DOI QR코드

DOI QR Code

Correlation of elastic input energy equivalent velocity spectral values

  • Cheng, Yin (Department of Structural and Geotechnical Engineering, Sapienza University of Rome) ;
  • Lucchini, Andrea (Department of Structural and Geotechnical Engineering, Sapienza University of Rome) ;
  • Mollaioli, Fabrizio (Department of Structural and Geotechnical Engineering, Sapienza University of Rome)
  • 투고 : 2014.02.27
  • 심사 : 2014.08.13
  • 발행 : 2015.05.25

초록

Recently, two energy-based response parameters, i.e., the absolute and the relative elastic input energy equivalent velocity, have been receiving a lot of research attention. Several studies, in fact, have demonstrated the potential of these intensity measures in the prediction of the seismic structural response. Although some ground motion prediction equations have been developed for these parameters, they only provide marginal distributions without information about the joint occurrence of the spectral values at different periods. In order to build new prediction models for the two equivalent velocities, a large set of ground motion records is used to calculate the correlation coefficients between the response spectral values corresponding to different periods and components of the ground motion. Then, functional forms adopted in models from the literature are calibrated to fit the obtained data. A new functional form is proposed to improve the predictions of the considered models from the literature. The components of the ground motion considered in this study are the two horizontal ones only. Potential uses of the proposed equations in addition to the prediction of the correlation coefficients of the equivalent velocity spectral values are shown, such as the prediction of derived intensity measures and the development of conditional mean spectra.

키워드

참고문헌

  1. Abrahamson, N.A., Kammerer, A. and Gregor, N. (2003), "Summary of scaling relations for spectral damping, peak velocity, and average spectral acceleration", Report for the PEGA-SOS project, Personal communication.
  2. Akaike, H. (1974), "A new look at the statistical model identification", IEEE Trans. Automatic Control, 19(6), 716-723. https://doi.org/10.1109/TAC.1974.1100705
  3. Akiyama, H. (1985), Earthquake resistant limit-state design for buildings, Univ. Tokyo Press, Tokyo.
  4. Baker, J. (2011), "Conditional mean spectrum: tool for ground-motion selection", J. Struct. Eng., 137(3), 322-331. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000215
  5. Baker, J. and Cornell, C.A. (2006a), "Correlation of response spectral values for multicomponent ground motions", Bull. Seismol. Soc. Am., 96(1), 215-227. https://doi.org/10.1785/0120050060
  6. Baker, J. and Cornell, C.A. (2006b), "Spectral shape, epsilon and record selection", Earthq. Eng. Struct. Dyn., 35(9), 1077-1095. https://doi.org/10.1002/eqe.571
  7. Baker, J. and Jayaram, N. (2008), "Correlation of spectral acceleration values from NGA ground motion models", Earthq. Spectra, 24(1), 299-317. https://doi.org/10.1193/1.2857544
  8. Benavent-Climent, A., Lopez-Almansa, F. and Bravo-Gonzalez, D.A. (2010), "Design energy input spectra for moderate-to-high seismicity regions based on Colombian earthquakes", Soil Dyn. Earthq. Eng., 30(11), 1129-1148. https://doi.org/10.1016/j.soildyn.2010.04.022
  9. Bertero, V.V. and Uang, C.M. (1992), Issues and future directions in the use of energy approach for seismic-resistant design of structures, Nonlinear seismic analysis of reinforced concrete buildings, Elsevier, London.
  10. Bradley, A.B., Cubrinovski, M., MacRae, G.A. and Dhakal, R.P. (2009), "Ground-motion prediction equation for SI based on spectral acceleration equations", Bull. Seismol. Soc. Am., 99(1), 277-285. https://doi.org/10.1785/0120080044
  11. Chai, R.Y.H. and Fajfar, P.A. (2000), "Procedure for estimating input energy spectra for seismic design", J. Earthq. Eng., 4(4), 539-561. https://doi.org/10.1080/13632460009350382
  12. Chapman, M.C. (1999), "On the use of elastic input energy for seismic hazard analysis", Earthq. Spectra, 15(4), 607-635. https://doi.org/10.1193/1.1586064
  13. Cheng, Y., Lucchini, A. and Mollaioli, F. (2014), "Proposal of new ground-motion prediction equations for elastic input energy spectra", Earthq. Struct., 7(4), 485-510. https://doi.org/10.12989/eas.2014.7.4.485
  14. Chou, C.C. and Uang, C.M. (2000), "Establishing absorbed energy spectra-an attenuation approach", Earthq. Eng. Struct. Dyn., 29(10), 1441-1455. https://doi.org/10.1002/1096-9845(200010)29:10<1441::AID-EQE967>3.0.CO;2-E
  15. Chou, C.C. and Uang, C.M. (2003), "A procedure for evaluation of seismic energy demand of framed structures", Earthq. Eng. Struct. Dyn., 32(2), 229-244. https://doi.org/10.1002/eqe.221
  16. Cimellaro, G.P. (2013), "Correlation in spectral acceleration for earthquakes in Europe", Earthq. Eng. Struct. Dyn., 42(4), 623-633. https://doi.org/10.1002/eqe.2248
  17. Danciu, L. and Tselentis, G.A. (2007), "Engineering ground-motion parameters attenuation relationships for Greece", Bull. Seismol. Soc. Am., 97(1), 162. https://doi.org/10.1785/0120050087
  18. Decanini, L.D. and Mollaioli, F. (1998), "Toward the definition of the relation between hysteretic and input energy", Proceeding of 6th U.S. National Conference on Earthquake Engineering, EERI, Oakland, California.
  19. Decanini, L.D. and Mollaioli, F. (2001), "An energy-based methodology for the assessment of seismic demand", Soil Dyn. Earthq. Eng., 21(2), 113-137. https://doi.org/10.1016/S0267-7261(00)00102-0
  20. Fajfar, P. and Fischinger, M. (1990), "A seismic procedure including energy concept", Proceedings of IX ECEE, Moscow, September.
  21. Fajfar, P. and Vidic, T. (1994), "Consistent inelastic design spectra: hysteretic and input energy", Earthq. Eng. Struct. Dyn., 23(5), 523-537. https://doi.org/10.1002/eqe.4290230505
  22. Gong, M.S. and Xie, L.L. (2005), "Study on comparison between absolute and relative input energy spectra and effects of ductility factor", Acta. Seismol. Sinic., 18(6), 717-726. https://doi.org/10.1007/s11589-005-0099-4
  23. Haselton, C.B., Baker, J.W., Bozorgnia, Y., Goulet, C.A., Kalkan, E., Luco, N., Shantz, T., Shome, N., Stewart, J.P., Tothong, P., Watson-Lamprey, J. and Zareian, F. (2009), "Evaluation of ground motion selection and modification methods: Predicting median interstory drift response of buildings", PEER Report 2009/01 College of Engineering University of California, Berkeley.
  24. Housner, G.W. (1952), "Spectrum intensities of strong motion earthquakes", Proceedings of Symposium of earthquake and blast effects on structures, EERI, Los Angeles, California.
  25. Jayaram, N., Mollaioli, F., Bazzurro, P., De Sortis, A. and Bruno, S. (2010), "Prediction of structural response of reinforced concrete frames subjected to earthquake ground motions", 9th U.S. National and 10th Canadian Conference on Earthquake Engineering, Toronto, Canada.
  26. Krawinkler, H. (1987), "Performance assessment of steel components", Earthq. Spectra, 3(1), 27-41. https://doi.org/10.1193/1.1585417
  27. Lopez-Almansa, F., Yazgan, A. and Benavent-Climent, A. (2013), "Design energy input spectra for high seismicity regions based on turkish registers", Bull. Earthq. Eng., 11(4), 885-912. https://doi.org/10.1007/s10518-012-9415-2
  28. Lucchini, A., Mollaioli, F. and Monti, G. (2011), "Intensity measures for response prediction of a torsional building subjected to bi-directional earthquake ground motion", Bull. Earthq. Eng., 9(5), 1499-1518. https://doi.org/10.1007/s10518-011-9258-2
  29. Luco, N., Manuel, L, Baldava, S. and Bazzurro, P. (2005), "Correlation of damage of steel moment-resisting frames to a vector-valued ground motion parameter set that includes energy demands", Proceedings of the 9th International Conference on Structural Safety and Reliability, ICOSSAR05.
  30. Manfredi, G. (2001), "Evaluation of seismic energy demand", Earthq. Eng. Struct. Dyn., 30(4), 485-499. https://doi.org/10.1002/eqe.17
  31. Decanini, L.D. and Mollaioli, F. (2001), "An energy-based methodology for the assessment of seismic demand", Soil Dyn. Earthq. Eng., 21(2), 113-137. https://doi.org/10.1016/S0267-7261(00)00102-0
  32. McCabe, S.L. and Hall, W.J. (1989), "Assessment of seismic structural damage", J. Struct. Eng., 115(9), 2166-2183. https://doi.org/10.1061/(ASCE)0733-9445(1989)115:9(2166)
  33. Mollaioli, F., Bruno, S., Decanini, L. and Saragoni, R. (2011), "Correlation between energy and displacment demand for performance-based seismic engineering", Pure Appl. Geophys., 168(2011), 237-259. https://doi.org/10.1007/s00024-010-0118-9
  34. Yakut, A. and Yilmaz, H. (2008), "Correlation of deformation demands with ground motion intensity", J. Struct. Eng., 134(12), 1818-1828. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:12(1818)
  35. Mollaioli, F., Lucchini, A., Cheng, Y. and Monti, G. (2013), "Intensity measures for the seismic response prediction of base-isolated buildings", Bull. Earthq. Eng., 11(5), 1841-1866. https://doi.org/10.1007/s10518-013-9431-x
  36. Neter, J., Kutner, M.H., Nachtsheim, C.J. and Wasserman, W. (1996), Applied linear statistical models, MacGraw-Hill, Boston, Massachusetts, USA.
  37. Teran-Gilmore, A. (1996), "Performance-based earthquake-resistant design of framed buildings using energy concepts", Ph.D. Dissertation, Department of Civil Engineering, University of California at Berkeley.
  38. Uang, C.M. and Bertero, V.V. (1990), "Evaluation of seismic energy in structures", Earthq. Eng. Struct. Dyn., 19(1), 77-90. https://doi.org/10.1002/eqe.4290190108

피인용 문헌

  1. Application of a Monte-Carlo simulation approach for the probabilistic assessment of seismic hazard for geographically distributed portfolio vol.45, pp.4, 2016, https://doi.org/10.1002/eqe.2667
  2. Hysteresis and Soil Site Dependent Input and Hysteretic Energy Spectra for Far-Source Ground Motions vol.2016, 2016, https://doi.org/10.1155/2016/1548319
  3. Energy based design of a novel timber-steel building vol.15, pp.4, 2015, https://doi.org/10.12989/eas.2018.15.4.351
  4. A new practical equivalent linear model for estimating seismic hysteretic energy demand of bilinear systems vol.70, pp.3, 2015, https://doi.org/10.12989/sem.2019.70.3.289
  5. Ground-motion prediction equations for constant-strength and constant-ductility input energy spectra vol.18, pp.1, 2015, https://doi.org/10.1007/s10518-019-00725-x
  6. Multivariate Joint Probability Function of Earthquake Ground Motion Prediction Equations Based on Vine Copula Approach vol.2020, pp.None, 2015, https://doi.org/10.1155/2020/1697352
  7. Efficiency of Intensity Measures Considering Near- and Far-Fault Ground Motion Records vol.11, pp.6, 2015, https://doi.org/10.3390/geosciences11060234
  8. Characterization of Dissipated Energy Demand vol.147, pp.None, 2021, https://doi.org/10.1016/j.soildyn.2021.106725
  9. Cumulative Structural Damage Due to Low Cycle Fatigue: An Energy-Based Approximation vol.25, pp.12, 2021, https://doi.org/10.1080/13632469.2019.1692736
  10. Post-earthquake fast damage assessment using residual displacement and seismic energy: Application to Mexico City vol.37, pp.4, 2015, https://doi.org/10.1177/87552930211021872