Advances in concrete construction

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Experimental investigation of the stress-strain behavior of FRP confined concrete prisms

  • Hosseinpour, F. (Herff College of Engineering, University of Memphis) ;
  • Abbasnia, R. (Department of Civil Engineering, Iran University of Science and Technology)
  • Received : 2013.02.21
  • Accepted : 2014.08.01
  • Published : 2014.11.27
⟨ Previous Next ⟩

Abstract

One of the main applications of FRP composites is confining concrete columns. Hence identifying the cyclic and monotonic stress-strain behavior of confined concrete columns and the parameters influencing this behavior is inevitable. Two significant parameters affecting the stress-strain behavior are aspect ratio and corner radius. The present study aims to scrutinize the effects of corner radius and aspect ratio on different aspects of stress-strain behavior of FRP confined concrete specimens (rectangular, square and circular). Hence 44 FRP confined concrete specimens were tested and the results of the tests were investigated. The findings indicated that for specimens with different aspect ratios, the relationship between the ultimate stress and the corner radius is linear and the variations of the ultimate stress versus the corner radius decreases as a result of an increase in aspect ratio. It was also observed that increase of the corner radius results in increase of the compressive strength and ultimate axial strain and increase of the aspect ratio causes an increase of the ultimate axial strain but a decrease of the compressive strength. Investigation of the ultimate condition showed that the FRP hoop rupture strain is smaller in comparison with the one obtained from the tensile coupon test and also the ultimate axial strain and confined concrete strength are smaller when a prism is under monotonic loading. Other important results of this study were, an increase in the axial strain during the early stage of unloading paths and increase of the confining effect of FRP jacket with the increase and decrease of the corner radius and aspect ratio respectively, a decrease in the slope of reloading branches with cycle repetitions and the independence of this trend from the variations of the aspect ratio and corner radius and also quadric relationship between the number of each cycle and the plastic strain of the same cycle as well as the independence of this relationship from the aspect ratio and corner radius.

Keywords

Acknowledgement

Supported by : Iran University of Science and Technology

References

  1. Mirmiran, A., Shahawy, M., Samaan, M. and El Echary, H. (1998), "Effect of column parameters on FRPconfined concrete", J. Compos. Constr., ASCE, 2(4), 175-185. https://doi.org/10.1061/(ASCE)1090-0268(1998)2:4(175)
  2. Rochette, P. and Labossiere, P. (2000), "Axial testing of rectangular column models confined with composites", J. Compos. Constr., ASCE, 4(3), 129-136. https://doi.org/10.1061/(ASCE)1090-0268(2000)4:3(129)
  3. Wang, L.M. and Wu, Y.F. (2008), "Effect of corner radius on the performance of CFRP-confined square concrete columns", Eng. Struct., 30, 493-505. https://doi.org/10.1016/j.engstruct.2007.04.016
  4. Al-Salloum, Y.A. (2007), "Influence of edge sharpness on the strength of square concrete columns confined with FRP composite laminates", Compos. Part B: Eng., 38, 640-650. https://doi.org/10.1016/j.compositesb.2006.06.019
  5. Lam, L. and Teng J.G. (2003), "Design-oriented stress-strain model for FRP-confined concrete in rectangular columns", J. Reinf. Plast. Compos., 22(13), 1149-1186. https://doi.org/10.1177/0731684403035429
  6. Wu, Y.F. and Wei, Y.Y. (2010), "Effect of cross-sectional aspect ratio on the strength of CFRP-confined rectangular concrete columns", Eng. Struct., 32, 32-45 https://doi.org/10.1016/j.engstruct.2009.08.012
  7. Lam, L. and Teng, J.G. (2004), "Ultimate condition of fiber reinforced polymer-confined concrete", J. Compos Construct., ASCE; 8(6), 539-548. https://doi.org/10.1061/(ASCE)1090-0268(2004)8:6(539)
  8. Mirmiran, A. and Shahawy, M. (1997), "Dilation characteristics of confined concrete", Int. J. Mech. Cohesive-Frictional Mater., 2(3), 237-49. https://doi.org/10.1002/(SICI)1099-1484(199707)2:3<237::AID-CFM32>3.0.CO;2-2
  9. Mirmiran, A. and Shahawy, M. (1997), "Behavior of concrete columns confined by fiber composites", J. Struct. Eng., ASCE, 123(5), 583-590. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:5(583)
  10. Wu, G., Wu, Z.S. and Lu, Z.T. (2007), "Design-oriented stress-strain model for concrete prisms confined with FRP composites", Constr. Build. Mater., 21,1107-1121. https://doi.org/10.1016/j.conbuildmat.2005.12.014
  11. Zhao, T. and Xie, J. (2000), "Experimental study on complete stress-strain relation curve of CFRP confined concrete", J. Build. Struct., 30(7),40-43
  12. Saadatmanesh, H., Ehasni, M.R. and Li, M.W. (1994), Strength and ductility of concrete columns externally reinforced with fiber composite straps, ACI Struct. J., 91(4), 434-447.
  13. ACI Committee 440 Report (2002), Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures, ACI Committee 440, Technical Committee Document 440.2R-02
  14. Fraldi, M., Nunziante, L., Carannante, F., Prota, A., Manfredi, G. and Cosenza, E. (2008), "On the prediction of the collapse load of circular concrete columns confined by FRP", Eng. Struct., 30, 3247-3264. https://doi.org/10.1016/j.engstruct.2008.04.036
  15. Jiang, T. and Teng, J.G. (2007), "Analysis-oriented stress-strain models for FRP-confined concrete", Eng. Struct., 29, 2968-86. https://doi.org/10.1016/j.engstruct.2007.01.010
  16. Rousakis, T.C., Karabinis, A.I. and Kiousis, P.D. (2007), "FRP-confined concrete members: Axial compression experiments and plasticity modeling", Eng. Struct., 29, 1343-1353. https://doi.org/10.1016/j.engstruct.2006.08.006
  17. Sheikh, S.A. and Li, Y. (2007), "Design of FRP confinement for square concrete columns", Eng. Struct., 29, 1074-1083. https://doi.org/10.1016/j.engstruct.2006.07.016
  18. Harajli, M.H. (2006), "Axial stress-strain relationship for FRP-confined circular and rectangular concrete columns", Cement Concrete Compos., 28, 938-948. https://doi.org/10.1016/j.cemconcomp.2006.07.005
  19. Binici, B. (2005), "An analytical model for stress-strain behavior of confined concrete", Eng. Struct., 27(7), 1040-1051. https://doi.org/10.1016/j.engstruct.2005.03.002
  20. Lam, L. and Teng, J.G. (2004), "Behavior and modeling of fiber reinforced polymer-confined concrete", J Struct Eng, ASCE; 130(11), 1713-1723. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:11(1713)
  21. Xiao, Y. and Wu, H. (2000), "Compressive behavior of concrete confined by carbon fiber composite jackets", J. Mater. Civil Eng., ASCE, 12(2), 139-146. https://doi.org/10.1061/(ASCE)0899-1561(2000)12:2(139)
  22. Spoelstra, M.R. and Monti, G. (1999), "FRP-confined concrete model", J .Compos. Constr., ASCE, 3(3), 143-150. https://doi.org/10.1061/(ASCE)1090-0268(1999)3:3(143)
  23. Samaan, M., Mirmiran, A. and Shahawy, M. (1998), "Model of concrete confined by fiber composite", J Struct. Eng., ASCE, 124(9), 1025-1031. https://doi.org/10.1061/(ASCE)0733-9445(1998)124:9(1025)
  24. Pessiki, S., Harries, K.A., Kestner, J.T., Sause, R. and Ricles, J.M. (2001), "Axial behaviour of reinforced concrete columns confined with FRP Jackets", ASCE J Compos. Construct., 5(4), 237-245. https://doi.org/10.1061/(ASCE)1090-0268(2001)5:4(237)
  25. Abbasnia, R., Hosseinpour, F., Rostamian, M. and Ziaadiny, H. (2012), "Effect of corner radius on stressstrain behavior of FRP confined prisms under axial cyclic compression", Eng. Struct., 40, 529-535. https://doi.org/10.1016/j.engstruct.2012.03.020
  26. Abbasnia, R., Ahmadi, R. and Ziaadiny, H. (2012), "Effect of confinement level, aspect ratio and concrete strength on the cyclic stress-strain behavior of FRP-confined concrete prisms", Compos. Part B: Eng., 43, 825-831. https://doi.org/10.1016/j.compositesb.2011.11.008
  27. Abbasnia, R. and Ziaadiny, H. (2010), "Behavior of concrete prisms confined with FRP composites under axial cyclic compression", Eng. Struct., 32, 648-655 https://doi.org/10.1016/j.engstruct.2009.11.011
  28. Shao, Y., Zhu, Z. and Mirmiran, A. (2006), "Cyclic modeling of FRP-confined concrete with improved ductility", Cement Concrete Compos., 28, 959-968. https://doi.org/10.1016/j.cemconcomp.2006.07.009
  29. Lam, L. and Teng, J.G. (2009), "Stress-strain model for FRP-confined concrete under cyclic axial compression", Eng. Struct., 31, 308-321. https://doi.org/10.1016/j.engstruct.2008.08.014
  30. Lam, L., Teng, J.G., Cheung, J.G. and Xiao, Y. (2006), "FRP-confined concrete under axial cyclic compression", Cement Concrete Compos., 28(10), 949-958. https://doi.org/10.1016/j.cemconcomp.2006.07.007

Cited by

  1. Unified cyclic stress-strain model for FRP-confined concrete circular, square and rectangular prisms vol.17, pp.2, 2016, https://doi.org/10.1002/suco.201500128
  2. Statistical evaluation of the monotonic models for FRP confined concrete prisms vol.3, pp.3, 2015, https://doi.org/10.12989/acc.2015.3.3.161
  3. Effects of sulphuric acid on mechanical and durability properties of ECC confined by FRP fabrics vol.6, pp.2, 2018, https://doi.org/10.12989/acc.2018.6.2.199
  4. Shear strengthening of deficient concrete beams with marine grade aluminium alloy plates vol.7, pp.4, 2014, https://doi.org/10.12989/acc.2019.7.4.249
  5. Preload effects on behaviour of FRP confined concrete: Experiment, mechanism and modified model vol.9, pp.6, 2014, https://doi.org/10.12989/acc.2020.9.6.597
  6. Bond strength prediction of the composite rebars in concrete using innovative bio‐inspired models vol.2, pp.11, 2014, https://doi.org/10.1002/eng2.12260
  7. Assessment of analytical stress and strain at peak and at ultimate conditions for fiber‐reinforcement polymer‐confined reinforced concrete columns of rectangular sections under axial cyc vol.22, pp.1, 2021, https://doi.org/10.1002/suco.201900386
  8. Behavior of modified concrete based on crumb rubber: Experimental test and numerical investigation vol.12, pp.2, 2014, https://doi.org/10.12989/acc.2021.12.2.125