DOI QR코드

DOI QR Code

Improved capacity spectrum method with inelastic displacement ratio considering higher mode effects

  • Han, Sang Whan (Department of Architectural Engineering, Hanyang University) ;
  • Ha, Sung Jin (Department of Architectural Engineering, Hanyang University) ;
  • Moon, Ki Hoon (Department of Architectural Engineering, Hanyang University) ;
  • Shin, Myoungsu (School of Urban and Environmental Engineering, UNIST)
  • 투고 : 2013.03.16
  • 심사 : 2014.03.09
  • 발행 : 2014.10.30

초록

Progressive collapse, which is referred to as the collapse of the entire building under local damages, is a common failure mode happened by earthquakes. The collapse process highly depends on the whole structural system. Since, asymmetry of the building plan leads to the local damage concentration; it may intensify the progressive collapse mechanism of asymmetric buildings. In this research the progressive collapse of regular and irregular 6-story RC ordinary moment resisting frame buildings are studied in the presence of the earthquake loads. Collapse process and collapse propagation are investigated using nonlinear time history analyses (NLTHA) in buildings with 5%, 15% and 25% mass asymmetry with respect to the number of collapsed hinges and story drifts criteria. Results show that increasing the value of mass eccentricity makes the asymmetric buildings become unstable earlier and in the early stages with lower number of the collapsed hinges. So, with increasing the mass eccentricity in building, instability and collapse of the entire building occurs earlier, with lower potential of the progressive collapse. It is also demonstrated that with increasing the mass asymmetry the decreasing trend of the number of collapsed beam and column hinges is approximately similar to the decreasing trend in the average story drifts of the mass centers and stiff edges. So, as an alternative to a much difficult-to-calculate local response parameter of the number of collapsed hinges, the story drift, as a global response parameter, measures the potential of progressive collapse more easily.

키워드

과제정보

연구 과제 주관 기관 : National Research Foundation of Korea (NRF)

참고문헌

  1. Aschheim, M. and Black, E.F. (2000), "Yield point spectra for seismic design and rehabilitation", Earthq. Spectra, 16(2), 313-335.
  2. ATC (1996), "Seismic evaluation and retrofit of concrete buildings", Appl. Tech. Council, 40, Redwood City, CA.
  3. ATC. (2005), "Improvement of nonlinear static seismic analysis procedures", FEMA 440 Federal Emergency Management Agency, Washington, DC.
  4. Ayala, A.G., Castellanos, H. and Lopez, S. (2012), "A displacement-based seismic design method with damage control for RC buildings", Earthq. Struct., 3(3-4), 413-434. https://doi.org/10.12989/eas.2012.3.3_4.413
  5. Bento, R., Bhatt, C. and Pinho, R. (2010), "Using nonlinear static procedures for seismic assessment of the 3D irregular SPEAR building", Earthq. Struct., 1(2), 177-195. https://doi.org/10.12989/eas.2010.1.2.177
  6. Bracci, J.M., Kunnath, S.K. and Reinhorn, A.M. (1997), "Seismic performance and retrofit evaluation for reinforced concrete structures", J. Struct. Eng., 23(1), 3-10.
  7. Chopra, A.K. and Goel, R.K. (1999), "Capacity demand diagram methods based on inelastic design spectrum", Earthq. Spectra, 15(4), 637-656. https://doi.org/10.1193/1.1586065
  8. Chopra, A.K. and Goel, R.K. (2002), "A modal pushover analysis procedure for estimating seismic demands for buildings", Earthq. Eng. Struct. Dyn., 31, 561-582. https://doi.org/10.1002/eqe.144
  9. Chopra, A.K. and Chintanapakdee, C. (2004), "Inelastic deformation ratios for design and evaluation of structures: single-degree-of-freedom bilinear systems", J. Struct. Eng., 130(9), 1309-1319. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:9(1309)
  10. Chopra, A.K. (2008), "Discussion of "observations on the reliability of alternative multiple-mode pushover analysis methods" by T. Tjhin, M. Aschheim, and E. Hernandes-Montes", J. Struct. Eng., 134(9), 1582-1585.
  11. Council, B.S.S. (2000), "Prestandard and commentary for the seismic rehabilitation of buildings (FEMA356)", Federal Emergency Management Agency, 356, Washington, D.C.
  12. Fajfar, P. (1999), "Capacity spectrum method based on inelastic demand spectra", Earthq. Eng. Struct. Dyn., 28(9), 979-993. https://doi.org/10.1002/(SICI)1096-9845(199909)28:9<979::AID-EQE850>3.0.CO;2-1
  13. Freeman, S.A. (1978), "Prediction of response of concrete buildings to severe earthquake motion", Am. Concrete Inst., 55, 589-606.
  14. Goel, R.K. and Chopra, A.K. (2004), "Evaluation of modal and FEMA pushover analyses: SAC buildings", Earthq. Spectra, 20(1), 225-254. https://doi.org/10.1193/1.1646390
  15. Gupta, A. and Krawinkler, H. (1999), "Seismic demands for performance evaluation of steel moment resisting frame structures", Ph.D. Dissertation, Stanford University, CA.
  16. Gupta, B. and Kunnath, S.K. (2000), "Adaptive spectra-based pushover procedure for seismic evaluation of structures", Earthq. Spectra, 16(2), 367-392. https://doi.org/10.1193/1.1586117
  17. Han, S.W. and Chopra, A.K. (2006), "Approximate incremental dynamic analysis using the modal pushover analysis procedure", Earthq. Eng. Struct. Dyn., 35, 1853-1973. https://doi.org/10.1002/eqe.605
  18. Hernandez-Montes, E., Kwon, O.S. and Aschheim, M.A. (2004). "An energy-based formulation for firstand multiple-mode nonlinear static (Pushover) analyses", J. Earthq. Eng., 8(1), 69-88.
  19. Krawinkler, H. and Nassar, A.A. (1992). Seismic design based on ductility and cumulative damage demands and capacities. Nonlinear Seismic Analysis and Design of Reinforced Concrete Buildings, Eds P. Fajfar and H. Krawinkler. New York: Elsevier Applied Science.
  20. Krawinkler, H. (1995), "New trends in seismic design methodology", Proceedings of 10th European Conference on Earthquake Engineering, Vienna, Austria, September.
  21. Krawinkler, H. and Seneviratna, G.D.P.K. (1998), "Pros and cons of a pushover analysis of seismic performance evaluation", Eng. Struct., 20(4-6), 452-464. https://doi.org/10.1016/S0141-0296(97)00092-8
  22. Miranda, E. and Bertero, V.V. (1994), "Evaluation of strength reduction factors for earthquake resistant design", Earthq. Spectra, 10, 357-379 https://doi.org/10.1193/1.1585778
  23. Miranda, E. (2001), "Estimation of inelastic deformation demands of SDOF systems", J. Struct. Eng., 127(9), 1005-1012. https://doi.org/10.1061/(ASCE)0733-9445(2001)127:9(1005)
  24. Nassar, A.A. and Krawinkler, H. (1991), Seismic Demands for SDOF and MDOF Systems, Report No. 95, John A. Blume Earthquake Engineering Center, Stanford University, CA.
  25. Newmark, N.M. and Hall, W.J. (1982), "Earthquake Spectra and Design", Berkeley, Calif. Earthquake Engineering Research Inst.
  26. Prakash, V., Powell, G.H. and Campbell, S. (1993), "DRAIN-2DX base program description and user guide", Report UCB/SEMM-93/17, Department of Civil and Environmental Engineering, University of California at Berkeley, Berkeley, CA.
  27. Prasanth, T., Ghosh, S. and Collins, K.R. (2008), "Estimation of hysteretic energy demand using concepts of modal pushover analysis", Earthq. Eng. Struct. Dyn., 37(6), 975-990. https://doi.org/10.1002/eqe.802
  28. Ramirez, O.M., Constantinou, M.C., Whittaker, A.S., Kircher, C.A. and Chrysostomou, C.Z. (2002), "Elastic and inelastic seismic response of building with damping systems", Earthq. Spectra, 18(3), 531-547. https://doi.org/10.1193/1.1509762
  29. Somerville, P., Punyamurthula, S. and Sun, J. (1997), "Development of ground motion time histories for phase 2 of the FEMA/SAC Steel Project", SAC background documentation, SAC/BD 97-04, Sacramento, CA.
  30. Vidic, T., Fajfar, P. and Fischinger, M. (1994), "Consistent inelastic design spectra: strength and displacement", Earthq. Eng. Struct. Dyn., 23(5), 507-521. https://doi.org/10.1002/eqe.4290230504

피인용 문헌

  1. Inelastic deformation ratio for seismic demands assessment of structures vol.199, 2017, https://doi.org/10.1016/j.proeng.2017.09.168
  2. Development of seismic collapse capacity spectra for structures with deteriorating properties vol.12, pp.3, 2014, https://doi.org/10.12989/eas.2017.12.3.297
  3. Modification of ground motions using wavelet transform and VPS algorithm vol.12, pp.4, 2017, https://doi.org/10.12989/eas.2017.12.4.389
  4. Seismic structural demands and inelastic deformation ratios: a theoretical approach vol.12, pp.4, 2014, https://doi.org/10.12989/eas.2017.12.4.397
  5. Seismic structural demands and inelastic deformation ratios: Sensitivity analysis and simplified models vol.13, pp.1, 2014, https://doi.org/10.12989/eas.2017.13.1.059