DOI QR코드

DOI QR Code

Microstructure and Characterization of Ni-C Films Fabricated by Dual-Source Deposition System

  • Han, Chang-Suk (Department of Defense Science & Technology, Hoseo University) ;
  • Kim, Sang-Wook (Department of Nanobiotronics, Hoseo University)
  • 투고 : 2016.03.07
  • 심사 : 2016.04.14
  • 발행 : 2016.06.27

초록

Ni-C composite films were prepared by co-deposition using a combined technique of plasma CVD and ion beam sputtering deposition. Depending on the deposition conditions, Ni-C thin films manifested three kinds of microstructure: (1) nanocrystallites of non-equilibrium carbide of nickel, (2) amorphous Ni-C film, and (3) granular Ni-C film. The electrical resistivity was also found to vary from about $10^2{\mu}{\Omega}cm$ for the carbide films to about $10^4{\mu}{\Omega}cm$ for the amorphous Ni-C films. The Ni-C films deposited at ambient temperatures showed very low TCR values compared with that of metallic nickel film, and all the films showed ohmic characterization, even those in the amorphous state with very high resistivity. The TCR value decreased slightly with increasing of the flow rate of $CH_4$. For the films deposited at $200^{\circ}C$, TCR decreased with increasing $CH_4$ flow rate; especially, it changed sign from positive to negative at a $CH_4$ flow rate of 0.35 sccm. By increasing the $CH_4$ flow rate, the amorphous component in the film increased; thus, the portion of $Ni_3C$ grains separated from each other became larger, and the contribution to electrical conductivity due to thermally activated tunneling became dominant. This also accounts for the sign change of TCR when the filme was deposited at higher flow rate of $CH_4$. The microstructures of the Ni-C films deposited in these ways range from amorphous Ni-C alloy to granular structures with $Ni_3C$ nanocrystallites. These films are characterized by high resistivity and low TCR values; the electrical properties can be adjusted over a wide range by controlling the microstructures and compositions of the films.

키워드

참고문헌

  1. J. Keczkowska, Central Euro. J. Phys., 9, 330 (2011).
  2. C. S. Han, C. H. Chun and S. O. Han, J. Korean Soc. Heat Treat., 21, 235 (2008).
  3. L. I. Kveglis and V. S. Zhigalov, Surf. Sci., 601, 2873 (2007). https://doi.org/10.1016/j.susc.2006.12.044
  4. R. Tang, M. Mizuguchi, H. Wang, R. Yu and K. Takanashi, IEEE Trans. Mag., 46, 2144 (2010). https://doi.org/10.1109/TMAG.2010.2043340
  5. K. H. Tan, R. Ahmad and M. R. Johan, Mater. Chem. Phys., 139, 66 (2013). https://doi.org/10.1016/j.matchemphys.2012.12.006
  6. Z. B. Wang, C. R. Zhao, P. F. Shi, Y. S. Yang, Z. B. Yu, W. K. Wang and G. P. Yin, J. Phys. Chem. C, 114, 672 (2010). https://doi.org/10.1021/jp909022j
  7. C. Sella, M. Kaabouchi, R. Krishnan and M. Naili, Vacuum, 41, 1247 (1990). https://doi.org/10.1016/0042-207X(90)93924-8
  8. S. Tajima and S. I. Hirano, J. Mater. Sci. Lett., 11, 22 (1992). https://doi.org/10.1007/BF00720770
  9. R. Kravietz, B. Wehner, T. Sebald, H. Mai and R. Dietsch, Mater. Sci. Forum, 166-169, 331 (1994). https://doi.org/10.4028/www.scientific.net/MSF.166-169.331
  10. H. M. Strong and R. E. Hanneman, J. Chem. Phys., 469, 3668 (1967).
  11. A. Inoue, S. Furukawa and T. Matumoto, J. Mater. Sci., 22, 1670 (1987). https://doi.org/10.1007/BF01132390
  12. B. Abeles, P. Sheng, M. D. Coutts and Y. Arie, Adv. Phys., 24, 407 (1975). https://doi.org/10.1080/00018737500101431