Smart Structures and Systems

  • 제16권5호
  • /
  • Pages.835-851
  • /
  • 2015
  • /
  • 1738-1584(pISSN)
  • /
  • 1738-1991(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Assessment of temperature effect in structural health monitoring with piezoelectric wafer active sensors

  • Kamas, Tuncay (Department of Mechanical Engineering, Eskisehir Osmangazi University, Meselik Campus) ;
  • Poddar, Banibrata (Department of Mechanical Engineering, University of South Carolina) ;
  • Lin, Bin (Department of Mechanical Engineering, University of South Carolina) ;
  • Yu, Lingyu (Department of Mechanical Engineering, University of South Carolina)
  • 투고 : 2015.03.02
  • 심사 : 2015.04.30
  • 발행 : 2015.11.25
⟨ 이전 논문 다음 논문 ⟩

초록

This paper presents theoretical and experimental evaluation of the structural health monitoring (SHM) capability of piezoelectric wafer active sensors (PWAS) at elevated temperatures. This is important because the technologies for structural sensing and monitoring need to account for the thermal effect and compensate for it. Permanently installed PWAS transducers have been One of the extensively employed sensor technologies for in-situ continuous SHM. In this paper, the electro-mechanical impedance spectroscopy (EMIS) method has been utilized as a dynamic descriptor of PWAS behavior and as a high frequency standing wave local modal technique. Another SHM technology utilizes PWAS as far-field transient transducers to excite and detect guided waves propagating through the structure. This paper first presents how the EMIS method is used to qualify and quantify circular PWAS resonators in an increasing temperature environment up to 230 deg C. The piezoelectric material degradation with temperature was investigated and trends of variation with temperature were deduced from experimental measurements. These effects were introduced in a wave propagation simulation software called Wave Form Revealer (WFR). The thermal effects on the substrate material were also considered. Thus, the changes in the propagating guided wave signal at various temperatures could be simulated. The paper ends with summary and conclusions followed by suggestions for further work.

키워드

과제정보

연구 과제 주관 기관 : National Science Foundation, Department of Energy NEUP

참고문헌

  1. Baptista, F.G., Budoya, D.E., De Almeida, V.A.D. and Ulson, J.A.C. (2014), "An experimental study on the effect of temperature on piezoelectric sensors for impedance-based structural health monitoring", Sensors, 1208-1227. http://doi.org/10.3390/s140101208
  2. Chen, J., Young, B. and Uy, B. (2006), "Behavior of high strength structural steel at elevated temperatures", J. Struct. Eng.-ASCE, 132(12), 1948-1954. http://doi.org/10.1061/(ASCE)0733-9445(2006)132:12(1948)
  3. Defence, U.D. (1998), Metallic materials and elements for aerospace vehicle structures (Military H), USA, Department of Defence.
  4. Giurgiutiu, V. (2010), "Development and testing of high-temperature piezoelectric wafer active sensors for extreme environments", Struct. Health Monit., 9(6), 513-525. http://doi.org/10.1177/1475921710365389
  5. Giurgiutiu, V., Bao, J. and Zhao, W. (2001), "Active sensor wave propagation health monitoring of beam and plate structures", Proceedings of the SPIE's 8th International Symposium on Smart Structures and Materials. Newport Beach, CA.
  6. Giurgiutiu, V., Zagrai, A. and Jing Bao, J. (2002), "Piezoelectric wafer embedded active sensors for aging aircraft structural health monitoring", Struct. Health Monit., 1(1), 41-61. http://doi.org/10.1177/147592170200100104
  7. Giurgiutiu, V. and Zagrai, A. (2000), "Damage detection in simulated aging-aircraft panels using the electro-mechanical impedance technique", Proceedings of the Adaptive Structures and Material Systems Symposium, ASME Winter Annual Meeting, Orlando, FL.
  8. Hill, W.H. and Shimmin, K.D. (1961), Elevated temperature dynamic elastic moduli of various metallic materials.
  9. Hodge, A.W. and Maykuth, D.J. (1968), Properties of new high temperature Titanium alloys, DMIC Memo.
  10. Hooker, M.W. (1998), Properties of PZT-Based Piezoelectric Ceramics Between-150 and 250 C. Hampton, Virginia.
  11. Kamas, T. (2014), Behavior of Piezoelectric Wafer Active Sensor in Various Media. University of South Carolina.
  12. Kamas, T., Frankforter, E., Lin, B., Yu, L. and Giurgiutiu, V. (2015). "Thermal effect on E/M impedance spectroscopy of piezoelectric wafer active sensors", Proceedings of thSPIE 2015 Smart Structure/NDE, San Diego, CA.
  13. Lees, C.H., Andrews, P. and Shave, L.S. (1924), "The variation of Young's modulus at high temperatures", Proceedings of the Physc. Soc., London.
  14. Liang, C., Sun, F.P. and Rogers, C.A. (1994), "Coupled electro-mechanical analysis of adaptive material systems--determination of the actuator power consumption and system energy transfer", J. Intel. Mat. Sys. Str., 5(1), 12-20. http://doi.org/10.1177/1045389X9400500102
  15. Lin, B. and Giurgiutiu, V. (2010), "Modeling of power and energy transduction of embedded piezoelectric wafer active sensors for structural health monitoring", 7981, 76472P-76472P-12. http://doi.org/10.1117/12.880120
  16. Lipski, A. and Mrozinski, S. (2012), "The effects of temperature on the strength properties of aluminum alloy 2024-T3", Acta Mech. Autom., 6(3), 62-66.
  17. Raghavan, A. and Cesnik, C.E.S. (2008), "Effects of elevated temperature on guided-wave structural health monitoring", J. Intel. Mat. Syst. Str., 19(12), 1383-1398. http://doi.org/10.1177/1045389X07086691
  18. Santoni-Bottai, G. and Giurgiutiu, V. (2012), "Damage detection at cryogenic temperatures in composites using piezoelectric wafer active sensors", Struct. Health Monit., 11(5), 510-525. http://doi.org/10.1177/1475921712442441
  19. Shen, Y. (2014), Structural Health Monitoring Using Linear and Nonlinear Ultrasonic Guided Waves. University of South Carolina.
  20. Sun, F.P., Liang, C. and Rogers, C.A. (1994), "Structural modal analysis using collocated piezoelectric actuator/sensors: an electromechanical approach", Proceedings of the SPIE 2190, Smart Structures and Materials 1994: Smart Structures and Intelligent Systems, Orlando, FL.
  21. Wolf, R.A. (2004), "Temperature dependence of the piezoelectric response in lead zirconate titanate films", J. Appl. Phys., 95(3), 1397. http://doi.org/10.1063/1.1636530
  22. Xu, D., Banerjee, S., Wang, Y., Huang, S. and Cheng, X. (2015), "Temperature and loading effects of embedded smart piezoelectric sensor for health monitoring of concrete structures", Constr. Build. Mater., 76, 187-193. http://doi.org/10.1016/j.conbuildmat.2014.11.067
  23. Yost, W. T., Macias, B.R., Cao, P., Hargens, A.R. and Ueno, T. (2005), "System for determination of ultrasonic wave speeds and their temperature dependence in liquids and in vitro tissues", J. Acoust. Soc. Am., Retrieved from http://www.ncbi.nlm.nih.gov/pubmed/15759685
  24. Zagrai, A.N. (2002), Piezoelectric wafer active sensor electro-mechanical impedance structural health monitoring, University of South Carolina, Retrieved from http://onlinelibrary.wiley.com/doi/10.1002/cbdv.200490137/abstract
  25. Zagrai, A.N. and Giurgiutiu, V. (2001), Electro-Mechanical Impedance Method for Damage Identification in Circular Plates, 40.

피인용 문헌

  1. A temperature compensation methodology for piezoelectric based sensor devices vol.111, pp.8, 2017, https://doi.org/10.1063/1.4991074
  2. Irreversibility effects in piezoelectric wafer active sensors after exposure to high temperature vol.26, pp.9, 2017, https://doi.org/10.1088/1361-665X/aa785f
  3. Practical issues related to the application of piezoelectric based wave propagation technique in monitoring of concrete curing vol.152, 2017, https://doi.org/10.1016/j.conbuildmat.2017.06.163
  4. Experimental investigation for an isolation technique on conducting the electromechanical impedance method in high-temperature pipeline facilities vol.383, 2016, https://doi.org/10.1016/j.jsv.2016.07.036
  5. Feature extraction approach insensitive to temperature variations for impedance-based structural health monitoring pp.1751-8830, 2019, https://doi.org/10.1049/iet-smt.2018.5226
  6. Effects of Gamma Radiation on Resonant and Antiresonant Characteristics of Piezoelectric Wafer Active Sensors vol.2, pp.1, 2015, https://doi.org/10.1115/1.4041068
  7. Temperature Effects on Electromechanical Response of Deposited Piezoelectric Sensors Used in Structural Health Monitoring of Aerospace Structures vol.19, pp.12, 2019, https://doi.org/10.3390/s19122805
  8. Temperature effect on electromechanical admittance-based concrete structural health monitoring vol.19, pp.3, 2020, https://doi.org/10.1177/1475921719860397
  9. Investigation on modulation of multi-frequency ultrasonic waves in structures with quadratic nonlinearity vol.28, pp.1, 2021, https://doi.org/10.12989/sss.2021.28.1.043
  10. Experimental Study on Impedance-Based Damage Detection Considering Temperature Effect vol.21, pp.5, 2015, https://doi.org/10.9798/kosham.2021.21.5.1