DOI QR코드

DOI QR Code

Calculating Method of FRF with Sub-structure Mode Synthesis Method

부분구조 모드합성법에 의한 주파수응답함수 산출법

  • Oh, Chang-Guen (Doosanmottrol) ;
  • Park, Kyung-Il (Graduate School, Korea Maritime and Ocean University) ;
  • Park, Sok-Chu (Department of Naval Architecture and Ocean System Engineering, Korea Maritime and Ocean University)
  • Received : 2014.06.09
  • Accepted : 2015.05.01
  • Published : 2015.05.31

Abstract

A very important part in vibration analysis is to calculate the frequency response function (FRF). In general, a large sized or/and complicated structure has many thousands to millions of degrees. Therefore, the FRF cannot be calculated by the traditional analysis method using an inverse matrix. This paper presents a new FRF calculation method of a superstructure by synthesizing sub-structure modes, of which the DOF can be deduced by partitioning into some sub-structures. To confirm its analysis results, the method was applied to an assembled plate ($B300{\times}L900{\times}t5mm$) with three diagonal sub-plates($B300{\times}L300{\times}t5mm$) in series and compared with the measured data. The test results have were comparable those of the calculated ones with an error less than 5%.

진동해석에 있어서 매우 중요한 부분 중의 하나가 주파수응답함수를 구하는 것이다. 크거나 복잡한 구조물은 일반적으로 아주 큰 자유도-예를 들면 수 백 만 자유도-를 가지기 때문에 역행렬에 의한 전통적인 방법으로는 주파수응답함수를 구할 수 없을지도 모른다. 그래서 전체 구조물을 몇 개의 부분구조로 나누어서 해석하는 부분구조 해석법을 이용한다. 여기에서는 부분구조별로 나누어 계산한 부분구조 진동모드를 이용하여 자유도를 현격하게 낮춘 등가의 저 자유도 모델에서 주파수응답함수를 구하는 방법을 제시한다. 개발한 프로그램의 신뢰도를 확인하기 위하여 평판 구조물에 적용하여서 실험과 축소하지 않는 영역에서의 해석 결과와 본 해석 결과를 비교하였고, 매우 좋은 결과를 얻었다.

Keywords

References

  1. S. C. Park, J. R. Kim, and K. I. Park, "Sub-structure mode synthesis vibration analysis program development using Matlab," Journal of the Korean Society of Marine Engineering, vol. 38, no. 6, pp. 666-673, 2014. https://doi.org/10.5916/jkosme.2014.38.6.666
  2. A. Nagamatsu, M. Okuma, Component Mode Synthesis Method, Japan: Baifukan, 1991.
  3. R. J. Guyan, "Reduction of stiffness and mass matrices," AIAA Journal, vol. 3, no. 2, p.380, 1965. https://doi.org/10.2514/3.2874
  4. W. C. Hurty. "Dynamic analysis of structural systems using component modes," AIAA Journal, vol. 3, no. 4, pp. 678-685, 1965. https://doi.org/10.2514/3.2947
  5. W. A. Benfield and R. F. Hruda, "Vibration analysis of structures by component mode substitution," AIAA Journal, vol. 9, no. 7, pp. 1255-1261, 1971. https://doi.org/10.2514/3.49936