참고문헌
- Alexandrov, S. and Harris, D. (2006), "Comparison of solution behaviour for three models of pressuredependent plasticity: a simple analytical example", Int. J. Mech. Sci., 48(7), 750-762. https://doi.org/10.1016/j.ijmecsci.2006.01.009
- Alexandrov, S. and Mishuris, G. (2009), "Qualitative behaviour of viscoplastic solutions in the vicinity of maximum-friction surfaces", J. Eng. Math., 65(2), 143-156. https://doi.org/10.1007/s10665-009-9277-z
- Deshpande, V.S. and Fleck, N.A. (2001), "Multi-axial yield behaviour of polymer foams", Acta Materialia, 49, 1859-1866. https://doi.org/10.1016/S1359-6454(01)00058-1
- Harren, S.V. (1995), "Toward a new phenomenological flow rule for orientationally hardening glassy polymers", J. Mech. Phys. Solid., 43(7), 1151-1171. https://doi.org/10.1016/0022-5096(95)00025-E
- Harren, S.V. (1997), "A yield surface and flow rule for orientationally hardening polymers subjected to arbitrary deformations", J. Mech. Phys. Solid., 45(1), 1-20. https://doi.org/10.1016/S0022-5096(96)00077-4
- Heise, R. (2016), "Friction between a temperature dependent viscoelastic body and a rough surface", Friction, 4(1), 50-64. https://doi.org/10.1007/s40544-016-0103-0
- Mills, N.J. (2010), "Deformation mechanisms and the yield surface of low-density, closed-cell polymer foams", J. Mater. Sci., 45, 5831-5843. https://doi.org/10.1007/s10853-010-4659-1
- Pantani, R., Coccorullo, I., Speranza, V. and Titomanlio, G. (2005), "Modeling of morphology evolution in the injection molding process of thermoplastic polymers", Prog. Polym. Sci., 30, 1185-1222. https://doi.org/10.1016/j.progpolymsci.2005.09.001
- Raghava, R., Caddell, R.M. and Yeh, G.S.Y. (1973), "The macroscopic yield behaviour of polymers", J. Mater. Sci., 8, 225-232. https://doi.org/10.1007/BF00550671
- Spitzig, W.A. and Richmond, O. (1979), "Effect of hydrostatic pressure on the deformation behavior of polyethylene and polycarbonate in tension and in compression", Polym. Eng. Sci., 19(16), 1129-1139. https://doi.org/10.1002/pen.760191602
- Viana, J.C. (2004), "Development of the skin layer in injection moulding: phenomenological model", Polym., 45, 993-1005. https://doi.org/10.1016/j.polymer.2003.12.001
피인용 문헌
- Solution Behavior near Envelopes of Characteristics for Certain Constitutive Equations Used in the Mechanics of Polymers vol.12, pp.17, 2016, https://doi.org/10.3390/ma12172725