Computers and Concrete

  • 제20권6호
  • /
  • Pages.663-670
  • /
  • 2017
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Unified equivalent frame method for post-tensioned flat plate slab structures

  • Choi, Seung-Ho (Department of Architectural Engineering, University of Seoul) ;
  • Lee, Deuck Hang (Department of Civil Engineering, Nazarbayev University) ;
  • Oh, Jae-Yuel (Department of Architectural Engineering, University of Seoul) ;
  • Kim, Kang Su (Department of Architectural Engineering, University of Seoul) ;
  • Lee, Jae-Yeon (Division of Architecture, Mokwon University) ;
  • Lee, Kang Seok (School of Architecture, Chonnam National University)
  • 투고 : 2017.07.21
  • 심사 : 2017.09.02
  • 발행 : 2017.12.25
⟨ 이전 논문 다음 논문 ⟩

초록

The post-tensioned (PT) flat plate slab system is commonly used in practice, and this simple and fast construction method is also considered to be a very efficient method because it can provide excellent deflection and crack control performance under a service load condition and consequently can be advantageous when applying to long-span structures. However, a detailed design guideline for evaluating the lateral behavior of the PT flat plate slab system is not available in current design codes. Thus, typical design methods used for conventional reinforced concrete (RC) flat plate slab structures have inevitably been adopted in practice for the lateral load design of PT flat plate structures. In the authors' previous studies, the unified equivalent frame method (UEFM) was proposed, which considers the combined effect of gravity and lateral loads for the lateral behavior analysis of RC flat plate slab structures. The aim of this study is to extend the concept of the UEFM to the lateral analysis of PT flat plate slab structures. In addition, the stiffness reduction factors of torsional members on interior and exterior equivalent frames were newly introduced considering the effect of post-tensioning. Test results of various PT flat plate slab-column connection specimens were collected from literature, and compared to the analysis results estimated by the extended UEFM.

키워드

과제정보

연구 과제 주관 기관 : National Research Foundation of Korea (NRF)

참고문헌

  1. ACI Committee 318 (2014), Building Code Requirements for Structural Concrete and Commentary (ACI 318-14), American Concrete Institute, Farmington Hills, Michigan, U.S.A.
  2. Cano, M.T. and Kilngner, R.E. (1988), "Comparison of analysis procedures for tow-way slabs", ACI Struct. J., 85(6), 597-608.
  3. Choi, K.K. and Park, H.G. (2003), "Moment-rotation relationship and effective stiffness of flat plates under lateral load", J. Kor. Concrete Inst., 15(6), 856-865. https://doi.org/10.4334/JKCI.2003.15.6.856
  4. Choi, S.H., Lee, D.H., Oh, J.Y., Kim, K.S., Lee, J.Y. and Shin, M.S. (2014), "Unified equivalent frame method for flat plate slab structures under combined gravity and lateral loads-part 2: Verification", Earthq. Struct., 7(5), 735-751. https://doi.org/10.12989/eas.2014.7.5.735
  5. Corley, W.G. and Jirsa, J.O. (1970), "Equivalent frame analysis for slab design", ACI J. Proc., 67(11), 875-884.
  6. Gayed, R.B. and Ghali, A. (2006), "Seismic-resistant joints of interior columns with prestressed slabs", ACI Struct. J., 103(5), 710-719.
  7. Ghobarah, A. (2001), "Performance-based design in earthquake engineering: State of development", Eng. Struct., 23(8), 878-884. https://doi.org/10.1016/S0141-0296(01)00036-0
  8. Gorkem, S.E. and Husem, M. (2013), "Load capacity of high-strength reinforced concrete slabs by yield line theory", Comput. Concrete, 12(6), 819-829. https://doi.org/10.12989/cac.2013.12.6.819
  9. Han, S.W., Kee, S.H., Park, Y.M., Lee, L.H. and Kang, T.H.K. (2006), "Hysteretic behavior of exterior post-tensioned flat plate connections", Eng. Struct., 28(14),1983-1996. https://doi.org/10.1016/j.engstruct.2006.03.029
  10. Hegger, J., Sherif, A.G., Kueres, D. and Siburg, C. (2017). "Efficiency of various puching shear reinforcement systems for flat slabs", ACI Struct. J., 114(3), 631-642.
  11. Hwang, J.H., Lee, D.H., Park, M.K., Choi, S.H., Kim, K.S. and Pan, Z. (2015), "Shear performance assessment of steel fiber reinforced-prestressed concrete members", Comput. Concrete, 16(6), 825-846. https://doi.org/10.12989/cac.2015.16.6.825
  12. Hwang, S.J. and Moehle, J.P. (1993), An Experimental Study of Flat-Plate Structures under Vertical and Lateral Loads, Report No. UCB/EERC-93/03, University of California, Berkeley, California, U.S.A.
  13. Hwang, S.J. and Moehle, J.P. (2000), "Models for laterally loaded slab-column frames", ACI Struct. J., 97(2), 345-352.
  14. Kang, S.M., Eom, T.S. and Kim, J.Y. (2013), "Reshoring effects on deflection of multi-shored flat plate systems under construction", Struct. Eng. Mech., 45(4), 455-470. https://doi.org/10.12989/sem.2013.45.4.455
  15. Kang, T.H.K. (2004), "Shake table tests and analytical studies of reinforced and post-tensioned concrete flat plate frames", Ph.D. thesis, University of California, California, U.S.A.
  16. Karimiyan, S., Kashan, A.H. and Karimiyan, M. (2014), "Progressive collapse vulnerability in 6-Story RC symmetric and asymmetric buildings under earthquake loads", Earthq. Struct., 6(5), 473-494. https://doi.org/10.12989/eas.2014.6.5.473
  17. KCI-M-12 (2012), Design Specifications for Concrete Structures, Korea Concrete Institute, Korea.
  18. Kee, S.H., Han, S.W., Ha, S.S., Cho, K.H. and Lee, L.H. (2006), "Cyclic behavior of interior joints in post tensioned flat plate slab systems", J. Archit. Inst. Kor., 22(4), 39-46.
  19. Kim, H.S. and Lee, D.G. (2005), "Efficient analysis of flat slab structures subjected to lateral loads", Eng. Struct., 27(2), 251-263. https://doi.org/10.1016/j.engstruct.2004.10.005
  20. Kim, J.Y. and Kang, S.M. (2017), "Simulations of short-and long-term deflections of flat plates considering effects of construction sequences", Struct. Eng. Mech., 62(4), 477-485. https://doi.org/10.12989/sem.2017.62.4.477
  21. Kim, K.S., Choi, S.H., Ju, H.J., Lee, D.H., Lee, J.Y. and Shin, M.S. (2014), "Unified equivalent frame method for flat plate slab structures under combined gravity and lateral loads-part 1: Derivation", Earthq. Struct., 7(5), 719-733. https://doi.org/10.12989/eas.2014.7.5.719
  22. Kim, U., Huang, Y., Chakrabarti, P.R. and Kang, T.H.K. (2014), "Modeling of post-tensioned one-way and two-way slabs with unbonded tendons", Comput. Concrete, 13(5), 587-601. https://doi.org/10.12989/cac.2014.13.5.587
  23. Kotsovou, G.M., Kotsovou, G.M. and Vougioukas, E. (2016), "Assessment of design methods for punching through numerical experiments", Comput. Concrete, 17(3), 305-322. https://doi.org/10.12989/cac.2016.17.3.305
  24. Kurtoglu, A.E., Cevik, A., Albegmprli, H.M., Gulsan, M.E. and Bilgehan, M. (2016), "Reliability-based modeling of punching shear capacity of FRP-reinforced two-way slabs. Kurtoglu", Comput. Concrete, 17(1), 87-106. https://doi.org/10.12989/cac.2016.17.1.087
  25. Kwon, N.H., Lee, S.I. and Cho, Y.S. (2007), "Hysteretic behavior of interior column Cconnections with post-tensioned flat plate slab designed for gravity system under lateral load", J. Archit. Inst. Kor., 23(7), 61-68.
  26. Lee, D.H., Park, M.K., Oh, J.Y., Kim, K.S., Im, J.H. and Seo, S.Y. (2014), "Web-shear capacity of prestressed hollow-core slab unit with consideration on the minimum shear reinforcement requirement", Comput. Concrete, 14(3), 211-231. https://doi.org/10.12989/cac.2014.14.3.211
  27. Mirzaei, Y. and Sasani, M. (2013), "Progressive collapse resistance of flat slabs: Modeling post-punching behavior", Comput. Concrete, 12(3), 351-375. https://doi.org/10.12989/cac.2013.12.3.351
  28. Mohammed, A.H. and Taysi, N. (2017), "Modeling of bonded and unbonded post-tensioned concrete flat slabs under flexural and thermal loading", Struct. Eng. Mech., 62(5), 595-606. https://doi.org/10.12989/SEM.2017.62.5.595
  29. Park, Y.M., Rew, Y.H. and Han, S.W. (2012), "Stiffness reduction factor for post-tensioned flat plate slabs", Mag. Concrete Res., 64(1), 83-92. https://doi.org/10.1680/macr.10.00150
  30. Park, Y.M., Han, S.W. and Kee, S.H. (2009), "A modified equivalent frame method for lateral load analysis", Mag. Concrete Res., 61(5), 359-370. https://doi.org/10.1680/macr.2008.00081
  31. Qaisrani, A.N. (1993), "Interior post-tensioned flat-plate connections subjected to vertical and biaxial lateral loading", Ph.D. Dissertation, University of California, Berkeley, California, U.S.A.
  32. Ritchie, M. and Ghali, A. (2005), "Seismic-resistant connections of edge columns with prestressed slabs", ACI Struct. J., 102(2), 314-323.
  33. Schwaighofer, J. and Collins, M.P. (1977), "Experimental study of the behavior of reinforced concrete coupling slabs", ACI J. Proc., 74(3), 123-127.
  34. Vanderbilt, M.D. (1979), "Equivalent frame analysis for lateral loads. Proceedings", ASCE J. Struct. Div., 105(ST10), 1981-1998.
  35. Vanderbilt, M.D. (1981), The Equivalent Frame Analysis for Reinforced Concrete Slabs, Structural Research Series No. 36, Civil Engineering Department, Colorado State University, Fort Collins, U.S.A.
  36. Vanderbilt, M.D. and Corley, W.G. (1983), "Frame analysis for concrete buildings", Concrete Int., 5(12), 33-43.

피인용 문헌

  1. Experimental study of punching shear in post-tensioned slabs with unbonded tendons vol.79, pp.4, 2017, https://doi.org/10.12989/sem.2021.79.4.507