DOI QR코드

DOI QR Code

The bearing capacity of square footings on a sand layer overlying clay

  • 투고 : 2014.09.03
  • 심사 : 2015.04.21
  • 발행 : 2015.09.25

초록

The ultimate bearing capacity and failure mechanism of square footings resting on a sand layer over clay soil have been investigated numerically by performing a series of three-dimensional non-linear finite element analyses. The parameters investigated are the thickness of upper sand layer, strength of sand, undrained shear strength of lower clay and surcharge effect. The results obtained from finite element analyses were compared with those from previous design methods based on limit equilibrium approach. The results proved that the parameters investigated had considerable effect on the ultimate bearing capacity and failure mechanism occurring. It was also shown that the thickness of upper sand layer, the undrained shear strength of lower clay and the strength of sand are the most important parameters affecting the type of failure will occur. The value of the ultimate bearing capacity could be significantly different depending on the limit equilibrium method used.

키워드

참고문헌

  1. Akpila, S.B. (2007), "The design of a shallow foundation on sand overlying soft clay", Inter-World J. Sci. Technol., 3(3), 21-26.
  2. Amar, S., Baguelin, F., Canepa, Y. and Frank, R. (1994), "Experimental study of the settlement of shallow foundations", Geot. Spec. Pub., ASCE, 40(2), 1602-1610.
  3. Bandini, P. and Pham, H.V. (2011), "Bearing capacity of embedded strip footings in two-layered clay soils", Geo-Frontiers 2011, 332-341.
  4. Baglioni, V.P., Chow, G.S. and Endley, S.N. (1982), "Jack-up foundation stability in stratified soil profiles", Proceedings of the 14th Offshore Technology Conference, Houston, TX, USA, May, Volume 4, pp.363-369.
  5. Benmebarek, S., Benmoussa, S., Belounar, L. and Benmebarek, N. (2012), "Bearing capacity of shallow foundation on two clay layers by numerical approach", Geotech. Geol. Eng., 30(4), 907-923. https://doi.org/10.1007/s10706-012-9513-6
  6. Briaud, J-L. and Jeanjean, P. (1994), "Load settlement curve method for spread footings on sand", J. Geotech. Geoenviron. Eng., 133(8), 905-920. https://doi.org/10.1061/(ASCE)1090-0241(2007)133:8(905)
  7. Burd, H.J. and Frydman, S. (1997), "Bearing capacity of plane-strain footings on layered soils", Can. Geotech. J., 34(2), 241-253. https://doi.org/10.1139/t96-106
  8. Cerato, A.B. (2005), "Scale effect of shallow foundation bearing capacity on granular material", Ph.D. Dissertation; University of Massachusetts Amherts, MA, USA.
  9. Cerato, A.B. and Lutenegger, A.J. (2007), "Scale effect of shallow foundation bearing capacity on granular material", J. Geotech. Geoenviron. Eng., 133(10), 1192-1202. https://doi.org/10.1061/(ASCE)1090-0241(2007)133:10(1192)
  10. Florkiewicz, A. (1989), "Upper bound to bearing capacity of layered soils", Can. Geotech. J., 26(4), 730-736. https://doi.org/10.1139/t89-084
  11. Gourvenec, S., Randolph, M. and Kingsnorth, O. (2006), "Undrained bearing capacity of square and rectangular footings", Int. J. Geomech., 6(3), 147-157. https://doi.org/10.1061/(ASCE)1532-3641(2006)6:3(147)
  12. Hanna, A.M. (1981), "Foundations on strong sand overlying weak sand", J. Geotech. Eng. Div., 107(7), 915-927.
  13. Hanna, A.M. and Meyerhof, G.G. (1980), "Design charts for ultimate bearing capacity of foundations on sand overlying soft clay", Can. Geotech. J., 17(2), 300-303. https://doi.org/10.1139/t80-030
  14. Huang, M. and Qin, H.L. (2009), "Upper-bound multi-rigid-block solutions for bearing capacity of two-layered soils", Comput. Geotech., 36(3), 525-529. https://doi.org/10.1016/j.compgeo.2008.10.001
  15. Jahanandish, M., Veiskarami, M. and Ghahramani, A. (2010), "Effect of stress level on the bearing capacity factor, $N_{\gamma}$, by the ZEL method", KSCE J. Civil Eng., 14(5), 709-723. https://doi.org/10.1007/s12205-010-0866-1
  16. Jaky, J. (1944), "The coefficient of earth pressure at rest", J. Soc. Hungarian Archit. Eng., 78(22), 355-358.
  17. Kenny, M.J. and Andrawes, K.Z. (1997), "The bearing capacity of footings on a sand layer overlying soft clay", Geotechnique, 47(2), 339-345. https://doi.org/10.1680/geot.1997.47.2.339
  18. Kraft, L.M. and Helfrich, S.C. (1983), "Bearing capacity of shallow footing, sand over clay", Can. Geotech. J., 20(1), 182-185. https://doi.org/10.1139/t83-018
  19. Kumar, J. and Kouzer, K.M. (2007), "Effect of footing roughness on bearing capacity factor, $N_{\gamma}$", J. Geotech. Geoenviron. Eng., 133(5), 502-511. https://doi.org/10.1061/(ASCE)1090-0241(2007)133:5(502)
  20. Lavasan, A.A. and Ghazavi, M. (2012), "Behavior of closely spaced square and circular footings on reinforced sand", Soil. Found., 52(1), 160-167. https://doi.org/10.1016/j.sandf.2012.01.006
  21. Lee, J., Salgado, R. and Kim, S. (2005), "Bearing capacity of circular footings under surcharge using state-dependent finite element analysis", Comput. Geotech., 32(6), 445-457. https://doi.org/10.1016/j.compgeo.2005.07.005
  22. Merifield, R.S. and Nguyen, V.Q. (2006), "Two and three-dimensional bearing capacity solutions for footings on two-layered clays", Geomech. Geoeng.: Int. J., 1(2), 151-162. https://doi.org/10.1080/17486020600632637
  23. Merifield, R.S., Sloan, S.W. and Yu, H.S. (1999), "Rigorous plasticity solutions fort he bearing capacity of two-layered clays", Geotechnique, 49(4), 471-490. https://doi.org/10.1680/geot.1999.49.4.471
  24. Meyerhof, G.G. (1974), "Ultimate bearing capacity of footings on sand overlying clay", Can. Geotech. J., 11(2), 223-229. https://doi.org/10.1139/t74-018
  25. Michalowski, R.L. and Shi, L. (1995), "Bearing capacity of footings over two-layer foundation soils", J. Geotech. Eng., 121(5), 421-428. https://doi.org/10.1061/(ASCE)0733-9410(1995)121:5(421)
  26. Okamura, M., Takemura, J. and Kimura, T. (1997), "Centrifuge model tests on bearing capacity and deformation of sand layer overlying clay", Soil. Found., 37(1), 73-88. https://doi.org/10.3208/sandf.37.73
  27. Okamura, M., Takemura, J. and Kimura, T. (1998), "Bearing capacity predictions of sand overlying clay based on limit equilibrium methods", Soil. Found., 38(1), 181-194. https://doi.org/10.3208/sandf.38.181
  28. Plaxis 3D (2012), Delft, Netherlands.
  29. Purushothamaraj, P., Ramiah, B.K. and Rao, K.N.V. (1974), "Bearing capacity of strip footings in two layered cohesive-friction soils", Can. Geotech. J., 11(1), 32-44. https://doi.org/10.1139/t74-003
  30. Shiau, J.S., Lyamin, A.V. and Sloan, S.W. (2003), "Bearing capacity of a sand layer on clay by finite element limit analysis", Can. Geotech. J., 40(5), 900-915. https://doi.org/10.1139/t03-042
  31. Taiebat, H.A. and Carter, J.P. (2000), "Numerical studies of the bearing capacity of shallow foundations on cohesive soil subjected to combined loading", Geotechnique, 50(4), 409-418. https://doi.org/10.1680/geot.2000.50.4.409
  32. Terzaghi, K. (1943), Theoretical Soil Mechanics, Wiley, New York, NY, USA.
  33. Yamaguchi, H. (1963), "Practical formula of bearing value for two layered ground", Proceedings of the 2nd Asian Regional Conference on SMFE, Tokyo, Japan, May, Volume 1, pp. 176-180.
  34. Yamaguchi, H. and Terashi, M. (1971), "Ultimate bearing capacity of multi-layered ground", Proceedings of the 4th Asian Regional Conference on SMFE, Bangkok, Thailand, July-August, Volume 1, pp. 99-105.
  35. Yamamoto, K. and Kim, D. (2004), "Bearing capacity of spread foundations on sand overlying clay", Lowland Technol. Int., 6(2), 33-45.
  36. Yu, L., Liu, J., Kong, X. and Hu, Y. (2011), "Three-dimensional large deformation FE analysis of square footings in two-layered clays", J. Geotech. Geoenviron. Eng., 137(1), 52-58. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000400
  37. Yuan, F.F. and Luan, M.T. (2005), "Study on bearing behaviors of foundations on multi-layer subsoil", Proceedings of the International Symposium on Frontiers in Offshore Geotechnics, Perth, WA, Australia, September, pp. 19-21.

피인용 문헌

  1. A comparative study for design of boundary combined footings of trapezoidal and rectangular forms using new models vol.6, pp.4, 2017, https://doi.org/10.12989/csm.2017.6.4.417
  2. Bearing capacity of shallow foundations on the bilayer rock vol.21, pp.1, 2015, https://doi.org/10.12989/gae.2020.21.1.011
  3. Optimizing ANN models with PSO for predicting short building seismic response vol.36, pp.3, 2020, https://doi.org/10.1007/s00366-019-00733-0