DOI QR코드

DOI QR Code

Development of high-performance heavy density concrete using different aggregates for gamma-ray shielding

  • Ouda, Ahmed S. (Housing and Building National Research Center (HBRC))
  • 투고 : 2014.05.03
  • 심사 : 2014.06.24
  • 발행 : 2014.06.25

초록

This study aimed to investigate the suitability of some concrete components for producing "high-performance heavy density concrete" using different types of aggregates that could enhances the shielding efficiency against ${\gamma}$-rays. 15 mixes were prepared using barite, magnetite, goethite and serpentine aggregates along with 10% silica fume, 20% fly ash and 30% blast furnace slag to total OPC content for each mix. The mixes were subjected to compressive strength at 7, 28 and 90 days. In some mixes, compressive strengths were also tested up to 90 days upon replacing sand with the fine portions of magnetite, barite and goethite. The mixes containing magnetite along with 10% SF reaches the highest compressive strength exceeding over M60 requirement by 14% after 28 days. Whereas, the compressive strength of concrete containing barite was very close to M60 and exceeds upon continuing for 90 days. Also, the compressive strength of high-performance concrete incorporating magnetite fine aggregate was significantly higher than that containing sand by 23%. On the other hand, concrete made with magnetite fine aggregate had higher physico-mechanical properties than that containing barite and goethite. High-performance concrete incorporating magnetite fine aggregate enhances the shielding efficiency against ${\gamma}$-rays.

키워드

참고문헌

  1. Akkurt, I. and Canakci, H. (2011), "Radiation attenuation of boron doped clay for 662, 1173 and 1332 keV gamma rays", Iran. J. Radiat. Res., 9(1), 37-40.
  2. Akkurt, I., Akyildirim, H., Mavi, B., Kilincarsian, S. and Basyigit, C. (2010), "Photon attenuation coefficients of concrete includes barite in different rate", Ann. Nucl. Energy, 37(7), 910-914. https://doi.org/10.1016/j.anucene.2010.04.001
  3. Akkurt, I., Basyigit, C., Akkas, A., Kilincarsian, S., Mavi, B. and Gunoglu, K. (2012), "Determination of some heavyweight aggregate half value layer thickness used for radiation shielding", Acta Phys. Pol. A., 121(1), 138-140. https://doi.org/10.12693/APhysPolA.121.138
  4. ASTM C143 (2010), "Standard test method for slump of hydraulic cement concrete".
  5. ASTM C150 (2009), "Standard specification for Portland cement".
  6. ASTM C494 (2011), "Standard specification for chemical admixtures for concrete".
  7. ASTM C511 (2009), "Standard specification for mixing rooms, moist cabinets, moist rooms and water storage tanks used in the testing of hydraulic cements and concretes".
  8. ASTM C637 (2009), "Standard specification for aggregates for radiation-shielding concrete".
  9. Basyigit, C., Uysal, V., Kilincarsian, S., Mavi, B., Gunoglu, K., Akkurt, I. and Akkas, A. (2011), "Investigating radiation shielding properties of different mineral origin heavyweight concretes", AIP Conference Proceedings, 1400(1), 232-235.
  10. Bunsell, A.R. and Renard, J. (2005), "Fundamentals of fibre reinforced composite materials", MA, Institute of Physics, Boston, Philadelphia.
  11. Egyptian code for design and construction of concrete structures- part VII: tests of hardened concrete", (2002).
  12. Egyptian code of practice for reinforced concrete No. 203 (2007).
  13. Egyptian standard specifications No. 1109 (2002), "Concrete aggregates from natural sources".
  14. El-Didamony, H., Helmy, I.M, Moselhy, H. and Ali, M.A. (2011), "Utilization of an industrial waste product in the preparation of low cost cement", J. Amer. Sci., 7(9), 527-533.
  15. El-Sayed, A. (2002), "Calculation of the cross-sections for fast neutrons and gamma- rays in concrete shields", Ann. Nucl. Energy, 29, 1977-1988. https://doi.org/10.1016/S0306-4549(02)00019-1
  16. European standard No. 2390-3 (2001), "Testing hardened concrete - Part 3: compressive strength of test specimens".
  17. Gencel, O., Bozkurt, A., Kam, E. and Korkut, T. (2011), "Determination and calculation of gamma and neutron shielding characteristics of concretes containing different hematite proportions", Ann. Nucl. Energy, 38(12), 2719-2723. https://doi.org/10.1016/j.anucene.2011.08.010
  18. Gencel, O., Koksal, F., Ozel, C. and Brostow, W. (2012), "Combined effect of fly ash and waste ferrochromium on properties of concrete", Constr. Build. Mat., 29, 633-640. https://doi.org/10.1016/j.conbuildmat.2011.11.026
  19. Ikraiam, F.A., Abd El-Latif, A., Abd ELAzziz, A. and Ali, J.M. (2009), "Effect of steel fiber addition on mechanical properties and ${\gamma}$-ray attenuation for ordinary concrete used in El-Gabal El-Akhdar area in libya for radiation shielding purposes", Arab J. Nucl. Sci. Appl., 42, 287-295.
  20. Kaplan, M.F. (1989), "Concrete radiation shielding", Longman Scientific and Technical, England.
  21. Kazjonovs, J., Bajare, D. and Korjakins, A. (2010), "Designing of high density concrete by using steel treatment waste. modern building materials, structures and techniques", 10th International Conference, Vilnius Lithuania.
  22. Nadeem, M. and Pofale, A.D. (2012), "Experimental investigation of using slag as an alternative to normal aggregates (coarse and fine) in concrete", Int. J. Civil Struct. Eng., 3(1), 117-127.
  23. Ouda, A.S. (2013), "Studies on some concrete ingredients appropriate for utilization in the construction of electro-nuclear power plants", Ph.D Thesis, Faculty of Sci., Ain Shams Univ.
  24. TS EN 206-1 (2002), "Concrete- part 1: specification, performance, production and conformity", TSE. Ankara, Turkey.
  25. Yilmaz, E., Baltas, H., Kiris, E., Ustabas, I., Cevik, U. and El-khayatt, A.M. (2011), "Gamma ray and neutron shielding properties of some concrete materials", Ann. Nucl. Energy, 38(10), 2204-2212. https://doi.org/10.1016/j.anucene.2011.06.011