초록
본 논문은 자체 개발한 관성측정장치의 가속도, 각속도, 지자기계 데이터를 이용하여 보행거리를 측정하는 시스템 개발에 관한 것이다. 관성센서들의 오프셋 및 이득 오차를 최소화하기 위하여 9축의 자유도를 갖는 지그를 제작하였으며, 이를 이용하여 캘리브레이션을 수행하였다. 보행거리의 정확한 측정을 위하여, 기울기 하강법을 이용하여 가속도계의 중력성분 제거 및 보행패턴 분석을 통한 드리프트 성분을 제거하였다. 최종적으로 보정된 가속도 데이터의 이중적분을 통하여 보행거리를 측정하였다. 시스템의 성능 평가를 위하여, 실내 직선 10m 직선 보행에 대하여 캘리브레이션 전, 후 오차 개선 비율를 비교하였으며, 간단한 보행에 대해 Vicon과의 비교 실험을 수행하였다. 직선 보행에 대해서는 x, y, z축 각각에 대하여 $31.4{\pm}14.38%$(mean${\pm}$S.D.), $78.64{\pm}10.84%$ 및 $69.71{\pm}26.25%$ 개선이 되었음을 확인하였으며, Vicon과의 비교 실험 결과 x, y, z축 각각에 대하여 0.1m, 0.16m, 0.12m의 오차를 얻을 수 있었다.
In this paper, we present an inertial sensor-based gait distance measurement system using accelerometer, gyroscope, and magnetometer. To minimize offset and gain error of inertial sensors, we performed the calibration using the self-made calibration jig with 9 degrees of freedom. For measuring accurate gait distance, we used gradient descent algorithm to remove gravity error and used analysis of gait pattern to remove drift error. Finally, we measured a gait distance by double-integration of the error-removed acceleration data. To evaluate the performance of our system, we walked 10m in a straight line indoors to observe the improvement of removing error which compared un-calibrated to calibrated data. Also, the gait distance measured by the system was compared to the measurement of the Vicon motion capture system. The evaluation resulted in the improvement of $31.4{\pm}14.38%$(mean${\pm}$S.D.), $78.64{\pm}10.84%$ and $69.71{\pm}26.25%$ for x, y and z axis, respectively when walked in a straight line, and a root mean square error of 0.10m, 0.16m, and 0.12m for x, y and z axis, respectively when compared to the Vicon motion capture system.