Transactions of the Korean hydrogen and new energy society (한국수소및신에너지학회논문집)

The Korean Hydrogen and New Energy Society (한국수소및신에너지학회)
권호 표지
DOI QR코드

DOI QR Code

A Study on Combustion and Heat Transfer in Premixed Impinging Flames of Syngas(H2/CO)/Air Part II: Heat Transfer Characteristics

합성가스(H2/CO)/공기 예혼합 충돌화염의 연소 및 열전달 연구 Part II : 열전달 특성

  • Sim, Keunseon (Graduate School of Sunchon National Univ.) ;
  • Jeong, Byeonggyu (Graduate School of Sunchon National Univ.) ;
  • Lee, Yongho (School of Mechanical and Automotive Engineering of Chonnam Nat. Unv.) ;
  • Lee, Keeman (School of Mechanical and Aerospace Engineering, Sunchon Nat. Univ.)
  • 심근선 (순천대학교 대학원) ;
  • 정병규 (순천대학교 대학원) ;
  • 이용호 (전남대학교(여수캠퍼스) 기계자동차공학부) ;
  • 이기만 (순천대학교 기계.우주항공공학부)
  • Received : 2014.02.04
  • Accepted : 2014.02.28
  • Published : 2014.02.28
Download PDF
⟨ Previous Next ⟩

Abstract

An experimental study has been conducted to investigate the heat transfer characteristics of laminar syngas/air mixture with 10% hydrogen content impinging normally to a flat plate of cylinder. Effects of impinging distance, Reynolds number and equivalence ratio as major parameters on heat fluxes of stagnation point and radial direction were examined experimentally by the direct photos and data acquisitions from heat flux sensor. In this work, we could find the incurved flame behavior of line shaped inner top-flame in very closed distance between flat plate and burner exit, which has been not reported from general gas-fuels. There were 3 times of maximum and 2 times minimum heat flux of stagnation point with respect to the impinging distance for the investigation of Reynolds number and equivalence ratio effect. It was confirmed that the maximum heat flux of stagnation point in 1'st and 2'nd peaks increased with the increase of the Reynolds number due to the Nusselt number increment. There was a third maximum rise in the heat flux of stagnation point for larger separation distances and this phenomenon was different each for laminar and turbulent condition. The heat transfer characteristics between the stagnation and wall jet region in radial heat flux profiles was investigated by the averaged heat flux value. It has been observed that the values of averaged heat flux traced well with the characteristics of major parameters and the decreasing of averaged heat flux was coincided with the decreasing trend of adiabatic temperature in spite of the same flow condition, especially for impinging distance and equivalence ratio effects.

Keywords

References

  1. J.Y. Park, K.M. Lee, C.H. Hwang, "Stability Characteristics of Syngas($H_2$/CO)/Air Premixed Flames using an Impinging Jet Burner", The Korean Society of Combustion, Vol. 16, No. 1, 2011 pp. 15-21.
  2. K.J. Kang, T.J. Part, C.H. Whang, K.M. Lee, "A Study on Combustion Characteristics of Synthetic Gas Air Lifted Premixed Flames with High Strain Rate in an Impinging Jet Combustion Field", The Korean Society of Combustion, Vol. 16, No. 4, 2011 pp. 31-37.
  3. B.G. Jeong, K.M.Lee, S.R.Lee, "Laminar Flame Speed Measurements and Flame Structure Differences of Syngas($H_2$/CO)-Air Mixture in Lean and Rich Conditions", Asia-Pacific Conference on Combustion, Proceedings of ASPACC 2013, pp. 112.
  4. B.G. Jeong, K.M. Lee, "A Study on the Laminar Burning Velocity of Synthetic Gas of Coal Gasification($H_2$/CO)-Air Premixed Flames", Trans. of the Korean Society of Hydrogen Energy, Vol. 23, No. 5, 2012, pp. 493-502. https://doi.org/10.7316/KHNES.2012.23.5.493
  5. B.G. Jeong, K.M. Lee, "A Study on Combustion and Heat Transfer in Premixed Impinging Flames of Syngas($H_2$/CO)/Air Part I: Characteristics of Combustion", Trans. of the Korean Society of Hydrogen Energy, in submitted. https://doi.org/10.7316/KHNES.2014.25.1.047
  6. J.K. Kilham and M.R.I. Purvis, "Heat Transfer from Normally Impinging Flames", Combustion Sci. Technol., Vol. 18, 1978, pp. 81-90. https://doi.org/10.1080/00102207808946840
  7. K.Hargrave, M. Fairweather, J.K. Kilham, "Forced convection heat transfer from impinging flames, Part II, Impingement hrat transfer", International Journal of Heat Fluid Flow, Vol. 8, 1987, pp. 132-138. https://doi.org/10.1016/0142-727X(87)90013-0
  8. T.H. Van der Meer, "Stagnation Point Heat Transfer from Turbulent Low Reynolds Number Jets and Flame Jets", Experimental Thermal and Fluid Science, Vol. 4, 1991, pp. 115-126. https://doi.org/10.1016/0894-1777(91)90025-M
  9. R.Viskanta, "Heat transfer to impinging isothermal gas and flame jets", Experimental Thermal and Fluid Science, Vol. 6, 1993, pp. 111-134. https://doi.org/10.1016/0894-1777(93)90022-B
  10. E. Baukal, B. Gebhart, "A review of flame impingement heat transfer, Part I: Experimental conditions" Combustion Science and Technology, Vol.104, 1995, pp.339-357. https://doi.org/10.1080/00102209508907727
  11. L.L. Dong, C.S. Cheung, C.W. Leung, "Heat transfer of an impinging butane/air flame jet of low Reynolds number", Experimental Heat Transfer, Vol. 14, 2001, pp. 265-282. https://doi.org/10.1080/089161501317098317
  12. L.C. Kwok, C.S. Cheung, C.W. Leung, "Heat transfer characteristics of slot and round pre-mixed impinging butan/air flame jet", Exper-imental Heat Transfer, Vol. 16, 2003, pp. 111-137. https://doi.org/10.1080/08916150390126496
  13. S.G. Tuttle, B.W. Webb, M.Q. McQuay, "Convective Heat Transfer from a Partially Premixed Impinging Flame Jet. Part I : Time Averaged Results", Int. Journal of Heat and Mass Transfer, Vol. 48, 2005, pp 1236-1251. https://doi.org/10.1016/j.ijheatmasstransfer.2004.10.027
  14. Subhash Chander, Anjan Ray, "Flame Impingement Heat Transfer : A review", Energy Conversion and Management, Vol. 46, 2005, pp. 2803-2837. https://doi.org/10.1016/j.enconman.2005.01.011
  15. S. Chander, A. Ray, "Influence of Burner Geometry on Heat Transfer Characteristics of Methane/Air Flame Impinging on Flat Surface", Experimental Heat Transfer, Vol. 19, 2006, pp 15-38. https://doi.org/10.1080/08916150500317655
  16. Subhash Chander, Anjan Ray, "An Experimental and Numerical Study of Stagnation Point Heat Transfer for Methane/Air Laminar Flame Impinging on a Flat Surface", Int. Journal of Heat and Mass Transfer, Vol. 51, 2008, pp 3595-3607. https://doi.org/10.1016/j.ijheatmasstransfer.2007.10.018
  17. Subhash Chander, Anjan Ray, "Experimental and Numerical Study on the Occurrence of Off-Stagnation Peak in Heat Flux for Laminar Methane/Air Flame Impinging on a Flat Surface", Int. Journal of Heat and Mass Transfer, Vol. 54, 2011, pp 1179-1186. https://doi.org/10.1016/j.ijheatmasstransfer.2010.10.035

Cited by

  1. A Study on the Lifted Flame Structure with Strain Rates in Premixed Impinging Jet Flames of Syngas (H2/CO) vol.26, pp.4, 2015, https://doi.org/10.7316/KHNES.2015.26.4.347