Structural Engineering and Mechanics

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Thermoelastic analysis for a slab made of a thermal diode-like material

  • Darwish, Feras H. (Aeronautical Engineering Department, Jordan University of Science and Technology) ;
  • Al-Nimr, Mohammad A. (Mechanical Engineering Department, Jordan University of Science and Technology) ;
  • Hatamleh, Mohammad I. (Mechanical Engineering Department, Jordan University of Science and Technology)
  • Received : 2014.01.08
  • Accepted : 2014.07.13
  • Published : 2015.02.25
⟨ Previous Next ⟩

Abstract

This research investigates the thermoelastic transient behavior of a thermally loaded slab made of a thermal diode-like material which has two directional thermal conductivity values (low and high). Finite difference analysis is used to obtain the elastic response of the slab based on the temperature solutions. It is found that the rate of heat transfer through the thickness of the slab decreases with reducing the ratio between the low and high thermal conductivity values (R). In addition, reducing R makes the slab less responsive to the thermal load when heated from the direction associated with the low thermal conductivity value.

Keywords

References

  1. Addam, A.M.A (2000), "Temperature and thermal stresses in a two layer slab under the effect of the hyperbolic heat conduction model", M.S. Thesis, Mechanical Engineering Department, Jordan University of Science and technology, Jordan.
  2. Al-Huniti, N.S. and Al-Nimr, M. (2000), "Behavior of thermal stresses in a rapidly-heated thin plate", J. Therm. Stress., 23, 293-307. https://doi.org/10.1080/014957300280335
  3. Al-Huniti, N.S., Al-Nimr, M.A. and Naji, M. (2001), "Dynamic response of a rod due to a moving heat source under the hyperbolic heat conduction model", J. Sound. Vib., 242, 629-640. https://doi.org/10.1006/jsvi.2000.3383
  4. Al-Nimr, M.A. and Al-Huniti, N.S. (2000), "Transient thermal stresses in a thin elastic plate due to a rapid dual-phase-lag heating", J. Therm. Stress., 23, 731-746. https://doi.org/10.1080/01495730050192383
  5. Al-Nimr, M.A. and Abou-Arab, T.W. (1994), "Transient temperature distribution within a flat sheet during the welding process-analytical solution", Heat Transf. Eng., 15, 27-33. https://doi.org/10.1080/01457639408939815
  6. Boley, B. and Weiner, J. (1985), Theory of Thermal Stresses, Krieger, Florida.
  7. Brischetto, S.R., Leetsch, E., Carrera, T. and Wallmersperger, B. (2008), "Thermo-Mechanical bending of functionally graded plates", J. Therm. Stress., 31, 286-308. https://doi.org/10.1080/01495730701876775
  8. Darwish, F.H., AL-Nimr, M.A. and AL-Hunti, N.S. (2012), "Transient response of a clamped slab under pressure and thermal loads", J. Therm. Stress., 35, 470-484. https://doi.org/10.1080/01495739.2012.663693
  9. Feng, W.J., Pan, E. and Wang, X. (2008), "Stress analysis of a penny-shaped crack in a magneto-electrothermo-elastic layer under uniform heat flow and shear loads", J. Therm. Stress., 31, 497-514. https://doi.org/10.1080/01495730801912744
  10. Hata, T. (2001), "Thermal stresses focusing effect following rapid non uniform heating of long cylindrical rods", J. Therm. Stress., 24(2), 93-104. https://doi.org/10.1080/01495730150500415
  11. Hu, B., Li, H. and Xie, B.S. (2005), "Heat conduction in a one-dimensional Yukawa chain", Europhys. Lett., 69, 358. https://doi.org/10.1209/epl/i2004-10362-7
  12. Iesan, D. (2008), "Thermo-elastic deformation of porous Cosserat beams", J. Therm. Stress., 31, 823-847. https://doi.org/10.1080/01495730802194409
  13. Kreith, F. and Black, W.A. (1980), Basic Heat Transfer, Harper and Row, New York, U.S.A.
  14. Nowacki, W. (1986), Thermoelasticity, Second Edition, Pergamon Press, PWN, Warsaw.
  15. Shahani, A.R. and Bashusqeh, S.M. (2013), "Analytical solution of the coupled thermo-elasticity problem in a pressurized sphere", J. Therm. Stress., 36, 1283-1307. https://doi.org/10.1080/01495739.2013.818889
  16. Suh, C. and Burger, C. (1998), "Thermoelastic modeling of laser-induced stress waves in plates", J. Therm. Stress., 21, 829-847. https://doi.org/10.1080/01495739808956179
  17. Sumi, N., Hetnarski, R.B. and Noda, N. (1987), "Transient thermal stresses due to a local source of heat moving over the surface of an infinite elastic slab", J. Therm. Stress., 10, 83-96. https://doi.org/10.1080/01495738708926997
  18. Tall, L. (1964), "Residual stresses in welded plates-a theoretical study", Weld. J., 43, 10-23.
  19. Terraneo, M., Peyrard, M. and Casati, G. (2002), "Controlling the energy flow in nonlinear lattices: a model for a thermal rectifier", Phys. Rev. Lett., 88, 094302. https://doi.org/10.1103/PhysRevLett.88.094302
  20. Tzou, D.Y. (1997), Macro-to Microscale Heat Transfer, Taylor and Francis, Washington, DC.
  21. Ugural, A.C. (1999), Stresses in Plates and Shells, McGraw Hill, New York, U.S.A.
  22. Wang, B., Li, L. and Casati, G. (2004), "Thermal diode: rectification of heat flux", Phys. Rev. Lett., 93, 184301. https://doi.org/10.1103/PhysRevLett.93.184301
  23. Wang, B., Li, L. and Casati, G. (2006), "Negative differential thermal resistance and thermal transistor", Phys. Lett., 88, 143501.
  24. Xu, Y., Zhou, D. and Liu, K. (2010), "Three-dimensional thermoelastic analysis of rectangular plates with variable thickness subjected to thermomechanical loads", J. Therm. Stress., 33, 1136-1155. https://doi.org/10.1080/01495739.2010.510723

Cited by

  1. Thermoelastic response of the solid boundaries of a semi-infinite rectangular micro-channel flow vol.93, 2016, https://doi.org/10.1016/j.applthermaleng.2015.10.001
  2. Multi-Beams modelling for high-rise buildings subjected to static horizontal loads vol.75, pp.3, 2020, https://doi.org/10.12989/sem.2020.75.3.283