Geomechanics and Engineering

  • 제8권1호
  • /
  • Pages.53-66
  • /
  • 2015
  • /
  • 2005-307X(pISSN)
  • /
  • 2092-6219(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Unconfined compressive strength of PET waste-mixed residual soils

  • Zhao, Jian-Jun (State Key Laboratory of Geohazard Prevention and Geoenvironment Protection (Chengdu University of Technology)) ;
  • Lee, Min-Lee (State Key Laboratory of Geohazard Prevention and Geoenvironment Protection (Chengdu University of Technology)) ;
  • Lim, Siong-Kang (Faculty of Engineering and Science, Universiti Tunku Abdul Rahman) ;
  • Tanaka, Yasuo (Faculty of Engineering and Science, Universiti Tunku Abdul Rahman)
  • 투고 : 2014.05.26
  • 심사 : 2014.09.02
  • 발행 : 2015.01.25
⟨ 이전 논문 다음 논문 ⟩

초록

Plastic wastes, particularly polyethylene terephthalate (PET) generated from used bottled water constitute a worldwide environmental issue. Reusing the PET waste for geotechnical applications not only reduces environmental burdens of handling the waste, but also improves inherent engineering properties of soil. This paper investigated factors affecting shear strength improvement of PET-mixed residual soil. Four variables were considered: (i) plastic content; (ii) plastic slenderness ratio; (iii) plastic size; and (iv) soil particle size. A series of unconfined compression tests were performed to determine the optimum configurations for promoting the shear strength improvement. The results showed that the optimum slenderness ratio and PET content for shear strength improvement were 1:3 and 1.5%, respectively. Large PET pieces (i.e., $1.0cm^2$) were favorable for fine-grained residual soil, while small PET pieces (i.e., $0.5cm^2$) were favorable for coarse-grained residual soil. Higher shear strength improvement was obtained for PET-mixed coarse-grained residual soil (148%) than fine-grained residual soils (117%). The orientation of plastic pieces in soil and frictional resistance developed between soil particles and PET surface are two important factors affecting the shear strength performance of PET-mixed soil.

키워드

과제정보

연구 과제 주관 기관 : Chengdu University of Technology, National Basic Research Program of China

참고문헌

  1. Ahmed, A., Ugai, K. and Kamei, T. (2011), "Investigation of recycled gypsum in conjunction with waste plastic trays for ground improvement", Constr. Build. Mater., 25(1), 208-217. https://doi.org/10.1016/j.conbuildmat.2010.06.036
  2. Al-Refeai, T.O. (1991), "Behaviour of granular soils reinforced with discrete randomly oriented inclusions", Geotext. and Geomembranes., 10(4), 319-333. https://doi.org/10.1016/0266-1144(91)90009-L
  3. Al-Salem, S.M., Lettieri, P. and Baeyens, J. (2009), "Recycling and recovery routes of plastic solid waste (PSW): A review", Waste Manage., 29(10), 2625-2643. https://doi.org/10.1016/j.wasman.2009.06.004
  4. Ameta, N.K., Purohit, D.G.M. and Wayal, A.S. (2009), "Behaviour of square footing on dune sand reinforced with nylon fiber", Int. J. Geotech. Eng., 3(2), 313-317. https://doi.org/10.3328/IJGE.2009.03.02.313-317
  5. ASTM (2006), ASTM D 2166-06, Standard Test Method for Unconfined Compressive Strength of Cohesive Soil, American Society for Testing and Materials.
  6. British Standard (2012), BS 527-1, Plastics. Determination of Tensile Properties: General Principles, British Standards Institution.
  7. Bueno, B.S. (1997), "The mechanical response of reinforced soils using short randomly distributed plastic strips", In: Recent Developments in Soil and Pavement Mechanics, (Almeida Ed.), Balkema, Rotterdam, The Netherlands, pp. 401-407.
  8. Choi, Y.W., Moon, D.J., Chung, J.S. and Cho, S.K. (2005), "Effects of waste PET bottles aggregate on the properties of concrete", Cement Concrete Res., 35(4), 776-781. https://doi.org/10.1016/j.cemconres.2004.05.014
  9. Choudhary, A.K., Jha, J.N. and Gill, K.S. (2010), "A study on CBR behavior of waste plastic strip reinforced soil", Emirates J. Eng. Res., 15(1), 51-57.
  10. Consoli, N.C., Montardo, J.P., Prietto, P.D.M. and Pasa, G.S. (2002), "Engineering behavior of a sand reinforced with plastic waste", J. Geotech. Geoenviron. Eng., 128(6), 462-472. https://doi.org/10.1061/(ASCE)1090-0241(2002)128:6(462)
  11. Consoli, N.C., Vendruscolo, M.A., Fonini, A. and Dalla Rosa, F. (2009), "Fiber reinforcement effects on sand considering a wide cementation range", Geotext. Geomembr., 27(3), 196-203. https://doi.org/10.1016/j.geotexmem.2008.11.005
  12. Deb, K. and Konai, S. (2014), "Bearing capacity of geotextile-reinforced sand with varying fine fraction", Geomech. Eng., Int. J., 6(1), 33-45. https://doi.org/10.12989/gae.2014.6.1.033
  13. Frigione, M. (2010), "Recycling of PET bottles as fine aggregate in concrete", Waste Manage., 30(6), 1101-1106. https://doi.org/10.1016/j.wasman.2010.01.030
  14. Hejazi, S.M., Sheikhzadeh, M., Abtahi, S.M. and Zadhoush, A. (2012), "A simple review of soil reinforcement by using natural and synthetic fibers", Constr. Build. Mater., 30, 100-116. https://doi.org/10.1016/j.conbuildmat.2011.11.045
  15. Mastellone, M.L. (1999), "Thermal treatments of plastic wastes by means of fluidized bed reactors", Ph.D. Thesis, Department of Chemical Engineering, Second University of Naples, Italy.
  16. Neopaney, M., Ugyen, Wangchuk, K. and Tenzin, S. (2012), "Stabilization of soil by using plastic wastes", Int. J. Emerg. Trends Eng. Dev., 2(2), 461-466.
  17. Nguyen Ngoc, U. and Schnitzer, H. (2009), "Sustainable solutions for solid waste management in Southeast Asian countries", Waste Manage., 29(6), 1982-1995. https://doi.org/10.1016/j.wasman.2008.08.031
  18. Omine, K., Ochiai, H., Yasufuku, N. and Kato, T. (1996), "Effect of plastic wastes in improving cement-treated soils", Proceedings of the 2nd International Congress on Environmental Geotechnics, Osaka, Japan, November.
  19. Pacheco-Torgal, F., Fing, Y. and Jalali, S. (2012), "Properties and durability of concrete containing polymeric wastes (tyre rubber and polyethylene terephthalate bottles): An overview", Constr. Build. Mater., 30, 714-724. https://doi.org/10.1016/j.conbuildmat.2011.11.047
  20. Sharma, H.D. and Reddy, K.R. (2004), Geoenvironmental Engineering: Site Remediation, Waste Containment, and Emerging Waste Management Technologies, John Wiley & Sons, Inc., New Jersey, NY, USA.
  21. Silva, R.V., Brito, J. de and Saikia, N. (2012), "Influence of curing conditions on the durability-related performance of concrete made with selected plastic waste aggregates", Cement Concrete Comp., 35(1), 23-31. https://doi.org/10.1016/j.cemconcomp.2012.08.017
  22. Sivakumar Babu, G.L. and Vasudevan, A.K. (2008), "Strength and stiffness response of coir reinforced tropical soils", J. Mater. Civ. Eng. ASCE, 20(9), 571-577. https://doi.org/10.1061/(ASCE)0899-1561(2008)20:9(571)
  23. Sivakumar Babu, G.L. and Chouksey, S.K. (2011), "Stress-strain response of plastic waste mixed soil", Waste Manage., 31(3), 481-488. https://doi.org/10.1016/j.wasman.2010.09.018
  24. Tandel, Y.K., Solanki, C.H. and Desai, A.K. (2014), "Field behaviour geotextile reinforced sand column", Geomech. Eng., Int. J., 6(2), 195-211. https://doi.org/10.12989/gae.2014.6.2.195
  25. Troschinetz, A.M. and Mihelcic, J.R. (2009), "Sustainable recycling of municipal solid waste in developing countries", Waste Manage., 29(2), 915-923. https://doi.org/10.1016/j.wasman.2008.04.016
  26. Yoon, Y.W., Heo, S.B. and Kim, K.S. (2008), "Geotechnical performance of waste tires for soil reinforcement from chamber tests", J. Geotext. Geomembr., 26(1), 100-107. https://doi.org/10.1016/j.geotexmem.2006.10.004

피인용 문헌

  1. Reinforcing Effect of Polypropylene Waste Strips on Compacted Lateritic Soils vol.12, pp.22, 2015, https://doi.org/10.3390/su12229572
  2. Effect of Recycled Polyethylene Terephthalate Strips on the Mechanical Properties of Cement-Treated Lateritic Sandy Soil vol.12, pp.23, 2015, https://doi.org/10.3390/su12239801
  3. Effect of Polypropylene Fibers on the Shear Strength-Dilation Behavior of Compacted Lateritic Soils vol.13, pp.22, 2015, https://doi.org/10.3390/su132212603
  4. A Study on the Combined Effects of Silica Fume Particles and Polyethylene Terephthalate Fibres on the Mechanical and Microstructural Characteristics of Cemented Sand vol.7, pp.4, 2015, https://doi.org/10.1007/s40891-021-00340-4