Steel and Composite Structures

  • 제19권1호
  • /
  • Pages.153-171
  • /
  • 2015
  • /
  • 1229-9367(pISSN)
  • /
  • 1598-6233(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Effect of fibers and welded-wire reinforcements on the diaphragm behavior of composite deck slabs

  • Altoubat, Salah (Department of Civil& Environmental Engineering, University of Sharjah) ;
  • Ousmane, Hisseine (Department of Architectural Engineering, University of Sharjah) ;
  • Barakat, Samer (Department of Civil& Environmental Engineering, University of Sharjah)
  • 투고 : 2014.04.30
  • 심사 : 2014.12.29
  • 발행 : 2015.07.25
⟨ 이전 논문 다음 논문 ⟩

초록

Twelve large-scale composite deck slabs were instrumented and tested in a cantilever diaphragm configuration to assess the effect of fibers and welded wire mesh (WWM) on the in-plane shear capacity of composite deck slabs. The slabs were constructed with reentrant decking profile and reinforced with different types and dosages of secondary reinforcements: Conventional welded wire mesh (A142 and A98); synthetic macro-fibers (dosages of $3kg/m^3$ and $5.3kg/m^3$); and hooked-end steel fibers with a dosage of $15kg/m^3$. The deck orientation relative to the main beam (strong and weak) was also considered in this study. Fibers and WWM were found efficient in distributing the applied load to the whole matrix, inducing multiple cracking, thereby enhancing the strength and ductility of composite deck slabs. The test results indicate that fibers increased the slab's ultimate in-plane shear capacity by up to 29% and 50% in the strong and weak directions, respectively. WWM increased the ultimate in-plane shear capacity by up to 19% in the strong direction and 9% in the weak direction. The results suggest that discrete fibers can provide comparable diaphragm behavior as that with the conventional WWM.

키워드

참고문헌

  1. Abdullah, R. and Easterling, W. (2007), "Determination of composite slab strength using a new elemental test method", J. Struct. Eng., 133(9), 1268-1277. https://doi.org/10.1061/(ASCE)0733-9445(2007)133:9(1268)
  2. ACI Committee 544 (1982), State of the art report of fibre reinforced concrete; Concrete Int.: Des. Construct., 4(5), 9-30.
  3. ACI 318 (2011), Building code requirements for structural concrete and commentary; American Concrete Institute, Farmington Hills, MI, USA.
  4. Ahmat, H.O (2010), "Diaphragm behavior of fiber-reinforced composite deck slabs", M.S. Thesis; University of Sharjah, Sharjah, UAE.
  5. AISC (2010), Manual of steel construction-load and resistance factor design; American Institute of Steel Construction Chicago, IL, USA.
  6. ASTM C 1609-07 (2007), Standard test method for flexural performance of fiber-reinforced concrete (using beam with third-point loading); ASTM International, West Conshohocken, PA, USA.
  7. BS EN ISO 898-1 (2009), Mechanical properties of fasteners made of carbon steel and alloy steel-part I, bolts, screws and studs with specified property classes-coarse thread and fine pitch thread; British Standards Institute, London, UK.
  8. BS EN 10147 (2000), Continuously hot-dip zinc coated structural steels strip and sheet; British Standards Institute, London, UK.
  9. BS 1881-101 (1983), Testing Concrete, Part 101: Method of sampling fresh concrete on site; British Standards Institute, London, UK.
  10. BS 1881-116 (1983), Testing Concrete, Part 116: Method for determination of compressive strength of concrete cubes; British Standards Institute, London, UK.
  11. Cifuentes, H. and Medina, F. (2013), "Experimental study on shear bond behavior of composite slabs according to Eurocode 4", J. Construct. Steel Res., 82(2013), 99-110. https://doi.org/10.1016/j.jcsr.2012.12.009
  12. Chen, S., Shi, X. and Qiu, Z. (2011), "Shear bond failure in composite slabs-A detailed experimental study", Steel Compos. Struct., Int. J., 11(3), 233-250. https://doi.org/10.12989/scs.2011.11.3.233
  13. Davies, J.M. and Fisher, J. (1979), "The diaphragm action of composite slabs", Inst. Civil Eng., 67(2), 891-906. https://doi.org/10.1680/iicep.1979.2780
  14. Easterling, W.S. and Porter, M.L. (1988), "Behavior, analysis and design of steel-deck-reinforced concrete diaphragms", Final Report; Iowa State University, Engineering Research Institute-Project 1636, Ames, IA, USA.
  15. Easterling, W.S. and Porter, M.L. (1994), "Steel deck reinforced concrete diaphragms-I", ASCE J. Struct. Eng., 120(2), 560-576. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:2(560)
  16. Easterling, W.S. and Young, C.S., (1992), "Strength of composite slabs", J. Struct. Eng., 118(9), 2370-2389. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:9(2370)
  17. Guirola, M. (2001), "Strength and performance of fiber-reinforced concrete composite slabs", M.S. Thesis; Virginia Polytechnic Institute and State, VA, USA.
  18. Hossain, K.M.A. and Wright, H.D. (2004), "Experimental and theoretical behavior of composite walling under in-plane shear", J. Construct. Steel Res., 60(1), 59-83. https://doi.org/10.1016/j.jcsr.2003.08.004
  19. Hedaoo, N.A., Gupta, L.M. and Ronghe, G.N. (2012), "Design of composite slabs with profiled steel decking: A comparison between experimental and analytical studies", Int. J. Adv. Struct. Eng., 3(1).
  20. James, L. and Easterling, W.S. (2006), "Structural performance of fiber reinforced and welded wire fabric reinforced composite slabs", Research Report CEE/VPI-ST-06/05, Virginia Polytechnic Institute, VA, USA.
  21. JSCE-SF4 (1984), Methods of Tests for Flexural Strength and Flexural Toughness of Steel Fiber Reinforced Concrete; Japan Society of Civil Engineers, Concrete Library International, No. 3, Part III-2, pp. 58-61.
  22. Lopes, E. and Simoes, R. (2008), "Experimental and analytical behaviour of composite slabs", Steel Compos. Struct., Int. J., 8(5), 361-388. https://doi.org/10.12989/scs.2008.8.5.361
  23. Luttrell, L.D. (1971), "Shear diaphragms with lightweight concrete fill", Proceedings of the 1st Specialty Conference on Cold-Formed Steel Structures, University of Missouri-Rolla, Rolla, MO, USA, August.
  24. Luttrell, C.B. (1995), "Transverse distribution of non-uniform loads on composite slabs", M.S. Thesis; West Virginia University, WV, USA.
  25. Porter, M.L. and Ekberg, C.E. Jr. (1978), "Compendium of ISU research conducted on cold-formed steel-deck reinforced slab systems", Bull. 200-1978; ISU-ER1-AMES-78263, Engineering Research Institute, Iowa State University, Ames, IA, USA.
  26. Roesler, J.R., Altoubat, S.A., Lange, D.A., Rieder, K.A. and Ulreich, G.R. (2006), "Effect of synthetic fibers on structural behavior of concrete slabs-on-ground", ACI Mater. J., 103(1), 3-10.
  27. Saravanan, M., Marimuthu, V., Prabha, P., Arul Jayachandran, S. and Datta, D. (2012), "Experimental investigations on composite slabs to evaluate longitudinal shear strength", Steel Compos. Struct., Int. J., 13(5), 489-500. https://doi.org/10.12989/scs.2012.13.5.489

피인용 문헌

  1. TYPES OF STEEL AND CONCRETE COMPOSITE CABLE SPACE FRAMES vol.0, pp.6(66), 2016, https://doi.org/10.15802/stp2016/90514
  2. Free vibrations of precast modular steel-concrete composite railway track slabs vol.24, pp.1, 2015, https://doi.org/10.12989/scs.2017.24.1.113
  3. Investigation on mechanical performance of flat steel plate-lightweight aggregate concrete hollow composite slab vol.31, pp.4, 2019, https://doi.org/10.12989/scs.2019.31.4.329
  4. Partially encased composite columns using fiber reinforced concrete: experimental study vol.34, pp.6, 2015, https://doi.org/10.12989/scs.2020.34.6.909
  5. An innovative system to increase the longitudinal shear capacity of composite slabs vol.35, pp.4, 2015, https://doi.org/10.12989/scs.2020.35.4.509
  6. Conception and design of high‐performance steel‐concrete composite slabs vol.4, pp.2, 2015, https://doi.org/10.1002/cepa.1352