Geomechanics and Engineering

  • 제9권5호
  • /
  • Pages.645-667
  • /
  • 2015
  • /
  • 2005-307X(pISSN)
  • /
  • 2092-6219(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Stress field interference of hydraulic fractures in layered formation

  • Zhu, Haiyan (State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University) ;
  • Zhang, Xudong (State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University) ;
  • Guo, Jianchun (State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University) ;
  • Xu, Yaqin (Safety Environment Quality Surveillance&Inspection Institude, CNPC Chuanqing Drilling Engineering Company Limited) ;
  • Chen, Li (Luming company, Shengli Oil Field) ;
  • Yuan, Shuhang (Research Institute of Engineering and Technology, PetroChina Southwest Oil and Gas Fields Company) ;
  • Wang, Yonghui (Research Institute of Petroleum Exploration and Development-Langfang) ;
  • Huang, Jingya (State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University)
  • 투고 : 2014.10.31
  • 심사 : 2015.07.14
  • 발행 : 2015.11.25
⟨ 이전 논문 다음 논문 ⟩

초록

Single treatment and staged treatments in vertical wells are widely applied in sandstone and mudstone thin interbedded (SMTI) reservoir to stimulate the reservoir. The keys and difficulties of stimulating this category of formations are to avoid hydraulic fracture propagating through the interface between shale and sand as well as control the fracture height. In this paper, the cohesive zone method was utilized to build the 3-dimensional fracture dynamic propagation model in shale and sand interbedded formation based on the cohesive damage element. Staged treatments and single treatment were simulated by single fracture propagation model and double fractures propagation model respectively. Study on the changes of fracture vicinity stress field during propagation is to compare and analyze the parameters which influence the interfacial induced stresses between two different fracturing methods. As a result, we can prejudge how difficult it is that the fracture propagates along its height direction. The induced stress increases as the pumping rate increasing and it changes as a parabolic function of the fluid viscosity. The optimized pump rate is $4.8m^3/min$ and fluid viscosity is $0.1Pa{\cdot}s$ to avoid the over extending of hydraulic fracture in height direction. The simulation outcomes were applied in the field to optimize the treatment parameters and the staged treatments was suggested to get a better production than single treatment.

키워드

참고문헌

  1. Anderson, G.D. (1981), "Effects of friction on hydraulic fracture growth near unbonded interfaces in rocks", Soc. Petrol. Eng. J., 21(1), 21-29. https://doi.org/10.2118/8347-PA
  2. Chen, Z.X., Chen, M., Jin, Y. and Huang, R.Z. (1997), "Determination of rock fracture toughness and its relationship with acoustic velocity", Int. J. Rock Mech. Min. Sci., 34(3), 49.e1-e11. https://doi.org/10.1016/S1365-1609(97)00068-3
  3. Chen, Z., Bunger, A.P., Zhang, X. and Jeffrey, R.G. (2009), "Cohesive zone finite element-based modeling of hydraulic fractures", Acta Mechanica Solida Sinica, 22(5), 443-452. https://doi.org/10.1016/S0894-9166(09)60295-0
  4. Chen, W.Z., Wu, G.J. and Jia, S. (2010), The Application of ABAQUS in Tunnel and Underground Engineering, China Waterpower Press.
  5. Cheng, Y. (2009), Boundary Element Analysis of the Stress Distribution Around Multiple Fractures: Implications for the Spacing of Perforation Clusters of Hydraulically Fractured Horizontal Wells, Society of Petroleum Engineers.
  6. Gu, H. and Weng, X. (2010), "Criterion for fractures crossing frictional interfaces at non-orthogonal angles", Proceedings of the 44th US Rock Mechanics Symposium and 5th US-Canada Rock Mechanics Symposium, American Rock Mechanics Association.
  7. He, M. and Hutchinson, J.W. (1989), "Kinking of a crack out of an interface", J. Appl. Mech., 56(2), 270-278. https://doi.org/10.1115/1.3176078
  8. Olson, J.E. and Wu, K. (2012), Sequential vs. Simultaneous Multizone Fracturing in Horizontal Wells: Insights From a Non-Planar, Multifrac Numerical Model, Society of Petroleum Engineers.
  9. Palmer, I.D. (1993), "Induced stresses due to propped hydraulic fracture in coalbed methane wells", Low Permeability Reservoirs Symposium, Denver, CO, USA, April.
  10. Renshaw, C.E. and Pollard, D.D. (1995), "An experimentally verified criterion for propagation across unbounded frictional interfaces in brittle, linear elastic materials", Int. J. Rock Mech. Min. Sci. Geomech. Abstracts, 32(3), 237-249. https://doi.org/10.1016/0148-9062(94)00037-4
  11. Saberhosseini, S.E., Keshavarzi, R. and Ahangari, K. (2014), "A new geomechanical approach to investigate the role of in-situ stresses and pore pressure on hydraulic fracture pressure profile in vertical and horizontal oil wells", Geomech. Eng., Int. J., 7(3), 233-246. https://doi.org/10.12989/gae.2014.7.3.233
  12. Shin, D.H. and Sharma, M.M. (2014), "Factors controlling the simultaneous propagation of multiple competing fractures in a horizontal well", SPE Hydraulic Fracturing Technology Conference, The Woodlands, TX, USA, Feburary.
  13. Sneddon, I. (1946), "The distribution of stress in the neighbourhood of a crack in an elastic solid", Proceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences, 187(1009), 229-260. https://doi.org/10.1098/rspa.1946.0077
  14. Sneddon, I.N. and Elliot, H.A. (1946), "The opening of a Griffith crack under internal pressure", Quart. Appl. Math, 4(3), 262-267. https://doi.org/10.1090/qam/17161
  15. Soliman, M.Y., East, L.E. and Augustine, J.R. (2010), "Fracturing design aimed at enhancing fracture complexity", SPE EUROPEC/EAGE Annual Conference and Exhibition, Barcelona, Spain, June.
  16. Warpinski, N.R. and Branagan, P.T. (1989), "Altered-stress fracturing", J. Petrol. Technol., 41(9), 990-997. https://doi.org/10.2118/17533-PA
  17. Warpinski, N.R. and Teufel, L.W. (1987), "Influence of geologic discontinuities on hydraulic fracture propagation (includes associated papers 17011 and 17074)", J. Petrol. Technol., 39(2), 209-220. https://doi.org/10.2118/13224-PA
  18. Wu, H. and Chudnovsky, A., Dudley, J.W. and Wong, G.K. (2004), "A map of fracture behavior in the vicinity of an interface", Gulf Rocks 2004 the 6th North America Rock Mechanics Symposium (NARMS), Houston, TX, USA, June.
  19. Yao, Y., Gosavi, S.V., Searles, K.H. and Ellison, T.K. (2010), "Cohesive fracture mechanics based analysis to model ductile rock fracture", Proceedings of the 44th US Rock Mechanics Symposium and 5th US-Canada Rock Mechanics Symposium, Salt Lake City, UT, USA, June.
  20. Zhu, H.Y., Deng, J.G., Chen, Z.J., An, F.C., Liu, S.J., Peng, C.Y., Wen, M. and Dong, G. (2013), "Perforation optimization of hydraulic fracturing of oil and gas well", Geomech. Eng., Int. J., 5(5), 463-483. https://doi.org/10.12989/gae.2013.5.5.463
  21. Zhu, H.Y., Deng, J.G., Zhao, J., Zhao, H., Liu, H.L. and Wang, T. (2014a), "Cementing failure of the casing-cement-rock interfaces during hydraulic fracturing", Comput. Concrete, Int. J., 14(1), 91-107. https://doi.org/10.12989/cac.2014.14.1.091
  22. Zhu, H.Y., Deng, J.G., Liu, S.J., Wen, M., Peng, C.Y., Li, J.R., Chen, Z.J., Hu, L.B., Lin, H. and Dong, G. (2014b), "Hydraulic fracturing experiments of highly deviated well with oriented perforation technique", Geomech. Eng., Int. J., 6(2), 153-172. https://doi.org/10.12989/gae.2014.6.2.153

피인용 문헌

  1. Multilayer stress field interference in sandstone and mudstone thin interbed reservoir vol.13, pp.5, 2016, https://doi.org/10.1088/1742-2132/13/5/775
  2. Effect of interface property on hydraulic fracture vertical propagation behavior in layered formation based on discrete element modeling vol.15, pp.4, 2018, https://doi.org/10.1088/1742-2140/aaa8ab
  3. Rock mechanics and wellbore stability in Dongfang 1-1 Gas Field in South China Sea vol.12, pp.3, 2015, https://doi.org/10.12989/gae.2017.12.3.465
  4. An experimental investigation on the tensile stiffness in layered rock interface using the digital image correlation technique vol.13, pp.2, 2015, https://doi.org/10.3233/sfc-200251
  5. Material constituents and mechanical properties and macro-micro-failure modes of tight gas reservoirs vol.38, pp.6, 2015, https://doi.org/10.1177/0144598720913069
  6. Experimental and Numerical Simulation of Interlayer Propagation Path of Vertical Fractures in Shale vol.9, pp.None, 2015, https://doi.org/10.3389/fenrg.2021.797105
  7. Numerical simulation and optimization of hydraulic fracturing operation in a sandstone-mudstone interbedded reservoir vol.14, pp.21, 2021, https://doi.org/10.1007/s12517-021-08506-0