DOI QR코드

DOI QR Code

Effect of cumulative seismic damage to steel tube-reinforced concrete composite columns

  • Ji, Xiaodong (Key Laboratory of Civil Engineering Safety and Durability of China Education Ministry, Department of Civil Engineering, Tsinghua University) ;
  • Zhang, Mingliang (Key Laboratory of Civil Engineering Safety and Durability of China Education Ministry, Department of Civil Engineering, Tsinghua University) ;
  • Kang, Hongzhen (Department of Civil Engineering, Tangshan College) ;
  • Qian, Jiaru (Key Laboratory of Civil Engineering Safety and Durability of China Education Ministry, Department of Civil Engineering, Tsinghua University) ;
  • Hu, Hongsong (Key Laboratory of Civil Engineering Safety and Durability of China Education Ministry, Department of Civil Engineering, Tsinghua University)
  • 투고 : 2013.11.19
  • 심사 : 2014.03.13
  • 발행 : 2014.08.29

초록

The steel tube-reinforced concrete (ST-RC) composite column is a novel type of composite column, consisting of a steel tube embedded in reinforced concrete. The objective of this paper is to investigate the effect of cumulative damage on the seismic behavior of ST-RC columns through experimental testing. Six large-scale ST-RC column specimens were subjected to high axial forces and cyclic lateral loading. The specimens included two groups, where Group I had a higher amount of transverse reinforcement than Group II. The test results indicate that all specimens failed in a flexural mode, characterized by buckling and yielding of longitudinal rebars, failure of transverse rebars, compressive crushing of concrete, and steel tube buckling at the base of the columns. The number of loading cycles was found to have minimal effect on the strength capacity of the specimens. The number of loading cycles had limited effect on the deformation capacity for the Group I specimens, while an obvious effect on the deformation capacity for the Group II specimens was observed. The Group I specimen showed significantly larger deformation and energy dissipation capacities than the corresponding Group II specimen, for the case where the lateral cyclic loads were repeated ten cycles at each drift level. The ultimate displacement of the Group I specimen was 25% larger than that of the Group II counterpart, and the cumulative energy dissipated by the former was 2.8 times that of the latter. Based on the test results, recommendations are made for the amount of transverse reinforcement required in seismic design of ST-RC columns for ensuring adequate deformation capacity.

키워드

참고문헌

  1. CECS 188 (2005), Technical Specification for Steel Tube-reinforced Concrete Column Structure, China Planning Press, Beijing, China. [In Chinese]
  2. Chung, Y., Nagae, T., Hitaka, T. and Nakashima, M. (2010), "Seismic resistance capacity of high-rise buildings subjected to long-period ground motions: E-Defense shaking table test", J. Struct. Eng., ASCE, 136(6), 637-644. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000161
  3. El-Bahy, A., Kunnath, S.K., Stone, W.C. and Taylor, A.W. (1999), "Cumulative seismic damage of circular bridge columns: Benchmark and low-cycle fatigure tests", ACI Struct. J., 96(4), 633-641.
  4. Erberik, A. and Sucuoglu, H. (2004), "Seismic energy dissipation in deteriorating systems through low-cycle fatigue", Earthq. Eng. Struct. Dyn., 33(1), 49-67. https://doi.org/10.1002/eqe.337
  5. EuroCode 8 (2004), "Design Provisions for Earthquake Resistance-Part 1: General Rules, Seismic Actions and Rules for Buildings", European Committee for Standardization, Brussels, Belgium.
  6. Fajfar, P. (1992), "Equivalent ductility factors, taking into account low-cycle fatigue", Earthq. Eng. Struct. Dyn., 21(10), 837-848. https://doi.org/10.1002/eqe.4290211001
  7. GB 50011-2010, "Code for seismic design of buildings", China Ministry of Construction, Beijing, China.
  8. GB 50010-2010, "Code for design of concrete structures", China Ministry of Construction, Beijing, China.
  9. Han, L.H., Yao, G.H. and Zhao, X.L. (2004), "Behavior and calculation on concrete-filled steel CHS (circular hollow section) beam-columns", Steel Compos. Struct., Int. J., 4(3), 169-188. https://doi.org/10.12989/scs.2004.4.3.169
  10. Han, L.H., Liao, F.Y., Tao, Z. and Hong, Z. (2009), "Performance of concrete filled steel tube reinforced concrete columns subjected to cyclic bending", J. Construct. Steel Res., 65(8-9), 1607-1616. https://doi.org/10.1016/j.jcsr.2009.03.013
  11. JGJ 3-2011 (2011), "Technical specification for concrete structures of tall building", China Ministry of Construction, Beijing, China. [In Chinese]
  12. Ji, X., Fenves, G.L., Kajiwara, K. and Nakashima, M. (2011), "Seismic damage detection of a full-scale shaking table test structure", J. Struct. Eng., ASCE, 137(1), 14-21. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000278
  13. Ji, X., Kang, H., Chen, X. and Qian, J. (2014), "Seismic behavior and strength capacity of steel tubereinforced concrete composite columns", Earthq. Eng. Struct. Dyn., 43(4), 487-505. https://doi.org/10.1002/eqe.2354
  14. Jiao, Y., Yamada, S., Kishiki, S. and Shimada, Y. (2011), "Evaluation of plastic energy dissipation capacity of steel beams suffering ductile fracture under various loading histories", Earthq. Eng. Struct. Dyn., 40(14), 1553-1570. https://doi.org/10.1002/eqe.1103
  15. Kang, H. and Qian, J. (2006), "Experimental study on high-strength concrete filled steel tube composite columns under axial compressive loading", Proceedings of the Tenth East Asia - Pacific Conference on Structural Engineering and Construction, Bangkok, Thailand, pp. 69-74.
  16. Kawashima, K. and Koyama, T. (1988), "Effect of number of loading cycles on dynamic characteristics of reinforced concrete bridge pier columns", Struct. Eng. Earthq. Eng., 5(1), 183-191.
  17. Krawinkler, H. and Zohrei, M. (1983), "Cumulative damage in steel structures subjected to earthquake ground motions", Comput. Struct., 16(1-4), 531-541. https://doi.org/10.1016/0045-7949(83)90193-1
  18. Nie, J., Bai, Y. and Cai, C.S. (2008), "New connection system for confined concrete columns and beams. I: Experimental study", J. Struct. Eng., ASCE, 134(12), 1787-1799. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:12(1787)
  19. Perea, T. (2010), "Analytical and experimental study on slender concrete-filled steel tube columns and beam-column", Ph.D. Dissertation, School of Civil and Environmental Engineering, Georgia Institute of Technology, Atlanta, GA, USA.
  20. Pujol, S., Sozen, M.A. and Ramirez, J. (2006), "Displacement history effects on drift capacity of reinforced concrete columns", ACI Struct. J., 103(2), 253-262.
  21. Takewaki, I., Murakami, S., Fujita, K., Yoshitomi, S. and Tsuji, M. (2011), "The 2011 off the Pacific coast of Tohoku earthquake and response of high-rise buildings under long-period ground motions", Soil Dyn. Earthq. Eng., 31(11), 1511-1528. https://doi.org/10.1016/j.soildyn.2011.06.001
  22. Tort, C. and Hajjar, J.F. (2004), "Damage assessment of rectangular concrete-filled steel tubes for performance-based design", Earthq. Spect., 20(4), 1317-1348. https://doi.org/10.1193/1.1809660
  23. Varma, A.H., Ricles, J.M., Sause, R. and Lu, L. (2002), "Seismic behavior and modeling of high-strength composite concrete-filled steel tube (CFT) beam-columns", J. Construct. Steel Res., 58(5-8), 725-758. https://doi.org/10.1016/S0143-974X(01)00099-2

피인용 문헌

  1. A high-order analytical method for thick composite tubes vol.21, pp.4, 2016, https://doi.org/10.12989/scs.2016.21.4.755
  2. Experimental study on hysteretic behavior of composite frames with concrete-encased CFST columns vol.123, 2016, https://doi.org/10.1016/j.jcsr.2016.04.024
  3. Seismic performance of recycled aggregate concrete–filled steel tube columns vol.133, 2017, https://doi.org/10.1016/j.jcsr.2017.02.006
  4. Earthquake analysis of NFRP-reinforced-concrete beams using hyperbolic shear deformation theory vol.13, pp.3, 2014, https://doi.org/10.12989/eas.2017.13.3.241
  5. Dynamic response of concrete beams reinforced by Fe2O3 nanoparticles subjected to magnetic field and earthquake load vol.13, pp.6, 2014, https://doi.org/10.12989/eas.2017.13.6.589
  6. Seismic analysis of AL2O3 nanoparticles-reinforced concrete plates based on sinusoidal shear deformation theory vol.15, pp.3, 2014, https://doi.org/10.12989/eas.2018.15.3.285
  7. Test on Hysteretic Behaviour of Prestressed Composite Joints with Concrete-Encased CFST Columns vol.2019, pp.None, 2014, https://doi.org/10.1155/2019/4523045
  8. Study on shear capacity of prestressed composite joints with concrete-encased CFST columns vol.24, pp.11, 2021, https://doi.org/10.1177/13694332211000558
  9. Axial Compression Performance and Residual Strength Calculation of Concrete-Encased CFST Composite Columns Exposure to High Temperature vol.12, pp.1, 2022, https://doi.org/10.3390/app12010480