Steel and Composite Structures

  • 제19권2호
  • /
  • Pages.441-465
  • /
  • 2015
  • /
  • 1229-9367(pISSN)
  • /
  • 1598-6233(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Flexural and compression behavior for steel structures strengthened with Carbon Fiber Reinforced Polymers (CFRPs) sheet

  • Park, Jai-woo (Korea Infrastructure Safety Corporation) ;
  • Yoo, Jung-han (School of Architecture, Seoul National University of Science &Technology)
  • 투고 : 2014.09.11
  • 심사 : 2015.02.06
  • 발행 : 2015.08.25
⟨ 이전 논문 다음 논문 ⟩

초록

This paper presents the experimental results of flexural and compression steel members strengthened with carbon fiber reinforced polymers (CFRP) sheets. In the flexural test, the five specimens were fabricated and the test parameters were the number of CFRP ply and the ratio of partial-length bonded CFRP sheets of specimen. The CFRP sheet strengthened steel beam had failure mode: CFRP sheet rupture at the mid span of steel beams. A maximum increase of 11.3% was achieved depending on the number of CFRP sheet ply and the length of CFRP sheet. In the compression test, the nine specimens were fabricated and the main parameters were: width-thickness ratio (b/t), the number of CFRP ply, and the length of the specimen. From the tests, for short columns it was observed that two sides would typically buckle outward and the other two sides would buckle inward. Also, for long columns, overall buckling was observed. A maximum increase of 57% was achieved in axial-load capacity when 3 layers of CFRP were used to wrap HSS columns of b/t = 60 transversely.

키워드

참고문헌

  1. AISC (2010), Steel Construction Manual; Volume 2, (13th Ed.), American Institute of Steel Construction.
  2. Fam, A., Macfougall, C. and Shaat, A. (2009), "Upgrading steel-concrete composite girders and repair of damaged steel Beams using bonded CFRP laminates", Thin-Wall. Struct., 47(1), 1122-1135. https://doi.org/10.1016/j.tws.2008.10.014
  3. Harries, K.A., Peck, A.J. and Abraham, E.J. (2009), "Enhancing stability of structural steel sections using FRP", Thin-Wall. Struct., 47(1), 1092-1101. https://doi.org/10.1016/j.tws.2008.10.007
  4. Miller, T.C., Chajes, M.J., Mertz, D.R. and Hastings, J.N. (2001), "Strengthening of a steel bridge girder using CFRP plates", ASCE, J. Bridge. Eng., 6(6), 514-522. https://doi.org/10.1061/(ASCE)1084-0702(2001)6:6(514)
  5. Park, J.W. and Choi, S.M. (2013), "Structural behavior of CFRP strengthened concrete-filled steel tubes columns under axil compression loads", Steel Compos. Struct., Int. J., 14(5), 453-472. https://doi.org/10.12989/scs.2013.14.5.453
  6. Photiou, N.K., Hollaway, L.C. and Chrassanthopoulos, M.K. (2006), "Strengthening of an artificially damaged steel beam utilizing a carbon/glass composite system", J. Construct. Mater ., 20(1), 11-21. https://doi.org/10.1016/j.conbuildmat.2005.06.043
  7. Ritchie, P.A., Toamas, D.A., Lu, W. and Conneilly, G.M. (1991), "External reinforcement of concrete beams using fiber reinforced plastics", ACI Structural J., 490-500.
  8. Sallam, H.E.M., Badawy, A.A.M., Saba, A.M. and Mikhail, F.A. (2010), "Flexural behavior of strengthened steel-concrete composite beams by various plating methods", J. Const. Steel. Res., 62(1), 472-483.
  9. Schnerch, D. and Rizkalla, S. (2008), "Flexural strengthening of steel bridges with high modulus CFRP strips", ASCE J. Bridge Eng., 13(2), 192-201. https://doi.org/10.1061/(ASCE)1084-0702(2008)13:2(192)
  10. Shaat, A. and Fam, A.Z. (2006), "Axial loading tests on short and long hollow structural steel columns retrofitted using carbon fibre reinforced polymers", Can. J. Civil Eng., 33(4), 458-470. https://doi.org/10.1139/l05-042
  11. Shatt, A. and Fam, A. (2008), "Repair of cracked steel girders connected to concrete slabs using carbon fiber reinforced polymer sheets", J. Compos. Construct.., 12(6), 650-659. https://doi.org/10.1061/(ASCE)1090-0268(2008)12:6(650)
  12. Shaat, A. and Fam, A.Z. (2009), "Slender steel columns strengthened using high-modulus CFRP plates for buckling control", ASCE, J. Compo. Const., 13(1), 1-12. https://doi.org/10.1061/(ASCE)1090-0268(2009)13:1(1)
  13. Swamy, E.N., Johns, E. and Charif, A. (1989), "The effect of external plate reinforcement on the strengthening of structurally damaged RC beams", The Structural Engineer, 67(3), 45-54.
  14. Zhao, X.L. and Zhang, L. (2007), "State of art review on FRP strengthened steel structures", Eng. Struct., 29(8), 1808-1823. https://doi.org/10.1016/j.engstruct.2006.10.006

피인용 문헌

  1. Retrofitting of RC girders using pre-stressed CFRP sheets vol.20, pp.4, 2016, https://doi.org/10.12989/scs.2016.20.4.833
  2. Strengthening of steel hollow pipe sections subjected to transverse loads using CFRP vol.60, pp.1, 2016, https://doi.org/10.12989/sem.2016.60.1.163
  3. Finite element and micromechanical modeling for investigating effective material properties of polymer–matrix nanocomposites with microfiber, reinforced by CNT arrays vol.8, pp.3, 2016, https://doi.org/10.1007/s40091-016-0132-y
  4. Stereo-digital image correlation in the behavior investigation of CFRP-steel composite members vol.23, pp.6, 2015, https://doi.org/10.12989/scs.2017.23.6.727
  5. Minimum cost design of overhead crane beam with box section strengthened by CFRP laminates vol.61, pp.4, 2015, https://doi.org/10.12989/sem.2017.61.4.475
  6. Numerical study on the rotation capacity of CFRP strengthened cold formed steel beams vol.23, pp.4, 2017, https://doi.org/10.12989/scs.2017.23.4.385
  7. Mechanical behavior of FRP confined steel tubular columns under impact vol.27, pp.6, 2015, https://doi.org/10.12989/scs.2018.27.6.691
  8. Experimental and numerical investigation of strengthened deficient steel SHS columns under axial compressive loads vol.67, pp.2, 2015, https://doi.org/10.12989/sem.2018.67.2.207
  9. Strengthening of deficient steel SHS columns under axial compressive loads using CFRP vol.30, pp.1, 2015, https://doi.org/10.12989/scs.2019.30.1.069
  10. Parametric study of shear strength of CFRP strengthened end-web panels vol.31, pp.2, 2015, https://doi.org/10.12989/scs.2019.31.2.159
  11. Reliability Analysis of CFRP-Strengthened RC Bridges Considering Size Effect of CFRP vol.12, pp.14, 2015, https://doi.org/10.3390/ma12142247
  12. Investigating loading rate and fibre densities influence on SRG - concrete bond behaviour vol.34, pp.6, 2020, https://doi.org/10.12989/scs.2020.34.6.877