DOI QR코드

DOI QR Code

Relation between Shear Strength of Masonry infills and Seismic Performance of Masonry-infilled Frames

조적채움벽의 전단강도에 따른 채움벽골조의 내진성능

  • Yu, Eunjong (Department of Architectural Engineering, Hanyang University) ;
  • Kim, Min Jae (Department of Architectural Engineering, Hanyang University) ;
  • Lee, Sang Hyun (Department of Architectural Engineering, Hanyang University) ;
  • Kim, Chung Man (Department of Architectural Engineering, Hanyang University)
  • Received : 2015.04.14
  • Accepted : 2015.05.29
  • Published : 2015.07.01

Abstract

In this study, material tests were performed on the masonry specimens constructed with bricks and mortar used in Korea. The specimens included two types of thickness(0.5B and 1.0B) and physical conditions (good and poor). It was shown that 1.0B specimens have 3.2~1.8 times larger shear strength than 0.5B specimens and shear strength of specimens in poor condition was 66%~38% of those in good condition. Average shear stress of masonry-infills was calculated from previous experimental studies, and relationships with failure mode, material strength of masonry, aspect ratio, and frame-to-infill strength ratio were investigated. In addition, the effects of masonry strength on the seismic performance of a masonry-infilled frame was studied using a simple example building. It can be seen that the obtained average shear stress were considerably higher than the default masonry shear strength recommended by the ASCE 41, and low values the strength of masonry does not guarantee conservative evaluation results due to the early shear failure of frame members.

Keywords

References

  1. Rhee HM, Seo JM, Kim MK, Choi IK. Comparison of methods for the analysi percentile of seismic hazards. EESK J. Earthquake Eng. 2011 April;15(2):43-51.
  2. Federal Emergency Management Agency. Evaluation of Earthquake Damaged Concrete and Masonry Wall Buildings: FEMA-306. c1998.
  3. Stafford Smith, B. Behavior of square infilled frames. ASCE Journal of the Structural Division, vol.92. no.ST1. pp.381-403. 1966.
  4. Priestley MJN, Paulay T. Seismic design of reinforced concrete and masonry buildings. Wiley, United States. c2007.
  5. Federal Emergency Management Agency. Prestandard and Commentary for the Seismic Rehabilitation of Buildings: FEMA-356. c2000.
  6. Dolsek, Matjaz, Peter Fajfar. Mathematical modelling of an infilled RC frame structure based on the results of pseudo‐dynamic tests. Earthquake engineering & structural dynamics 2002;31.6: 1215-1230. https://doi.org/10.1002/eqe.154
  7. ASCE/SEI Seismic Rehabilitation Standards Committee. Seismic Rehabilitation of Existing Buildings (ASCE/SEI 41-13). American Society of Civil Engineers, Reston, VA. c2014.
  8. EN, BSIBS. 1-1: 2005, Eurocode 6: design of masonry structures. General rules for reinforced and unreinforced masonry structures, CEN. c2005.
  9. BS EN 1052-3 Methods of test for masonry-Part 3: Determination of initial shear strength. c2002.
  10. Architectural Institute of Japan (AIJ), AIJ standard for structural calculation of reinforced concrete structures. Architectural Institute of Japan. c2010.
  11. Architectural Institute of Korea, Korean Building Code, Architectural Institute of Korea. c2009.
  12. ASTM International, ASTM C 1314-12 Standard Test Method for Compressive Strength of Masonry Prisms. ASTM International, West Conshohocken, PA. c2012.
  13. ASTM International, ASTM E 519/E 519M-10 Standard Test Method for Diagonal Tension (Shear) in Masonry Assemblages. ASTM International, West Conshohocken, PA. c2010.
  14. Lee WH, Lee JH, Kang DE, Yang WJ. An Experimental Study of Material Characteristics of Brick Masonry. Journal of the Architectural Institute of Korea. 2004;20.12:45-52.
  15. Kim HC, Kim KJ, Park JH, Hong WK. Experimental Study on the Material Properties of Unreinforced Masonry Considering Earthquake Load. Journal of the Earquake Engineering Society of Korea. 2001;5(2):93-101.
  16. CALVI, G. Michele; BOLOGNINI, Davide; PENNA, Andrea. Seismic performance of masonry-infilled RC frames: benefits of slight reinforcements. Invited lecture to Sismica. 2004; 6:14-16.
  17. Masonry Society (US). Masonry Designers' Guide: Based on Building Code Requirements for Masonry Structures (ACI 530-99). Masonry Society. c2001.
  18. Lee JH. Seismic Capacity and Seismic Retrofitting of Low Rise Buildings - Unreinforced Masonry, Brick-Infilled RC Frame and Steel Slit Damper Retrofitted RC Frame. Ph.D. Thesis, University of Kwangwoon. c2005.
  19. Nam WG. An Experimental Study for improvement of Seismic performance of Reinforced Concrete Infilled Masonry Frame. Master of Philosophy. c2001.
  20. Choi H. Cyclic Loading Test of Reinforced Concrete Frame with Unreinforced Concrete Block Infill. Journal of the Architectural Institute of Korea. 2007;23.4:71-78.
  21. Jang JH and Kim YM. Behavior of Non-Seismic Detailed Low-Rise Reinforced Concrete Frame by Cyclic Loading. Journal of the Architectural Institute of Korea. 2002;4.4:127-133.
  22. Seo CH et al. Seismic Resistance Performance of RC Infilled Wall with Steel Honeycomb System. Journal of Concrete Structures and Materials, 2011:105-106.
  23. Chung L, Park TW and Lee SG. Retrofitting Effects on Seismic Resistance Capacity of Reinforced Concrete Framed Structure. Journal of the Architectural Institute of Korea. 2004;20.9:37-44.
  24. Kakaletsis DJ, Karayannis CG, Panagopoulos GK. Effectiveness of rectangular spiral shear reinforcement on infilled R/C frames under cyclic loading. Journal of Earthquake Engineering. 2011; 15.8: 1178-1193. https://doi.org/10.1080/13632469.2011.560361
  25. Sanada Y. Konishi D. Effects of Nonstructural Brick Infills on an Indonesian Earthquake - Damaged Building. Procedia Engineering. 2011;14:2077-2085. https://doi.org/10.1016/j.proeng.2011.07.261
  26. Mehrabi, ArminB. et al. Experimental evaluation of masonry-infilled RC frames. Journal of Structural Engineering. 1996;122(3): 228-237. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:3(228)
  27. Colangelo F. Pseudo-dynamic seismic response of reinforced concrete frames infilled with non-structural brick masonry. Earthquake engineering & structural dynamics. 2005;34(10):1219-1241. https://doi.org/10.1002/eqe.477
  28. Manos GC, Soulis VJ, Thauampteh J. The behavior of masonry assemblages and masonry-infilled R/C frames subjected to combined vertical and cyclic horizontal seismic-type loading. Advances in Engineering Software. 2012;45.1:213-231. https://doi.org/10.1016/j.advengsoft.2011.10.017
  29. EL-DAKHAKHNI, Wael W.; ELGAALY, Mohamed; HAMID, Ahmad A. Three-strut model for concrete masonry-infilled steel frames. Journal of Structural Engineering. 2003, 129.2: 177-185. https://doi.org/10.1061/(ASCE)0733-9445(2003)129:2(177)
  30. MSJC 2011b. Specification for Masonry Structures (TMS 602-11 / ACI 530.1-11 / ASCE 6-11), The Masonry Society, Boulder, Colorado, the American Concrete Institute, Farmington Hills, Michigan, and the American Society of Civil Engineers, Reston, Virginia. c2011.