Abstract
Recently, the trend toward larger architectural structures continues and accelerates demand for Ultra High Strength Concrete (UHSC) which satisfies structural performance. However, UHSC has weakness in fire and the performance tests are required. In this paper, the change of mechanical properties of 100 MPa grade UHSC exposed to high temperatures ($20^{\circ}C{\sim}800^{\circ}C$) was observed to develop high temperature material model of UHSC: residual compressive strength, modulus of elasticity, property of stress-strain on monotonous loading and property of stress-strain on cyclic loading. In addition, TG/DTA and SEM Images analyses were performed to investigate chemical and physical characteristics of UHSC, and the results of this research were compared with those of previous studies. As a result, UHSC at the heating temperature of $300^{\circ}C$ showed a sharp decrease of residual compressive strength and modulus of elasticity. And It was shown that UHSC had a plastic behavior at more than $400^{\circ}C$ on the cyclic loading and revealed a same tendency in both monotonous and cyclic loading of all heating temperatures. In addition, through TG/DTA and SEM images analyses compared with those from previous studies, it was shown that the deterioration of concrete inner tissue, water evaporation and chemical reaction caused the decrease of residual compressive strength and modulus of elasticity.
최근의 건축 구조물이 고층화, 대형화됨에 따라 초고강도 콘크리트의 적용 및 수요가 증가하고 있는 추세이나, 화재에 대한 취약성을 가지고 있는 초고강도 콘크리트의 열적 특성에 대한 검토는 아직 충분하지 않으며 이에 대한 성능 검토 또한 요구되고 있는 실정이다. 이에 이 논문에서는 초고강도 콘크리트의 고온 재료 모델 개발에 대한 기초적 자료를 제공하기 위하여 상온에서 $800^{\circ}C$까지의 고온 가열을 받은 100 MPa급 초고강도 콘크리트를 대상으로 가열온도의 변화에 따른 잔존압축강도, 탄성계수 및 응력-변형 성상, 반복하중 시의 응력-변형 성상 등 역학적 특성 변화를 확인하였다. 또한, TG/DTA분석과 SEM 촬영으로 콘크리트의 화학 물리적 특성을 확인하고 국내 외의 기존 연구와 비교 검토하였다. 그 결과, 가열온도 $300^{\circ}C$에서 잔존압축강도 및 탄성계수의 급격한 저하를 확인하였으며, 반복하중 하에서는 가열온도 $400^{\circ}C$부터 소성거동이 발생하는 것과 함께 단일하중과 거의 동일한 경향을 보임을 확인할 수 있었다. TG/DTA 분석 및 SEM 촬영을 실시한 결과와 기존 연구를 비교 검토한 결과, 콘크리트 내부 조직의 열화와 수분 증발 및 화학반응 등으로 인하여 잔존압축강도 및 탄성계수의 저하가 일어났음을 확인할 수 있었다.