Advances in concrete construction

  • 제4권3호
  • /
  • Pages.221-230
  • /
  • 2016
  • /
  • 2287-5301(pISSN)
  • /
  • 2287-531X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Partial replacement of fine aggregates with laterite in GGBS-blended-concrete

  • Karra, Ram Chandar (Department of Mining Engineering, National Institute of Technology Karnataka) ;
  • Raghunandan, Mavinakere Eshwaraiah (Civil Engineering Discipline, School of Engineering, Monash University Malaysia) ;
  • Manjunath, B. (Department of Civil Engineering, National Institute of Technology Karnataka)
  • 투고 : 2016.08.20
  • 심사 : 2016.12.26
  • 발행 : 2016.09.25
⟨ 이전 논문 다음 논문 ⟩

초록

This paper presents a preliminary study on the influence of laterite soil replacing conventional fine aggregates on the strength properties of GGBS-blended-concrete. For this purpose, GGBS-blended-concrete samples with 40% GGBS, 60% Portland cement (PC), and locally available laterite soil was used. Laterite soils at 0, 25, 50 and 75% by weight were used in trails to replace the conventional fine aggregates. A control mix using only PC, river sand, course aggregates and water served as bench mark in comparing the performance of the composite concrete mix. Test blocks including 60 cubes for compression test; 20 cylinders for split tensile test; and 20 beams for flexural strength test were prepared in the laboratory. Results showed decreasing trends in strength parameters with increasing laterite content in GGBS-blended-concrete. 25% and 50% laterite replacement showed convincing strength (with small decrease) after 28 day curing, which is about 87-90% and 72-85% respectively in comparison to that achieved by the control mix.

키워드

과제정보

연구 과제 주관 기관 : National Institute of Technology Karnataka, Monash University Malaysia

참고문헌

  1. Adepegba, D. (1975), "A comparative study of normal concrete with concrete which contained laterite instead of sand", Build. Sci., 10(2), 135-141. https://doi.org/10.1016/0007-3628(75)90029-8
  2. Balogun, L.A. and Adepegba, D. (1982), "Effect of varying sand content in laterized concrete", Int. J. Cement Compos. Lightw. Concrete, 4(4), 235-240. https://doi.org/10.1016/0262-5075(82)90027-6
  3. Binici, H. (2007), "Effect of crushed ceramic and basaltic pumice as fine aggregates on concrete mortars properties", Constr. Build. Mater., 21(6), 1191-1197. https://doi.org/10.1016/j.conbuildmat.2006.06.002
  4. Cheng, A., Huang, R., Wu, J.K. and Chen, C.H. (2005), "Influence of GGBS on durability and corrosion behavior of reinforced concrete", Mater. Chem. Phys., 93(2-3), 404-411. https://doi.org/10.1016/j.matchemphys.2005.03.043
  5. Chore, H.S. and Joshi, M.P. (2015), "Strength evaluation of concrete with fly ash and GGBFS as cement replacing materials", Adv. Concrete Constr., 3(3), 223-236. https://doi.org/10.12989/acc.2015.3.3.223
  6. Babu, K.G. and Kumar, V.S.R. (2000), "Efficiency of GGBS in concrete", Cement Concrete Res., 30(7), 1031-1036. https://doi.org/10.1016/S0008-8846(00)00271-4
  7. Hogan, F. and Meusel, J. (1981), "Evaluation for durability and strength development of a ground granulated blast furnace slag", Cement, Concrete Aggreg., 3(1), 40-52. https://doi.org/10.1520/CCA10201J
  8. Ismail, Z.Z. and Al-Hashmi, E.A. (2009), "Recycling of waste glass as a partial replacement for fine aggregate in concrete", Waste Manage., 29(2), 655-659. https://doi.org/10.1016/j.wasman.2008.08.012
  9. Khan, S.U., Nuruddin, M.F., Ayub, T. and Shafiq, N. (2014), "Effects of different mineral admixtures on the properties of fresh concrete", The Sci. World J., Article ID: 986567.
  10. Lasisi, F., Ajayi, E.O. and Osunade, J.A. (1984), "Technical notes: Strength characteristics of lateritecement mortars", Int. J. Cement Compos. Lightw. Concrete, 6(3), 201-203. https://doi.org/10.1016/0262-5075(84)90009-5
  11. Manjunath, B. (2015), "Experimental investigations on the use of laterite waste as partial replacement for fine aggregates in GGBS blended concrete", MTech Thesis, Department of Civil Engineering, National Institute of Technology Karnataka, Suratkal, India.
  12. Marinkovic, S., Radonjanin, V., Malesev, M. and Ignjatovic, I. (2010), "Comparative environmental assessment of natural and recycled aggregate concrete", Waste Manage., 30(11), 2255-2264. https://doi.org/10.1016/j.wasman.2010.04.012
  13. Oner, A. and Akyuz, S. (2007), "An experimental study on optimum usage of GGBS for the compressive strength of concrete", Cement Concrete Compos., 29(6), 505-514. https://doi.org/10.1016/j.cemconcomp.2007.01.001
  14. Sakai, K. (2005), "Environmental design for concrete structures", J. Adv. Concrete Technol., 3(1), 17-28. https://doi.org/10.3151/jact.3.17
  15. Shaikh, F.U.A. (2014), "Effects of alkali solutions on corrosion durability of geopolymer concrete", Adv. Concrete Constr., 2(2), 109-123. https://doi.org/10.12989/acc.2014.2.2.109
  16. Sunil, B.M., Manjunatha, L.S., Ravi, L. and Yaragal, S.C. (2015), "Potential use of mine tailings and fly ash in concrete", Adv. Concrete Constr., 3(1), 55-69. https://doi.org/10.12989/acc.2015.3.1.055
  17. Terro, M.J. (2006), "Properties of concrete made with recycled crushed glass at elevated temperatures", Build. Environ., 41(5), 633-639. https://doi.org/10.1016/j.buildenv.2005.02.018
  18. Udoeyo, F.F., Iron, U.H. and Odim, O.O. (2006), "Strength performance of laterized concrete", Constr. Build. Mater., 20(10), 1057-1062. https://doi.org/10.1016/j.conbuildmat.2005.03.002
  19. Van Oss, H.G. and Padovani, A.C. (2003), "Cement manufacture and the environment, Part II: Environmental challenges and opportunities", J. Industr. Ecology, 7(1), 93-126. https://doi.org/10.1162/108819803766729212

피인용 문헌

  1. Experimental investigation for partial replacement of fine aggregates in concrete with sandstone vol.4, pp.4, 2016, https://doi.org/10.12989/acc.2016.4.4.243
  2. A study on suitability of iron ore overburden waste rock for partial replacement of coarse aggregates in concrete pavements vol.431, pp.1757-899X, 2018, https://doi.org/10.1088/1757-899X/431/10/102012
  3. Mechanical properties of blended cements at elevated temperatures predicted using a fuzzy logic model vol.20, pp.2, 2017, https://doi.org/10.12989/cac.2017.20.2.247
  4. Sustainable use of mine waste and tailings with suitable admixture as aggregates in concrete pavements-A review vol.6, pp.3, 2016, https://doi.org/10.12989/acc.2018.6.3.221
  5. Effect of accelerators with waste material on the properties of cement paste and mortar vol.22, pp.2, 2016, https://doi.org/10.12989/cac.2018.22.2.153
  6. Experimental investigations on performance of concrete incorporating Precious Slag Balls (PS Balls) as fine aggregates vol.8, pp.3, 2016, https://doi.org/10.12989/acc.2019.8.3.239
  7. Experimental and Statistical Evaluations of Strength Properties of Concrete with Iron Ore Tailings as Fine Aggregate vol.24, pp.1, 2016, https://doi.org/10.1061/(asce)hz.2153-5515.0000480