Geomechanics and Engineering

  • 제8권6호
  • /
  • Pages.801-810
  • /
  • 2015
  • /
  • 2005-307X(pISSN)
  • /
  • 2092-6219(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Experiment of single screw piles under inclined cyclic pulling loading

  • Dong, Tian Wen (Department of Road and Bridge Engineering, Liaoning Provincial College of Communications) ;
  • Zheng, Ying Ren (Department of Architecture & Engineering, Logistical Engineering college)
  • 투고 : 2014.05.05
  • 심사 : 2015.02.09
  • 발행 : 2015.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

The ultimate pullout capacity under inclined dynamic loading is an important measure of the destruction degree of vertical screw piles (anchors) under dynamic actions. Based on the static and dynamic tests on two kinds of model screw piles, the ultimate bearing capacity was researched considering different distance-width ratio of blade (D/W) and preloading ratio. The results compared well with other experimental data available in the literature. This research reveals that D/W might determine the failure model of the piles (anchors), for example D/W = 3.14 or 5; a critical dynamic-static loading ratio (DSLR) existed in the experiments. The critical DSLR was reached under the conditions of 40%~60% preloading (D/W = 3.14) or 20%~40% preloading (D/W = 5), respectively.

키워드

참고문헌

  1. Cerato, A.B. and Victor, R. (2008), "Effects of helical anchor geometry on long-term performance of small wind tower foundations subject to dynamic loads", J. Deep Found. Inst., 2(1), 30-41. https://doi.org/10.1179/dfi.2008.004
  2. China Academy of Building Reseach (2001), Lode Code for the Design of Building Structures (GB50009-2001), China Architecture & Building Press, Beijing, China.
  3. Clemence, S.P. and Smithling, A.P. (1984), "Dynamic uplift capacity of helical anchors in sand", Proceedings of the 4th Australia-New Zealand Conference on Geomechanics, Perth, Brazil, May.
  4. Dong, T.W., Zhang, Y.J., Li, S.W. and Huang, L.Z. (2008a), "Bearing capacity of screw pile group determined by inclined pull-out test", Chinese J. Geotech. Eng., 30(3), 429-433.
  5. Dong, T.W., Liang, L., Wang, W. and Wang, M.S. (2008b), "Experimental analysis on the lamina-soils interaction in pullout screw pile foundation", J. Eng. Mech., 25(8), 150-155.
  6. Dong, T.W., Liang, L., Huang, L.Z. and Wang, M.S. (2009), "Pullout test of screw pile foundation", J. Rock Soil Mech., 30(1), 186-190.
  7. Ghaly, A.M. and Clemence, S.P. (1998), "Pullout performance of inclined helical screw anchors in sand", J. Geotech. Geoenviron. Eng., ASCE, 124(7), 617-627. https://doi.org/10.1061/(ASCE)1090-0241(1998)124:7(617)
  8. Ghaly, A. and Hanna, A.M. (1994), "Model investigation of the performance of single anchors and groups of anchors", Can. Geotech. J., 31(2), 273-284. https://doi.org/10.1139/t94-032
  9. Goel, S., Shalini and Patra, N.R. (2006), "Break out resistance of inclined anchors in sand", J. Geotech. Geol. Eng., 24(6), 1511-1525. https://doi.org/10.1007/s10706-005-2634-4
  10. Hanna, A.M., Das, B. and Foriero, A. (1988), "Behavior of shallow inclined plate anchors in sand", Proceedings of Special Topics in Foundations, Nashville, USA, May.
  11. Hoyt, R.M. and Clemence, S.P. (1989), "Uplift capacity of helical anchors in soil", Proceedings of the 12th International Conference on Soil Mechanics and Foundation Engineering, Brazil, August.
  12. Ilamparuthi, K., Dickin, E.A. and Muthukrisnaiah, K. (2002), "Experimental investigation of the uplift behavior of circular plate anchors embedded in sand", Can. Geotech. J., 39(3), 648-664. https://doi.org/10.1139/t02-005
  13. Kananyan, A.S. (1966), "Experimental investigation of the stability of bases of anchor foundations", Soil Mech. Found. Eng., 3(6), 387-392. https://doi.org/10.1007/BF01702954
  14. Matsuo, M. (1967), "Study on the uplift resistance of footing", Japanese Geotech. Soc. Soil Found., 7(4), 1-37.
  15. Mitsch, M.P. and Clemence, S.P. (1985), "The uplift capacity of helix anchors and sand", Uplift Behavior of Anchor Foundations in Soil, ASCE, Detroit, MI, USA, October.
  16. Peabody, A.B. and McClure, G. (2002), "Load limiters for overhead lines", Proceedings of the 4th Structural Specialty Conference of the Canadian Society for Civil Engineering, Montreal, QC, Canada, June.
  17. Ponniah, D.A. and Finlay, T.W. (1988), "Cyclic behaviour of plate anchors", Can. Geotech. J., 25(2), 374-381. https://doi.org/10.1139/t88-038
  18. Raham, M.A.A., Othman, M.A. and Edil, T.B. (1992), "Effect plate flexibility on behavior of shallow anchors", Japanese Geotech. Soc. Soil Found., 32(3), 137-143. https://doi.org/10.3208/sandf1972.32.3_137
  19. Rao, S.N. and Prasad, Y.V.S.N. (1993), "Uplift behavior of pile anchors subjected to lateral cyclic loading", J. Geotech. Eng., ASCE, 119(4), 786-790. https://doi.org/10.1061/(ASCE)0733-9410(1993)119:4(786)
  20. Rattley, M.J., Richards, D.J. and Lehane, B.M. (2008), "Uplift performance of transmission tower foundations embedded in clay", J. Geotech. Geoenviron. Eng., ASCE, 134(4), 531-540. https://doi.org/10.1061/(ASCE)1090-0241(2008)134:4(531)
  21. Singh, S.P. and Ramaswamy, S.V. (2010), "Effects of cyclic frequency and pre-loading on behaviour of plate anchors", International Conference Geoshanghai-#2010 Shanghai China, ASCE, Shanghai, China, June.
  22. Southwest Electric Power Design Institute Co., LTD (2002), "Technical regulation of design for tower and pole structures of overhead transmission (DL/T5154-2002)", Electric Power Press, Beijing, China.
  23. Zhang, Y.J., Wei, D.S. and Liang, L. (2010), "The loading translation of screw pile on pullout test under inclined loading", J. Transp. Sci. Eng., 25(4), 22-30.