DOI QR코드

DOI QR Code

Strength evaluation of concrete with fly ash and GGBFS as cement replacing materials

  • Chore, H.S. (Department of Civil Engineering, Datta Meghe College of Engineering) ;
  • Joshi, M.P. (Department of Civil Engineering, Datta Meghe College of Engineering)
  • Received : 2015.09.30
  • Accepted : 2015.12.23
  • Published : 2015.09.25

Abstract

Concrete is the most widely used material of construction. Concrete gained the popularity as a construction material due to the easy availability of its component materials, the easy formability, strength and rigidity upon setting and curing.In construction industry, strength is the primary criterion in selecting a concrete for a particular application. Now a days, the substantial amount of waste materials, containing the properties of the Pozzolana, is being generated from the major industries; and disposal of such industrial wastes generated in abundance is also a serious problem from the environmental and pollution point of view. On this backdrop, efforts are made by the researchers for exploring the possible utilization of such waste materials in making the sustainable construction material. The present paper reports the experimental investigations to study the strength characterization of concrete made from the pozzolanic waste materials. For this purpose, the Pozzolanic materials such as fly ash and ground granulated blast furnace slag were used as a cement replacing materials in conjunction with ordinary Portland cement. Equal amount of these materials were used in eight trial mixes with varying amount of cement. The water cement ratio was also varied. The chemical admixture was also added to improve the workability of concrete. The compressive strengths for 7, 28, 40 and 90 days' were evaluated whereas the flexural and tensile strengths corresponding to 7, 28 and 40 days were evaluated. The study corroborates that the pozzolanic materials used in the present investigation along with the cement can render the sustainable concrete.

Keywords

References

  1. Aggarwal, V. and Gupta, S.M. (2010), "Concrete durability through high volume fly ash concrete (HVFC):A literature review", Int. J. Eng. Sci. Tech., 2(9), 4473-4477.
  2. Aggarwal, V. and Gupta, S.M. (2012), "High volume fly ash concrete: a green concrete", J. Envir. Res. Develop., 6(3A).
  3. Alam, J. and Akhtar, M.N. (2011), "Fly ash utilization in different sectors in Indian scenario", Int. J. Emerg. Trend. Eng. Develop., 1(1), 1-14.
  4. Babu, G. and Kumar, K. (2000), "Efficiency of GGBFS in concrete", Cement Concrete Res., 30(7), 1031-1136. https://doi.org/10.1016/S0008-8846(00)00271-4
  5. Bijen, J. (1996), "Benefits of slag and fly ash", Constr. Build. Mater., 10(5), 309-314. https://doi.org/10.1016/0950-0618(95)00014-3
  6. Daube, J. and Bakker, R. (1986), "Portland blast furnace slag cement: a review", American Society for Testing and Materials (Blended cement, ASTM STP- 897), Ed. G. Frohnsdorff, Philadelphia, 5-14.
  7. Dhadse, S., Pramila, Kumari and Bhagia, L.J. (2008), "Fly ash characterization, utilization and government initiatives in India", J. Sci. Ind. Res., 67, 11-18.
  8. Dubovoy, V.S., Gebler, S.H. and Klieger, P. (1986), "Effects of Ground Granulated Blast Furnace slag on some properties of pastes, mortars and concretes", American Society for Testing and Materials(Blended cement, ASTM STP- 897), Ed. G. Frohnsdorff, Philadelphia, 29-48.
  9. Olorunsogo, F.T. and Wainwright, P.J. (1998), "Effect of GGBFS particle-size distribution on mortar compressive strength" , J. Mater. Civ. Eng., 10, 180-187. https://doi.org/10.1061/(ASCE)0899-1561(1998)10:3(180)
  10. Frigione, G. (1986), "Manufacture and characteristics of Portland blast furnace slag cements", American Society for Testing and Materials(Blended cement, ASTM STP- 897), Ed. G. Frohnsdorff, Philadelphia, 15-28.
  11. Gardner, L.J. and Susan, A. (2015), "Characterization of magnesium potassium phosphate cements blended with fly ash and ground granulated blast furnace slag", Cement Concrete Res., 74,78-87. https://doi.org/10.1016/j.cemconres.2015.01.015
  12. Hooton, R.D. (2000), "Canadian use of ground granulated blast furnace slag (GGBFS) as a supplementary cementing material for enhanced performance of concrete", Can. J. Civil Eng., 27, 754-760. https://doi.org/10.1139/l00-014
  13. Kohubu, M. (1969), "Fly ash and fly ash cement", Proceedings of the Fifth International Symposium on the Chemistry of Cement, Cement Association of Japan, Tokyo, IV, 75-105.
  14. Li, D.J., Shen, Y. and Chen, L. (2000), "Study of properties on fly ash-slag complex cement", Cement Concrete Res., 30 (3), 1381-1387. https://doi.org/10.1016/S0008-8846(00)00360-4
  15. Malhotra, V.M. (1999), "Making concrete 'Greener'with fly ash", Information Portal International Concrete Research and Information Portal Concrete International, 21(5), 61-66.
  16. Meusel, J.W. and Rose, J.H. (1983), "Production of granulated blast furnace slag at sparrows point, and the workability and strength potential of concrete incorporating the slag", American Concrete Institute (SP-79), 867-90.
  17. Obla, K.H. and Russell, L.H. (2003), "Properties of concrete containing ultra-fine fly ash", ACIMater. J., 100(5), 426-433.
  18. Oluokun, F.A. (1994), "Fly ash concrete mix design and the water-cement ratio law", ACI Mater. J., 91(4), 362-371.
  19. Osborne, G.J. (1999), "Durability of Portland blast furnace slag cement concrete", Cement Concrete Comp., 21(1), 11-21. https://doi.org/10.1016/S0958-9465(98)00032-8
  20. Pal, S.C.,Mukherjee, A. and Pathak, S.R. (2002), "Corrosion behavior of reinforcement in slag concrete", ACI Mater. J., 99(6), 521-527.
  21. Silva, P. and Brito, J. (2013), "Electrical resistivity and capillarity of self-compacting concrete with incorporation of fly ash and limestone filler" , Adv. Concrete Constr., 1(1), 65-84. https://doi.org/10.12989/acc.2013.1.1.065
  22. Sunil, B.M., Manjunatha, L.S., Ravi, L. and Yaragal, S.C. (2015), "Potential use of mine tailings and fly ash in concrete", Adv. Concrete Constr., 3(1), 55-69. https://doi.org/10.12989/acc.2015.3.1.055
  23. Tamilarasan, V.S. and Perumal, P. (2012), "Workability studies on concrete with GGBFS as a replacement material for cement with and without super-plasticizers", Int. J. Adv. Res. Eng. Tech. (IJARET), 3(2), 11-21.
  24. Wang, P.Z. and Trettin, R. (2005), "Effect of fineness and particle size distribution of granulated blast-furnace slag on the hydraulic reactivity in cement systems", Adv. Cement Res., 17(4), 161-167. https://doi.org/10.1680/adcr.2005.17.4.161
  25. Wang, Q. and Miao, M. (2012), "The influence of high-temperature curing on the hydration characteristics of a cement-GGBS binder", Adv. Cement Res., 24(1), 33-40. https://doi.org/10.1680/adcr.2012.24.1.33
  26. Wimpenny, D.E., Ellis, C. and Reeves, C.M. (1989), "Development of strength and elastic properties in slag cement concretes under low temperature curing conditions", Proc. 3rd International Conference on fly ash, silica fume, slag and natural Pozzolanas in concrete,Trondheim, Norway, 2.
  27. Yang, W. and Li, Q. (2012), "On effects of fly ash as a partial replacement of cement on concrete strength", Appl. Mech. Mater., 204-208.
  28. Ge, Z. and Wang, K. (2009), "Modified heat of hydration and strength models for concrete containing fly ash and slag", Comput. Concrete, 6(1), 19-40. https://doi.org/10.12989/cac.2009.6.1.019

Cited by

  1. Performance of bricks and brick masonry prism made using coal fly ash and coal bottom ash vol.4, pp.4, 2016, https://doi.org/10.12989/acc.2016.4.4.231
  2. The effect of attack of chloride and sulphate on ground granulated blast furnace slag concrete vol.4, pp.2, 2015, https://doi.org/10.12989/acc.2016.4.2.107
  3. Properties of concrete incorporating sand and cement with waste marble powder vol.4, pp.2, 2015, https://doi.org/10.12989/acc.2016.4.2.145
  4. Partial replacement of fine aggregates with laterite in GGBS-blended-concrete vol.4, pp.3, 2015, https://doi.org/10.12989/acc.2016.4.3.221
  5. Microstructural properties of hardened cement paste blended with coal fly ash, sugar mill lime sludge and rice hull ash vol.5, pp.3, 2015, https://doi.org/10.12989/acc.2017.5.3.289
  6. Permeability and mechanical properties of binary and ternary cementitious mixtures vol.5, pp.5, 2015, https://doi.org/10.12989/acc.2017.5.5.423
  7. Effect of different binders on cold-bonded artificial lightweight aggregate properties vol.9, pp.2, 2020, https://doi.org/10.12989/acc.2020.9.2.183
  8. Performance of eco-friendly mortar mixes against aggressive environments vol.10, pp.3, 2020, https://doi.org/10.12989/acc.2020.10.3.237
  9. Thermomechanical behavior of alkali-activated slag/fly ash composites with PVA fibers exposed to elevated temperatures vol.11, pp.1, 2015, https://doi.org/10.12989/acc.2021.11.1.011
  10. Ecofriendly building blocks using foamed concrete with ground granulated blast furnace slag vol.14, pp.4, 2015, https://doi.org/10.1080/19397038.2020.1836064
  11. An Experimental Study of the Effects of Low-Calcium Fly Ash on Type II Concrete vol.4, pp.4, 2021, https://doi.org/10.3390/ceramics4040043