Structural Engineering and Mechanics

  • 제51권1호
  • /
  • Pages.131-140
  • /
  • 2014
  • /
  • 1225-4568(pISSN)
  • /
  • 1598-6217(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Rational analysis model and seismic behaviour of tall bridge piers

  • Li, Jianzhong (Department of Bridge Engineering, Tongji University) ;
  • Guan, Zhongguo (Department of Bridge Engineering, Tongji University) ;
  • Liang, Zhiyao (Engineering Management Office, Suzhou Industrial Park)
  • 투고 : 2011.04.07
  • 심사 : 2014.05.18
  • 발행 : 2014.07.10
⟨ 이전 논문 다음 논문 ⟩

초록

This study focuses on seismic behaviour of tall piers characterized by high slender ratio. Two analysis models were developed based on elastic-plastic hinged beam element and elastic-plastic fiber beam element, respectively. The effect of the division density of elastic-plastic hinged beam element on seismic demand was discussed firstly to seek a rational analysis model for tall piers. Then structural seismic behaviour such as the formation of plastic hinges, the development of plastic zone, and the displacement at the top of the tall piers were investigated through incremental dynamic analysis. It showed that the seismic behaviour of a tall pier was quite different from that of a lower pier due to higher modes contributions. In a tall pier, an additional plastic zone may occur at the middle height of the pier with the increase of seismic excitation. Moreover, the maximum curvature reaction at the bottom section and maximum lateral displacement at the top turned out to be seriously out of phase for a tall pier due to the higher modes effect, and thus pushover analysis can not appropriately predict the local displacement capacity.

키워드

참고문헌

  1. AASHTO (2007), AASHTO Guide Specification for LRFD Seismic Bridge Design, Washington, D.C.
  2. Bresler, B. and Pister, K.S. (1985), "Strength of concrete under combined stresses", ACI J, 551(9), 321-345.
  3. Bu, Z.Y., Ding, Y., Chen, J. and Li, Y.S. (2012), "Investigation of the Seismic performance of precast segmental tall Bridge columns", Struct. Eng. Mech., 43(3), 287-309. https://doi.org/10.12989/sem.2012.43.3.287
  4. Ceravolo, R., Demarie, G.V., Giordano, L., Mancini, G. and Sabia, D. (2009), "Problems in applying codespecified capacity design procedures to seismic design of tall piers", Eng. Struct., 31(8), 1811-1821. https://doi.org/10.1016/j.engstruct.2009.02.042
  5. Fan, L.C. (2007), "Life cycle and performance based seismic design of major bridges in China", Front. Arch. Civil Eng. China, 1(3), 261-266. https://doi.org/10.1007/s11709-007-0033-z
  6. Gould, P.L. and Huang, W. (2006), "Higher mode effects in the nonlinear static analysis of a collapsed chimney", Proceedings of the 2006 Structures Congress, Missouri, May.
  7. JTG/T B02-01-2008 (2008), Guidelines for Seismic Design of Highway Bridges, Beijing.
  8. Kowalsky, M.J. (2000), "Deformation limit states for circular reinforced concrete bridge column", J. Struct. Eng., ASCE, 126(8), 869-878. https://doi.org/10.1061/(ASCE)0733-9445(2000)126:8(869)
  9. Li, J.Z., Song, X.D. and Fan, L.C. (2005), "Investigation for displacement ductility capacity of tall piers", Earthq. Eng. Eng. Vib., 25(1), 43-48.
  10. Mander, J.B., Dhakal, R.P., Mashiko, N. and Solberg, K.M. (2007), "Incremental dynamic analysis applied to seismic financial risk assessment of bridges", Eng. Struct., 29(10), 2662-2672. https://doi.org/10.1016/j.engstruct.2006.12.015
  11. Mander, J.B., Priestley, M.J.N. and Park, R. (1988), "Theoretical stress-strain model for confined concrete", J. Struct. Div., ASCE, 114(8), 1804-1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804)
  12. Memari, A.M., Harris, H.G., Hamid, A.A. and Scanlon, A. (2010), "Seismic evaluation of an elevated highway bridge in a low seismic region - a case study", Open Civil Eng. J., 4, 72-87.
  13. Mohd, Y.M.Y. (1994), "Nonlinear analysis of prestressed concrete structures under monotonic and cyclic loads", Ph.D. Dissertation, University of California, Berkeley.
  14. Poursha, M., Khoshnoudian, F. and Moghadam, A.S. (2009), "A consecutive modal pushover procedure for estimating the seismic demands of tall buildings", Eng. Struct., 31(2), 591-599. https://doi.org/10.1016/j.engstruct.2008.10.009
  15. Priestley, M.J.N., Seible, F. and Calvi, G.M. (1996), Seismic Design and Retrofit of Bridges, John Wiley & Sons, New York, NY, USA.
  16. Priestley, M.J.N., Calvi, G.M., and Kowalsky, M.J. (2007), Displacement-Based Seismic Design of Structures, IUSS Press, Pavia, Italy.
  17. Silvia, M., Frank, M., Michael, H. (2005), Open System for Earthquake Engineering Simulation User Manual, Pacific Earthquake Engineering Research Center, University of California, Berkeley, CA, USA.
  18. Taucer, F.F. and Enrico, S.F. (1991). A Fiber Beam-Column Element for Seismic Response Analysis of Reinforced Concrete Structures, UCB/EERC-91/17, Berkeley.
  19. Tsai, M.H. and Chang, K.C. (2002), "Higher-mode effect on the seismic responses of buildings with viscoelastic dampers", Earthq.Eng.Eng.Vib. 1(1), 119-129. https://doi.org/10.1007/s11803-002-0015-z
  20. Vmvatsikos, D. and Cornell, C.A. (2002), "Incremental dnamic aalysis", Earthq.Eng.Struct.Dyn. 31(3), 491-514. https://doi.org/10.1002/eqe.141

피인용 문헌

  1. Seismic performance and design of bridge piers with rocking isolation vol.73, pp.4, 2020, https://doi.org/10.12989/sem.2020.73.4.447