Advances in aircraft and spacecraft science

  • 제1권4호
  • /
  • Pages.443-454
  • /
  • 2014
  • /
  • 2287-528X(pISSN)
  • /
  • 2287-5271(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Effect of Reynolds number on compressible convex-corner flows

  • Chung, Kung-Ming (Aerospace Science and Technology Research Center, National Cheng Kung University) ;
  • Chang, Po-Hsiung (Department of Aeronautics and Astronautics, National Cheng Kung University) ;
  • Chang, Keh-Chin (Department of Aeronautics and Astronautics, National Cheng Kung University)
  • 투고 : 2014.03.07
  • 심사 : 2014.05.27
  • 발행 : 2014.10.25
⟨ 이전 논문 다음 논문 ⟩

초록

An experimental study was conducted to investigate the effect of Reynolds number on compressible convex-corner flows, which correspond to an upper surface of a deflected flap of an aircraft wing. The flow is naturally developed along a flat plate with two different lengths, resulting in different incoming boundary layer thicknesses or Reynolds numbers. It is found that boundary layer Reynolds number, ranging from $8.04{\times}10^4$ to $1.63{\times}10^5$, has a minor influence on flow expansion and compression near the corner apex in the transonic flow regime, but not for the subsonic expansion flow. For shock-induced separated flow, higher peak pressure fluctuations are observed at smaller Reynolds number, corresponding to the excursion phenomena and the shorter region of shock-induced boundary layer separation. An explicit correlation of separation length with deflection angle is also presented.

키워드

참고문헌

  1. Bernardini, A., Pirozzoli, S. and Grasso, F. (2010), "The wall pressure signature of transonic shock/boundary layer interaction", J. Fluid Mech., 671, 288-312.
  2. Bies, D.A. (1966), "Flight and wind tunnel measurements of boundary layer pressure fluctuations and induced structural response", NASA-CR-626.
  3. Bolonkin, A. and Gilyard, G.B. (1999), "Estimated benefits of variable-geometry wing camber control for transport aircraft", NASA TM-1999-206586, October.
  4. Chung, K.M. (2000), "Transition of subsonic and transonic expansion-corner flows", J. Aircraft, 37(6), 1079-1082. https://doi.org/10.2514/2.2714
  5. Chung, K.M. (2002), "Investigation on transonic convex-corner flows", J. Aircraft, 39(6), 1014-1018. https://doi.org/10.2514/2.3029
  6. Chung K.M. (2004), "Unsteadiness of transonic convex-corner flows", Experiment. Fluid., 37(6), 917-922. https://doi.org/10.1007/s00348-004-0890-3
  7. Chung, K.M. (2007), "Upstream blowing jet on transonic convex corner flows", J. Aircraft, 44(6), 1948-1953. https://doi.org/10.2514/1.32203
  8. Chung, K.M. (2010), "Effect of normal blowing on compressible convex-corner flows", J. Aircraft, 47(4), 1189-1196. https://doi.org/10.2514/1.46889
  9. Chung, K.M., Chang, P.H. and Chang, K.C. (2012), "Flow similarity in compressible convex corner flows", AIAA J., 50(4), 985-988. https://doi.org/10.2514/1.J051429
  10. Delery, J.M. (1983), "Experimental investigation of turbulent properties in transonic shock boundary layer interactions", AIAA J., 21(11), 1628-1634. https://doi.org/10.2514/3.60163
  11. Dolling, D.S. (2001), "Fifty years of shock wave/boundary layer interaction research: what next ?", AIAA J., 39(8), 1517-1531. https://doi.org/10.2514/2.1476
  12. Dussauge, J.P., Dupont, P. and Debieve, J.F. (2006), "Unsteadiness in shock wave boundary layer interactions with separation", Aero. Sci. Tech., 10(2), 85-91. https://doi.org/10.1016/j.ast.2005.09.006
  13. Dussauge, J.P. and Piponniau, S. (2008), "Shock/boundary layer interactions: possible sources of unsteadiness", J. Fluid. Struct., 24, 1166-1175. https://doi.org/10.1016/j.jfluidstructs.2008.06.003
  14. Inger, G.R. and Zee, S. (1978), "Transonic shock wave/turbulent boundary layer interaction with suction or blowing", J. Aircraft, 15(11), 750-754. https://doi.org/10.2514/3.58442
  15. Kim, H.D., Matsuo, K. and Setoguchi, T. (1996), "Investigation on onset shock-induced separation", Shock Waves, 6(5), 275-286. https://doi.org/10.1007/BF02535741
  16. Laganelli, A.L. and Martellucci, A. (1983), "Wall pressure fluctuations in attached boundary layer flow", AIAA J., 21(4), 495-502. https://doi.org/10.2514/3.8105
  17. Law, C.H. (1974), "Supersonic, turbulent boundary-layer separation", AIAA J., 12(6), 794-797. https://doi.org/10.2514/3.49352
  18. Liu, X. and Squire, L.C. (1987) "An investigation of shock/boundary layer interactions on curved surfaces at transonic speeds", J. Fluid Mech., 187, 467-486.
  19. Mason, W.H. (1993), "Fundamental issues in subsonic/transonic expansion corner aerodynamics", AIAA Paper 93-0649, January.
  20. Ogawa, H., Babinsky, H., Paetzold, A. and Lutz, T. (2008) "Shock-wave/boundary-layer interaction control using three-dimensional bumps for transonic wings", AIAA J., 46(6), 1442-1452. https://doi.org/10.2514/1.32049
  21. Piponniau, P., Dussauge, J.P., Debieve, J.F. and Dupont, P. (2009), "A simple model for low-frequency unsteadiness in shock-induced separation", J. Fluid Mech., 629, 87-108. https://doi.org/10.1017/S0022112009006417
  22. Ruban, A.I., and Turkyilmaz, I. (2000), "On laminar separation at a corner point in transonic flow", J. Fluid Mech., 423, 345-380. https://doi.org/10.1017/S002211200000207X
  23. Settles, G.S. and Bogdonoff, S.M. (1983), "Scaling of two- and three-dimensional shock/turbulent boundary-layer interactions at compression corners", AIAA J., 20(6), 782-789.
  24. Szodruch, J., and Hilbig, R. (1988), "Variable wing camber for transport aircraft", Prog. Aerospace Sci., 25(3), 1988, 297-328. https://doi.org/10.1016/0376-0421(88)90003-6
  25. Wollblad, C., Davidson, L. and Eriksson, L.K. (2010), "Investigation of large scale shock movement in transonic flow", Int. J. Heat Fluid Flow, 31, 528-535. https://doi.org/10.1016/j.ijheatfluidflow.2010.02.009

피인용 문헌

  1. Shock Wave Instability in a Channel with an Expansion Corner vol.07, pp.02, 2015, https://doi.org/10.1142/S1758825115500192
  2. Drag reduction for payload fairing of satellite launch vehicle with aerospike in transonic and low supersonic speeds vol.7, pp.4, 2014, https://doi.org/10.12989/aas.2020.7.4.371