95)98912-5
  15. Mobasher, B. and Li, C.Y. (1996), "Mechanical properties of hybrid cement-based composites", ACI Mater. J., 93(3), 284-292.
  16. Mosallam, A.S. and Banerjee, S. (2007), "Shear enhancement of reinforced concrete beams strengthened with FRP composite laminates", Compos.: Part B: Eng., 38(5), 781-793. https://doi.org/10.1016/j.compositesb.2006.10.002
  17. Obaidat, Y.T., Heyden, S., Dahlblom, O., Farsakh, G.A. and Jawad, Y.A. (2011), "Retrofitting of reinforced concrete beams using composite laminates", Constr. Build. Mater., 25(2), 591-597. https://doi.org/10.1016/j.conbuildmat.2010.06.082
  18. Sharmila, S. and Thirugnanam, G.S. (2013), "Behaviour of reinforced concrete flexural member with hybrid fibre under cyclic loading", J. Sci. Technol., 2(4), 725-734.
  19. Sobuz, H.R., Ahmed, E., Sutan, N.M., Hasan, N.M.S., Uddin, M.A. and Uddin, M.J. (2012), "Bending and time-dependent responses of RC beams strengthened with bonded carbon fiber composite laminates", Constr. Build. Mater., 29, 597-611. https://doi.org/10.1016/j.conbuildmat.2011.11.006
  20. Tersawy, S.H.A. (2013), "Effect of fiber parameters and concrete strength on shear behavior of strengthened RC beams", Constr. Build. Mater., 44, 15-24. https://doi.org/10.1016/j.conbuildmat.2013.03.007
  21. Wafa, F.F. (1990), "Properties and applications of fiber reinforced concrete", JKAU: Eng. Sci., 2(1), 49-63. https://doi.org/10.4197/Eng.2-1.4
  22. Xu, G. and Hannant, D.J. (1992), "Flexural behavior of combined polypropylene network and glass fiber reinforced cement", Cement Concrete Compos., 14(1), 51-61. https://doi.org/10.1016/0958-9465(92)90039-X
  23. Yaoa, W., Lib, J. and Wua, K. (2003), "Mechanical properties of hybrid fiber-reinforced concrete at low fiber volume fraction", Cement Concrete Res., 33(1), 27-30. https://doi.org/10.1016/S0008-8846(02)00913-4
  24. Zhang, Z. and Hsu, C.T.T. (2005), "Shear strengthening of reinforced concrete beams using carbon-fiber-reinforced polymer laminates", J. Compos. Constr., 9(2), 158-169. https://doi.org/10.1061/(ASCE)1090-0268(2005)9:2(158)

피인용 문헌

  1. Using Steel Fiber-Reinforced Concrete Precast Panels for Strengthening in Shear of Beams: An Experimental and Analytical Investigation vol.2019, pp.None, 2017, https://doi.org/10.1155/2019/4098505
  2. Pervious Geopolymer Concrete under Ambient Curing vol.46, pp.p7, 2017, https://doi.org/10.1016/j.matpr.2021.02.425