DOI QR코드

DOI QR Code

Modal parameter identification of in-filled RC frames with low strength concrete using ambient vibration

  • Arslan, Mehmet E. (Karadeniz Technical University, Department of Civil Engineering) ;
  • Durmus, Ahmet (Karadeniz Technical University, Department of Civil Engineering)
  • Received : 2012.09.05
  • Accepted : 2013.02.15
  • Published : 2014.04.25

Abstract

In this study, modal parameters such as natural frequencies, mode shapes and damping ratios of RC frames with low strength are determined for different construction stages using ambient vibration test. For this purpose full scaled, one bay and one story RC frames are produced and tested for plane, brick in-filled and brick in-filled with plaster conditions. Measurement time, frequency span and effective mode number are determined by considering similar studies and literature. To obtain experimental dynamic characteristics, Enhanced Frequency Domain Decomposition and Stochastic Subspace Identification techniques are used together. It is shown that the ambient vibration measurements are enough to identify the most significant modes of RC frames. The results indicate that modal parameters change significantly depending on the construction stages. In addition, Infill walls increase stiffness and change the mode shapes of the RC frame. There is a good agreement between mode shapes obtained from brick in-filled and in-filled with plaster conditions. However, some differences are seen in plane frame, like expected. Dynamic characteristics should be verified using finite element analysis. Finally, inconsistency between experimental and analytical dynamic characteristics should be minimize by finite element model updating using some uncertain parameters such as material properties, boundary condition and section properties to reflect the current behavior of the RC frames.

Keywords

References

  1. Bayraktar, A., Altunisik, A.C., Sevim, B., Turker, T., Akkose, M. and Coskun, N. (2006), "Modal analysis, experimental validation and calibration of a historical masonary minaret", J. Test. Eval., 36(6), 516-524.
  2. Bayraktar, A., Sevim, B., Altunisik, A.C. and Turker, T. (2009), "Analytical and operational modal analyses of Turkish style reinforced concrete minarets for structural identification", Dyn. Test. Civil Eng. Struct. Ser., 2, 65-75.
  3. Bayraktar, A.,Turker, T., Altunisik, A.C., Sevim, B., Sahin, A. and Ozcan, D.M. (2010a), "Determination of dynamic parameters of buildings by operational modal analysis", IMO Tech. J., 5185-5205.
  4. Bendat, J.S. and Piersol, A.G. (2004), Random Data: Analysis and Measurement Procedures, John Wiley and Sons, New York.
  5. Brencich, A., and Sabia, D. (2008), "Experimental identification of a multi-span masonry bridge: The Tanaro Bridge", Constr. Build. Mater., 22(10), 2087-2099. https://doi.org/10.1016/j.conbuildmat.2007.07.031
  6. Brincker, R., Zhang, L., and Andersen, P. (2000), "Modal identification from Ambient responses using frequency domain decomposition", Proceedings of the 18th International Modal Analysis Conference, San Antonio, USA, February.
  7. Dooms, D., Degrande, G., Roeck, G. and Reynders, E. (2006), "Finite element modeling of a silo based on experimental modal analysis", Eng. Struct., 28, 532-542. https://doi.org/10.1016/j.engstruct.2005.09.008
  8. Ellis, B.R. (1980), "An assessment of the accuracy of predicting fundamental natural frequencies of buildings and the implications concerning the dynamic analysis of structures", Inst. Civil Eng., 69(2), 763-776. https://doi.org/10.1680/iicep.1980.2376
  9. Ewins, D.J. (1984), Modal Testing: Theory and Practice, Research Studies Press Ltd., Hertfordshire, England.
  10. FEMA 356 (2000), Prestandard and Commentary for the Seismic Rehabilitation of Buildings, Federal Emergency Management Agency (FEMA), Washington, DC.
  11. Jacobsen, N.J., Andersen, P. and Brincker, R. (2006), "Using enhanced frequency domain decomposition as a robust technique to harmonic excitation in operational modal analysis", Proceedings of ISMA2006: International Conference on Noise and Vibration Engineering, Leuven, Belgium, September.
  12. Juang, J.N. (1994), Applied System Identification, Prentice-Hall, Inc., Englewood Cliffs, NJ.
  13. Klingner, R.E. and Bertero, V.V. (1978), "Earthquake resistance of infilled frames", ASCE J. Struct. Eng., 104, 973-989.
  14. Kodur, V.K.R., Erki, M.A. and Quenneville, J.H.P. (1994), Seismic behaviour and design of masonry-infilled frames, Royal Military College of Canada, Kingston, Civil Engineering Research Report.
  15. Kodur, V. R., Erki, M.A. and Quenneville, J.H.P. (1995), "Seismic design and analysis of masonry-infilled frames", Can. J. Civil Eng., 22(3), 576-587. https://doi.org/10.1139/l95-066
  16. Law, S.S., Li, X.Y. and Lu, Z.R. (2006), "Structural damage detection from wavelet coefficient sensitivity with model errors", J. Eng. Mech., ASCE, 132, 1077-1087. https://doi.org/10.1061/(ASCE)0733-9399(2006)132:10(1077)
  17. Maia, N.M.M. and Silva, J.M.M. (1997), Theaoretical and Experimental Modal Analysis, Research Studies Press Ltd., England.
  18. Mehrabi, A.B., Shing, P.B., Schuller, M.P. and Noland, J.L. (1996), "Hysteretic response of reinforced concrete infilled frames", ASCE J. Struct. Eng., 122(3), 228-237. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:3(228)
  19. OMA (2006), Operational Modal Analysis, Release 4.0., Structural Vibration Solution A/S, Denmark.
  20. Peeters, B. and De Roeck, G. (1999), "Reference based stochastic subspace identification in civil engineering", Proceedings of the Second International Conference on Identification in Engineering Systems, Swansea, United Kingdom, August.
  21. Peeters, B. (2000), "System identification and damage detection in civil engineering", Ph.D. Thesis, Katholieke Universiteit Leuven, Belgium.
  22. Ren, W.X., Zhao, T. and Harik, I.E. (2004), "Experimental and analytical modal analysis of steel arch bridge", J. Struct. Eng., ASCE, 130, 1022-1031. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:7(1022)
  23. Reynolds, P., Pavic, A. and Prichard, S. (2002), "Dynamic analysis and testing of a high performance floor structure", International Conference on Structural Dynamic Modeling-Test, Analysis, Correlation and Validation, Maderia Island, Portugal, June.
  24. Sahoo, D.R. and Rai, D.C. (2010), "Seismic strengthening of non-ductile reinforced concrete frames using aluminum shear links as energy-dissipation devices", Eng. Struct., 32, 3548-3557. https://doi.org/10.1016/j.engstruct.2010.07.023
  25. Sevim, B., Bayraktar, A., Altunisik, A.C., Adanur, S. and Akkose, M. (2010a), "Modal parameter identification of a prototype arch dam using enhanced frequency domain decomposition and stochastic subspace identification techniques", J. Test. Eval., 38(5), 1-10.
  26. Sevim, B., Bayraktar, A. and Altunisik, A.C. (2010b), "Investigation of water length effects on the modal behavior of a prototype arch dam using operational and analytical modal analyses", Struct. Eng. Mech., 37(6), 1-23. https://doi.org/10.12989/sem.2011.37.1.001
  27. Smith, B.S. (1962), "Lateral stiffness of in-filled frames", ASCE Struct. Div. J., 183- 199.
  28. Sun, X. and Philip, J. (1997), "A study on experimental modal analysis for seismic response assessment of underground facilities", Int. J. Rock Mech. Min. Sci., 34, 491-491. https://doi.org/10.1016/S1365-1609(97)00068-3
  29. Van, O.P. and De Moor, B. (1996), Subspace Identification for Linear Systems: Theory, Implementation and Applications, Kluwer Academic Publishers, Dordrecht, Netherlands.
  30. Yu, D.J. and Ren, W.X. (2005), "EMD-based stochastic subspace identification of structures from operational vibration measurements", Eng. Struct., 27, 1741-1751. https://doi.org/10.1016/j.engstruct.2005.04.016
  31. Zivanovic, S., Pavic, A. and Reynolds, P. (2006), "Modal testing and FE model tuning of a lively footbridge structure", Eng. Struct., 28, 857-868. https://doi.org/10.1016/j.engstruct.2005.10.012
  32. Zivanovic, S., Pavic, A. and Reynolds, P. (2007), "Finite-element modeling and updating of a lively footbridge: The complete process", J. Sound Vib., 301(1-2), 126-145. https://doi.org/10.1016/j.jsv.2006.09.024

Cited by

  1. Structural damage detection by principle component analysis of long-gauge dynamic strains vol.54, pp.2, 2015, https://doi.org/10.12989/sem.2015.54.2.379
  2. Parameters affecting the fundamental period of infilled RC frame structures vol.9, pp.5, 2015, https://doi.org/10.12989/eas.2015.9.5.999
  3. Effectiveness of seismic repairing stages with CFRPs on the seismic performance of damaged RC frames vol.67, pp.3, 2014, https://doi.org/10.12989/sem.2018.67.3.233
  4. Soil foundation effect on the vibration response of concrete foundations using mathematical model vol.22, pp.2, 2014, https://doi.org/10.12989/cac.2018.22.2.221
  5. Numerical Modeling of Masonry Infilled Reinforced Concrete Building during Construction Stages Using ABAQUS Software vol.9, pp.8, 2014, https://doi.org/10.3390/buildings9080181