Structural Monitoring and Maintenance

  • 제2권4호
  • /
  • Pages.399-418
  • /
  • 2015
  • /
  • 2288-6605(pISSN)
  • /
  • 2288-6613(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

A FRF-based algorithm for damage detection using experimentally collected data

  • Garcia-Palencia, Antonio (HNTB Corporation) ;
  • Santini-Bell, Erin (Department of Civil Engineering, University of New Hampshire) ;
  • Gul, Mustafa (Department of Civil and Enviromental Engineering, University of Alberta Canada) ;
  • Catbas, Necati (Department of Civil and Environmental and Construction Engineering, University of Central Florida)
  • 투고 : 2015.07.29
  • 심사 : 2015.11.27
  • 발행 : 2015.12.25
⟨ 이전 논문 다음 논문 ⟩

초록

Automated damage detection through Structural Health Monitoring (SHM) techniques has become an active area of research in the bridge engineering community but widespread implementation on in-service infrastructure still presents some challenges. In the meantime, visual inspection remains as the most common method for condition assessment even though collected information is highly subjective and certain types of damage can be overlooked by the inspector. In this article, a Frequency Response Functions-based model updating algorithm is evaluated using experimentally collected data from the University of Central Florida (UCF)-Benchmark Structure. A protocol for measurement selection and a regularization technique are presented in this work in order to provide the most well-conditioned model updating scenario for the target structure. The proposed technique is composed of two main stages. First, the initial finite element model (FEM) is calibrated through model updating so that it captures the dynamic signature of the UCF Benchmark Structure in its healthy condition. Second, based upon collected data from the damaged condition, the updating process is repeated on the baseline (healthy) FEM. The difference between the updated parameters from subsequent stages revealed both location and extent of damage in a "blind" scenario, without any previous information about type and location of damage.

키워드

과제정보

연구 과제 주관 기관 : National Science Foundation

참고문헌

  1. American Society of Civil Engineers (2013), http://www.infrastructurereportcard.org/bridges/. [Online] [Accessed July 2014].
  2. Burkett, J.L. (2005), Benchmark Studies for Structural Health Monitoring Using Analytical and Experimental Models, M.S. Thesis University of Central Florida.
  3. Caicedo, J.M. et al. (2006), Benchmark Problem for Bridge Health Monitoring: Definition Paper, San Diego, California, USA, s.n.
  4. Catbas, F.N., Gokce, H.B. and Gul, M. (2012), "A practical methodology for load rating of existing highway bridges: demonstration on reinforced concrete T-beam bridges", J. Bridge Eng., 17(4), 652-661, ASCE do http://dx.doi.org/10.1061/(ASCE)BE.1943-5592.0000284
  5. Catbas, F.N., Caicedo, J.M. and Dyke, S.J. (2006), Proceedings of the International Conference on Bridge Maintanance, Safety and Management, IABMS, July 16-19, 2006. Porto, Portugal, s.n.
  6. Chesne, S. and Deraemaeker, A. (2013), "Damage localization using transmissibility functions: A critical review", Mech. Syst. Signal Pr., 38(1), 569-584. https://doi.org/10.1016/j.ymssp.2013.01.020
  7. Computers and Structures, Inc. (2011), CSI Analysis Reference Manual for SAP2000, ETABS, SAFE and CSI Bridge, Berkeley, California, USA: Computers and Structures, Inc.
  8. Cruz, P.J. and Salgado, R. (2008), "Performance of vibration-based damage detection methods in bridges", Comput. -Aided Civil Infrastruct. Eng., 24(1), 62-79. https://doi.org/10.1111/j.1467-8667.2008.00546.x
  9. Davis, T. (2013), "Algorithm 930: FACTORIZE: An object-oriented linear system solver for MATLAB", ACM T. Math. Software, 39(4).
  10. Esfandiari, A., Bakhthiari-Nejad, F., Rahai, A. and Sanayei, M. (2009), "Structural model updating using frequency response function and quasi-linear sensitivity equation", J. Sound Vib., 326(1), 557-573. https://doi.org/10.1016/j.jsv.2009.07.001
  11. Ewins, D. J. (2000), Modal Testing: Theory, Practice and Application, 2nd Ed., Baldock, England: Research Studies Press.
  12. Fan, W. and Qiao, P. (2011), "Vibration-based damage identification methods: a review and comparative study", Struct. Health Monit., 10(1), 83-111. https://doi.org/10.1177/1475921710365419
  13. Fu, Y.Z., Lu, Z.R. and Liu, J.K. (2013), "Damage identification in plates using finite element model updating in time domain", J. Sound Vib., 332(1), 7018-7032. https://doi.org/10.1016/j.jsv.2013.08.028
  14. Gang, X., Chai, S., Allemang, J.R. and Lijun, L. (2014), "A new iterative model updating method using incomplete frequency response function data", J. Sound Vib., 333(1), 2443-2453. https://doi.org/10.1016/j.jsv.2013.12.008
  15. Garcia-Palencia, A.J. and Santini-Bell, E. (2013), "A two-step model updating algorithm for parameter identification of linear elastic damped structures", Comput. - Aided Civil Infrastruct. Eng., TBD, 28(7), 509-521. https://doi.org/10.1111/mice.12012
  16. Garcia-Palencia, A.J., Santini-Bell, E., Sipple, J.D. and Sanayei, M. (2014), "Structural model updating of an in-service bridge using dynamic data", Struct. Control Health Monit., 22(10), 1265-1281. https://doi.org/10.1002/stc.1742
  17. Gul, M. (2009), Investigation of Damage Detection Methodologies for Structural Health Monitoring, Ph. D. Dissertation, University of Central Florida, Orlando FL, USA.
  18. Gul, M. and Catbas, F.N. (2008), "Ambient vibration data analysis for structural identification and global condition assessment", J. Eng. Mech. - ASCE, 134(8), 650-662. https://doi.org/10.1061/(ASCE)0733-9399(2008)134:8(650)
  19. Hsieh, K.H., Halling, M.W. and Barr, P.J. (2006), "Overview of vibrational structural health monitoring with representative case studies", J. Bridge Eng., 11(6), 707-715. https://doi.org/10.1061/(ASCE)1084-0702(2006)11:6(707)
  20. Jafarkhani, R. and Masri, S.F. (2011), "Finite element model updating using evolutionary strategy for damage detection", Comput.-Aided Civil Infrastruct. Eng., 26(1), 207-224. https://doi.org/10.1111/j.1467-8667.2010.00687.x
  21. Kwon, K.S. and Ling, R.M. (2004), "Frequency selection method for FRF-based model updating", J. Sound Vib., 278(1), 285-306. https://doi.org/10.1016/j.jsv.2003.10.003
  22. Li, H., Huang, Y., Ou, J. and Bao, Y. (2011), "Fractal dimension-based damage detection method for beams with a uniform cross-section", Comput. -Aided Civil Infrastruct. Eng., 26(1), 190-206. https://doi.org/10.1111/j.1467-8667.2010.00686.x
  23. Link, M. (1993), Updating of analytical models-procedures and experience, s.l., s.n., 35-52.
  24. Maia, N.M., Almeida, R.A., Urgueira, A.P. and Sampaio, R.P. (2011), "Damage detection and quantification using transmissibility", Mech. Syst. Signal. Pr., 25(7), 2475-2483. https://doi.org/10.1016/j.ymssp.2011.04.002
  25. MathWorks Inc. (2011), Matlab Version 7.12 (R2011a), Natick MA, USA: s.n.
  26. Mendrok, K. and Uhl, T. (2010), "The application of modal filters for damage detection", Smart Struct. Syst., 6(2), 115-133. https://doi.org/10.12989/sss.2010.6.2.115
  27. Modak, S.V. (2014), "Model updating using uncorrelated modes", J. Sound Vib., 333(1), 2297-2322. https://doi.org/10.1016/j.jsv.2014.01.013
  28. Mottershead, J.E. and Friswell, M.I. (1993), "Model updating in structural dynamics: A survey", J. Sound Vib., 167(2), 347-375. https://doi.org/10.1006/jsvi.1993.1340
  29. Mottershead, J.E., Link, M. and Friswell, M.I. (2011), "The sensitivity method in finite element model updating: A tutorial", Mech. Syst. Signal Pr., 25(1), 2275-2296. https://doi.org/10.1016/j.ymssp.2010.10.012
  30. Panigrahi, S.K., Chakraverty, S. and Mishra, B.K. (2013), "Damage identification of multistory shear structure from sparse modal information", J. Comput. Civil Eng., 27(1), 1-9. https://doi.org/10.1061/(ASCE)CP.1943-5487.0000189
  31. Pascual, R., Golinval, J.C. and Razeto, M. (1996), "Testing of FRF based model updating methods using a general finite elements program", Proceedings of the International Conference of Noise and Vibration Engineering ISMA21.
  32. Rahmatalla, S., Eun, H.C. and Lee, E.T. (2012), "Damage detection from the variation of parameter matrices estimated by incomplete FRF data", Smart Struct. Syst., 9(1), 55-70. https://doi.org/10.12989/sss.2012.9.1.055
  33. Rytter, T. (1993), Vibration based inspection of civil engineering structure, Ph. D. Dissertation, Aalborg University, Denmark.
  34. Talebinejad, I., Fischer, C. and Ansari, F. (2011), "Numerical evaluation of vibration-based methods for damage assessment of cable-stayed bridges", Comput. - Aided Civil Infrastruct. Eng., 26(1), 239-251. https://doi.org/10.1111/j.1467-8667.2010.00684.x
  35. Thyagarajan, S.K., Schultz, S.J. and Pai, P.F. (1998), "Detecting structural damage using frequency response functions", J. Sound Vib., 210(1), 162-170. https://doi.org/10.1006/jsvi.1997.1308
  36. Tikhonov, A.N. and Arsenin, V.Y. (1977), Solutions of Ill-Posed Problems, New York: John Wiley & Sons.
  37. Wang, H. et al. (2014), "Finite element model updating of flexural structures based on modal parameters extracted from dynamic distributed macro-strain responses", J. Intell. Mat. Syst. Str., Volume 1045389X14523856. https://doi.org/10.1177/1045389X14523856
  38. Weber, B., Paultre, P. and Proulx, J. (2009), "Consistent regularization of nonlinear model updating for damage identification", Mech. Syst. Signal Pr., 23(6), 1965-1985. https://doi.org/10.1016/j.ymssp.2008.04.011

피인용 문헌

  1. Comparison of Damage Detection Methods Depending on FRFs within Specified Frequency Ranges vol.2017, 2017, https://doi.org/10.1155/2017/5821835
  2. A Novel Dense Full-Field Displacement Monitoring Method Based on Image Sequences and Optical Flow Algorithm vol.10, pp.6, 2015, https://doi.org/10.3390/app10062118
  3. Vibration Anatomy and Damage Detection in Power Transmission Towers with Limited Sensors vol.20, pp.6, 2015, https://doi.org/10.3390/s20061731
  4. Displacement Identification by Computer Vision for Condition Monitoring of Rail Vehicle Bearings vol.21, pp.6, 2015, https://doi.org/10.3390/s21062100