Wind and Structures

  • 제25권6호
  • /
  • Pages.537-549
  • /
  • 2017
  • /
  • 1226-6116(pISSN)
  • /
  • 1598-6225(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Comparative study of turbulent flow around a bluff body by using two- and three-dimensional CFD

  • Ozdogan, Muhammet (Department of Mechanical Engineering, Ondokuz Mayis University) ;
  • Sungur, Bilal (Department of Mechanical Engineering, Ondokuz Mayis University) ;
  • Namli, Lutfu (Department of Mechanical Engineering, Ondokuz Mayis University) ;
  • Durmus, Aydin (Department of Mechanical Engineering, Ondokuz Mayis University)
  • 투고 : 2017.08.24
  • 심사 : 2017.11.29
  • 발행 : 2017.12.25
⟨ 이전 논문 다음 논문 ⟩

초록

In this study, the turbulent flow around a bluff body for different wind velocities was investigated numerically by using its two- and three-dimensional models. These models were tested to verify the validity of the simulation by being compared with experimental results which were taken from the literature. Variations of non-dimensional velocities in different positions according to the bluff body height were analysed and illustrated graphically. When the velocity distributions were examined, it was seen that the results of both two- and three-dimensional models agree with the experimental data. It was also seen that the velocities obtained from two-dimensional model matched up with the experimental data from the ground to the top of the bluff body. Particularly, compared to the front part of the bluff body, results of the upper and back part of the bluff body are better. Moreover, after comparing the results from calculations by using different models with experimental data, the effect of multidimensional models on the obtained results have been analysed for different inlet velocities. The calculation results from the two-dimensional (2D) model are in satisfactory agreement with the calculation results of the three-dimensional model (3D) for various flow situations when comparing with the experimental data from the literature even though the 3D model gives better solutions.

키워드

참고문헌

  1. Ai, Z.T. and Mak, C.M. (2013), "CFD simulation of flow and dispersion around an isolated building: Effect of inhomogeneous ABL and near-wall treatment", Atmos. Environ., 77, 568-578. https://doi.org/10.1016/j.atmosenv.2013.05.034
  2. Ai, Z.T. and Mak, C.M. (2015), "Large-eddy Simulation of flow and dispersion around an isolated building: Analysis of influencing factors", Comput. Fluids, 118, 89-100. https://doi.org/10.1016/j.compfluid.2015.06.006
  3. Bazdidi-Tehrani, F., Ghafouri, A. and Jadidi, M. (2013), "Grid resolution assessment in large eddy simulation of dispersion around an isolated cubic building", J. Wind Eng. Ind. Aerod., 121, 1-15. https://doi.org/10.1016/j.jweia.2013.07.003
  4. CEDVAL Database (2006), Hamburg University. http://mi.uni-hamburg.de/Data-Sets.432.0.html.
  5. FLUENT (2006), FLUENT 6.3 version. Fluent User's Guide. Fluent Incorporated.
  6. Gao, Y. and Chow, W.K. (2005), "Numerical studies on air flow around a cube", J. Wind Eng. Ind. Aerod., 93, 115-135. https://doi.org/10.1016/j.jweia.2004.11.001
  7. Irtaza, H., Beale, R.G., Godley, M.H.R. and Jameel, A. (2013), "Comparison of wind pressure measurements on Silsoe experimental building from full-scale observation, wind-tunnel experiments and various CFD techniques", Int. J. Eng. Sci. Technol., 5(1), 28-41.
  8. Joubert, E.C., Harms, T.M. and Venter, G. (2015), "Computational simulation of the turbulent flow around a surface mounted rectangular prism", J. Wind Eng. Ind. Aerod., 142, 173-187. https://doi.org/10.1016/j.jweia.2015.03.019
  9. Lien, F.S., Yee, E. and Cheng, Y. (2004), "Simulation of mean flow and turbulence over a 2D building array using high-resolution CFD and a distributed drag force approach", J. Wind Eng. Ind. Aerod., 92, 117-158. https://doi.org/10.1016/j.jweia.2003.10.005
  10. Mavroidis, I., Andronopoulos, S., Venetsanos, A. and Bartzis, J.G. (2015), "Numerical investigation of concentrations and concentration fluctuations around isolated obstacles of different shapes. Comparison with wind tunnel results", Environ. Fluid Mech., 15, 999-1034. https://doi.org/10.1007/s10652-015-9394-3
  11. Mochida, A., Tominaga, Y., Murakami, S., Yoshie, R., Ishihara, T. and Ooka, R. (2002), "Comparison of various $k-{\epsilon}$ models and DSM applied to flow around a high-rise building -report on AIJ cooperative project for CFD prediction of wind environment", Wind Struct., 5(2-4), 227-244. https://doi.org/10.12989/was.2002.5.2_3_4.227
  12. Nitatwichit, C., Khunatorn, Y. and Tippayawong, N. (2008), "Computational analysis and visualization of wind-driven naturally ventilated flows around a school building", Maejo Int. J. Sci.Technol., 2(1), 240-254.
  13. Ntinas, G.K., Zhangb, G., Fragos, V.P., Bochtis, D.D. and Nikita-Martzopoulou, C.H. (2014), "Airflow patterns around obstacles with arched and pitched roofs: Wind tunnel measurements and direct simulation", Eur. J. Mech. B/Fluids, 43, 216-229. https://doi.org/10.1016/j.euromechflu.2013.09.004
  14. Ozmen, Y., Baydar, E. and van Beeck, J.P.A.J. (2016), "Wind flow over the low-rise building models with gabled roofs having different pitch angles", Build. Environ., 95, 63-74.
  15. Shao, J., Liu, J. and Zhao, J. (2012), "Evaluation of various non-linear $k-{\epsilon}$ models for predicting wind flow around an isolated high-rise building within the surface boundary layer", Buildi. Environ., 57, 145-155. https://doi.org/10.1016/j.buildenv.2012.04.018
  16. Tominaga, Y. and Stathopoulos, T. (2009), "Numerical simulation of dispersion around an isolated cubic building: Comparison of various types of $k-{\epsilon}$ models", Atmos. Environ., 43, 3200-3210. https://doi.org/10.1016/j.atmosenv.2009.03.038
  17. Tominaga, Y., Akabayashi, S.I., Kitahara, T. and Arinami, Y. (2015), "Air flow around isolated gable-roof buildings with different roof pitches: Wind tunnel experiments and CFD simulations", Build. Environ., 84, 204-213.
  18. Tsuchiya, M., Murakami, S., Mochida, A., Kondo, K. and Ishida, Y. (1997), "Development of a new $k-{\epsilon}$ model for flow and pressure fields around bluff body", J. Wind Eng. Ind. Aerod., 67-68, 169-182. https://doi.org/10.1016/S0167-6105(97)00071-8
  19. Vardoulakis, S., Dimitrova, R., Richards, K., Hamlin, D., Camilleri, G., Weeks, M., et al. (2011), "Numerical model inter-comparison for wind flow and turbulence around single-block buildings", Environ. Model. Assess., 16, 169-181.
  20. Yazid, A.W.M. and Sidik, N.A.C. (2013), "Prediction of the flow around a surface-mounted cube using two-equation turbulence models", Appl. Mech. Mater., 315, 438-442. https://doi.org/10.4028/www.scientific.net/AMM.315.438

피인용 문헌

  1. Validation of the numerical simulations of flow around a scaled-down turbine using experimental data from wind tunnel vol.29, pp.6, 2017, https://doi.org/10.12989/was.2019.29.6.405
  2. Effect of aerodynamic modifications on the surface pressure patterns of buildings using proper orthogonal decomposition vol.32, pp.3, 2017, https://doi.org/10.12989/was.2021.32.3.227